Nitsuko Digital System Feature And Terminal Programming Manual

CP- ALLOW BREAK-IN (INTRUSION) (BY0:4)
Description
Use this option to enable (1) or disable (0) Intrusion for extensions with this COS.
Conditions 
None
Default Value
•Intrusion allowed (1) at COS 0.
•Intrusion not allowed (0) at all other COSs.
Feature Reference
Intrusion (Barge-In)
Instructions
To enter data on the PRF:
1. On Table 2 for BY0:4, enter 0 to disable Intrusion for each COS. Enter 1 to enable Intrusion.
To enter data at the programming terminal:
1. Type CP.  You see: COS # 00: 00010000...

CP- ALLOW OFF-PREMISE CALL FORWARDING (BY0:3)
Description
Use this option to allow (1) or deny (0) Off-Premise Call Forwarding for extensions with this COS.
Conditions 
Off-Premise Call Forwarding requires either ground start trunks or loop start trunks with disconnect supervision.
Default Value
Off-Premise Call Forwarding not allowed (0).
Feature Reference
Call Forwarding
Instructions
To enter data on the PRF:
1. On Table 2 for BY0:3, enter 0 to disable Off-Premise Call Forwarding.  Enter 1 to enable...

CP- ALLOW ONLY INTERCOM CALLS AT NIGHT (BY0:2)
Description
Use this option to restrict extensions with this COS to only Intercom calls at night.  If enabled in an extension’s
COS, the user can only place Intercom calls when the system is in the night mode.  The user cannot place any
outside calls (including 911 calls).  When enabled (1), this option overrides AP- Toll Restriction programming.
Conditions 
None
Default Value
Extensions not restricted to Intercom calls at night (0).
Feature Reference
Toll...

CP- INHIBIT OPA TRANSFERS TO EXTENSION (BY0:1)
Description
Use this option to allow/deny Operator Assistance (OPA) transfers for extensions with this COS.  If denied (1),
the OPA will not transfer calls to extensions with this Class of Service.  If allowed (0), the transfer can go
through if the extension is free. 
OPA requires a 12SCU/VMU Module.
Conditions 
None
Default Value
OPA transfers not inhibited (0).
Feature Reference
Operator Assistance (OPA)
Voice Module Unit (VMU)
Instructions
To enter data...

CP- ALLOW CALLBACK PRIORITY (BY1:7)
Description
Use this option to allow (1) or deny (0) extensions with this COS trunk Callback priority.  An extension with pri-
ority receives Callback from a trunk before other extensions that also have Callbacks waiting.  Without priority,
the system processes the trunk Callbacks on a first in, first out basis.  This option has no effect on Callbacks left
at an extension.
Conditions 
More than one extension with Priority can leave a Callback for the same trunk.  If...

CP- ALLOW PRIVACY (BY1:6)
Description
Use this option to enable (1) or disable (0) Privacy for extensions with this COS.  If an extension has Privacy, an-
other extension cannot Intrude on its calls.  Privacy also blocks Call Waiting (Camp-On) tones and Silent Moni-
tor.
Conditions 
None
Default Value
Privacy not allowed (0).
Feature Reference
Intrusion (Barge-In)
Privacy
Instructions
To enter data on the PRF:
1. On Table 2 for BY1:6, enter 0 to disable Privacy for each COS. Enter 1 to enable Privacy.
To...

CP- ALLOW EXTENDED RINGING (BY1:5)
Description
Use this option to enable (1) or disable (0) Extended Ringing for extensions with this COS.
Conditions 
None
Default Value
Extended Ringing disabled (0).
Feature Reference
Extended Ringing
Instructions
To enter data on the PRF:
1. On Table 2 for BY0:5, enter 0 to enable Camp-On for each COS. Enter 1 to disable Camp-On.
To enter data at the programming terminal:
1. Type CP.  You see: COS # 00: 00010000 00000-0 00000001 00000000
2. Enter data for each COS you...

CP- ALLOW ONLY LOCAL CALLS AT NIGHT (BY1:4)
Description
Use this option to restrict extensions with this COS to Intercom and local calls in the night mode.  This option
also applies to DISA trunks.  This assignment overrides AP programming (except AP- Allow Active Dial Pad).
If you enable this option (1), extension users can only place the following types of trunk calls:
•7-digit (NNX+nnnn) calls, where N=any digit 2-9
•1+911 and 911 calls
•1+800+NNX+nnnn calls
If disabled (0), this option does not...

CP- ALLOW ONLY LOCAL CALLS (DAY OR NIGHT) (BY1:3)
Description
Use this option to restrict extensions with this COS to Intercom and local calls.  This option also applies to
DISA trunks.  This assignment overrides AP programming (except AP- Allow Active Dial Pad).
If you enable this option (1), extension users can only place the following types of trunk calls:
•7-digit (NNX+nnnn) calls, where N=any digit 2-9
•1+911 and 911 calls
•1+800+NNX+nnnn calls
If disabled (0), this option does not restrict calls....

CP- EXTENSION TOLL RESTRICTION LEVEL (BY1:0-2)
Description
Use this option to assign a Toll Restriction level (1-7) to extensions with this COS.  This option also applies to
DISA trunks.  You normally assign toll level 0 to COS 0 (for attendants).
Conditions 
This option does not apply to CO lines.
Default Value
No restriction (toll level 0).
Feature Reference
Equal Access Compatibility
Special Services and OCC Compatibility
Toll Restriction
Instructions
To enter data on the PRF:
1. On Table 2 for...