NEC Neax 2400 Ipx Fusion Network System Manual

CHAPTER 5 NDA-24299
Page 76
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
Table 5-1 Route Class Data Assignment
CDN Node A Node B
Description type B-channel D-channel B-channel D-channel
RT C_RT: 10 C_RT: 11 C_RT: 12 C_RT: 13
1TF3333Trunk Kind 3: Bothway (fixed)
2TCL4444Trunk Class: 4 (fixed)
3RLP2222Release Method: Assign 2-First Party 
Release.
4SMDR0000Assign 0.
5 LSG 12 13 12 13 B-ch: 12, D-ch: 13
6PAD
7 TRKS 0 (1) 0 0 (1) 0 0: FIFO (1: LIFO)
8TC/EC
9FINT0000Fusion Interface Kind:...

NDA-24299 CHAPTER 5
Page 77
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
CDN 1: Trunk Kind
0-2: -
3: Bothway Trunk
CDN 2: TCL (Trunk Class)
0-3: -
4: Fusion Trunk
5-31: -
CDN 3: RLP (Release Pattern)
0: Calling Party Release
1: -
2: First Party Release
3: -
CDN 4: SMDR (SMDR for station-to-station call)
Assign 0.
CDN 5: LSG (Line Signal)
12: B channel for No.7 CCIS/ISDN
13: D channel for No.7 CCIS/ISDN
CDN 6: PAD   
Note
0: Depending Key Setting of Circuit Card
1: Send 8 dB, Receive 0...

CHAPTER 5 NDA-24299
Page 78
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
CDN 10: FPEG (Fusion Trunk Peg Count)
Assign 0.
CDN 11: TC (Timer Class)
0: -
1: 1 sec.
2: 2 sec.
3: 8 sec.
4: 20 sec.
5-7: -
CDN 12: MTC (Miscellaneous Timer Counter)
CDN 13: STSEQ (Status Enquiry)
0: -
1: cancel
CDN 14: FGH (Fusion Gateway Handler)
Assign 0.
CDN 15: MMN (Kind of Multiple Equipment)
0: TDM
1: MM-Node
2-3: -
CDN 16: Fusion Link
0: via DTI
1: via ISW
2: Fusion over IP (Router)
3-15: Not used
CDN 17:...

NDA-24299 CHAPTER 5
Page 79
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
STEP 2: ACTK
Assign the connection trunk data of both B-channel and D-channel using the ACTK command.
Assign the Connection Equipment Number (C_LENS) referring to Figure 5-23 through Figure 5-26.
The ACTK command display should look similar to Figure 5-23.
Figure 5-23   ACTK Command Display (example)
The mounting location of the FCH, DTI cards can be classified into the following two types:
Regular Density Slot...

CHAPTER 5 NDA-24299
Page 80
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
Table 5-2 Data Programming Sheet for Regular Density Slot
C_RT
(1-1023)C_TK(1-4095)C_LENS
Time Slot Allocation
MG U G LV
10 (B-ch)1
000010
2000011
3000012
4000013
5000014
6000015
7000016
8000017
9000020
10000021
11000022
12000023
13000024
14000025
15000026
16000027
17000030
18000031
19000032
20000033
21000034
22000035
23000036
11 (D-ch)1000037
2000270
0405
01
2703
00
02Dch (TK1)
Bch (TK23)
Bch (TK1)
Dch (TK2) Bch...

NDA-24299 CHAPTER 5
Page 81
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
6.1.2 When FCH is Mounted in a High Density Slot
If the FCH is to be mounted in the High Density Slot, the connection trunk data should be assigned as
shown in Figure 5-25. Figure 5-25 shows when these cards are mounted in Slots 11 and 12.
Figure 5-25   Mounting FCH and DTI Cards in High-Density Slots
00 02 04 05 06 07 08 09 10 13 14 15 16 17 18 19 20 21 22 23
12 13 1415
0001
02 0001
02 0404 0606 08 0810 1003 03...

CHAPTER 5 NDA-24299
Page 82
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
When the DTI cards are mounted in a double density slot, the C_LEN data for the FCH and DTI cards
are assigned as follows in Figure 5-26.
Figure 5-26   How to Assign C_LEN Data (Type 2)
0002 04 05 06
0708 09
1011 12
1314 1516
1718
1920
2122
23
04 02  00 06 1005 07 11
12 131415
161718
0001
02 04 06 08 10 03 05 07 09 11
1213 14 15
1617 18 19
20 21 22 23
08 09
PIM
Universal SlotsUniversal Slots
PWR DPWR TSW/MUX...

NDA-24299 CHAPTER 5
Page 83
Revision 1.0
DATA PROGRAMMING
Assignment of Telephone Numbers
Table 5-3 Data Programming Sheet for High Density Slot
C_RT
(1-1023)C_TK
(1-4095)C_LENS
Time Slot Allocation
MG U G LV
10 (B-ch)1 000210
2 000211
3 000212
4 000213
5 000214
6 000215
7 000216
8 000217
9 000220
10 000221
11 000222
12 000223
13 000224
14 000225
15 000226
16 000227
17 000230
18 000231
19 000232
20 000233
21 000234
22 000235
23 000236
11 (D-ch)1 000237
2 000190
1112
19 23
22
21Dch (TK1)
Bch (TK23)
Bch...

CHAPTER 5 NDA-24299
Page 84
Revision 1.0
DATA PROGRAMMING
Assignment of FCH Related Data
STEP 3: MBCT
Unbusy the connection trunk data assigned in the previous step using MBCT (Make Busy of
Connection Trunk) command. This step is required for both B-channel and D-channel trunk. The
MBCT command should look similar to Figure 5-27.
Figure 5-27   MBCT Command Display
7. Assignment of FCH Related Data
STEP 1: For Fusion with FCH only:
Assign FCH Number on an FCH (PA-FCHA) circuit card basis. 
The FCH...

NDA-24299 CHAPTER 5
Page 85
Revision 1.0
DATA PROGRAMMING
Assignment of FCH Related Data
Figure 5-28 shows a sample data assignment when FCH cards are located in the PIM 0 slot 4 and PIM 2 slot 11.
Figure 5-28   Assignment of FCH Number
The AFCH command display should look similar to Figure 5-29.
Figure 5-29   AFCH Command Display (example)
N
ECNE
AX
 
2
40
0
 
IM
S
FCHN=2
LENS: 000270FCHN=1
Data Assignment
PIM 0 Slot 04 LENS 011190
PIM 2 Slot 11
FCHN: 2 FCHEN: 01 0   19  0FCHN: 1 FCHEN: 00 0   27  0...