NEC Neax 2400 Imx Callcenterworx Enterprise Acd System Manual

CHAPTER 4 NDA-24282
Pag e 8 2
Revision 1.0
PA-ME34 (CRAM)
SWITCH SETTING SHEET
MODULE SLOT NO.SWITCH 
NAMESWITCH SHAPE REMARKS
APM-A\E 06
08
19DMWDK
SW0
SW1ON
ON
12345678
ON
12 

NDA-24282 CHAPTER 4
Page 83
Revision 1.0
PA-IO02-A (IOC)
PA-IO02-A (IOC)
1. Function
This circuit card is an I/O card (input/output control card) and provides a serial interface function by which
the CPU performs mutual communications with the ACD-MIS conforming with the RS-232C Interface.
2. Mounting Location/Condition
The mounting locations of this circuit card and the conditions related to mounting are shown below.
CPUCPU
COPYCOPY
CRAMCRAM
IOC
APM-A\E
ALMC
RS-232C (Non-protocol)
Position within the...

CHAPTER 4 NDA-24282
Pag e 8 4
Revision 1.0
PA-IO02-A (IOC)
3. Face Layout of Lamps, Switches, and Connectors
The face layout of lamps, switches, and connectors of this circuit card is shown below.
4. Lamp Indications
The contents of lamp indications of this circuit card are shown in the table below.
LAMP NAME COLOR STATE
OPE  Green Remains lit while this circuit card is operating in ACT mode.
ON LINE1 Green Remains lit while PORT 1 is in on-line state.
ON LINE0 Green Remains lit while PORT 0 is in...

NDA-24282 CHAPTER 4
Page 85
Revision 1.0
PA-IO02-A (IOC)
5. Switch Settings
Standard settings of various switches on this circuit card are shown in the table below.
SWITCH 
NAMESWITCH NO. SETTINGSTANDARD 
SETTINGMEANING
MB UP Circuit card make busy.
DOWN Circuit card make idle.
MB REQ UP Circuit card make busy.
DOWN Circuit card make idle.
OFF LINE UP Setting is inhibited.
MIDDLE×Fixed.
DOWN Setting is inhibited.
SW0
1
2
3OFF×
4OFF×
5OFF×
6OFF×
7OFF×
8OFF×
SW3 1 OFF×
2OFF×
3OFF×
4OFF×
SW0-1 SW0-2 SETTING...

CHAPTER 4 NDA-24282
Pag e 8 6
Revision 1.0
PA-IO02-A (IOC)
SW1
 (for Port 0)
SW11
(for Port 1)1
2
3
4
5
6ON×Data Length: 7 bits
OFF Data Length: 8 bits
7ON×Stop Bit: 1 bits 
OFF Stop Bit: 2 bits 
8ONData store into the send-side buffer of the port 
is disabled.
OFF×Data of max. 64 kbytes are to be stored into the 
send-side buffer of the port.
SWITCH 
NAMESWITCH NO. SETTINGSTANDARD 
SETTINGMEANING
SW01-1
SW11-1SW01-2
SW11-2SW01-3
SW11-3DATA TRANSMISSION SPEED 
(BPS) SETTING
ON ON ON 300 bps
ON ON OFF 600...

NDA-24282 CHAPTER 4
Page 87
Revision 1.0
PA-IO02-A (IOC)
Note:
When setting SW02-7/SW12-7 to ON, set SW02-1/SW12-1 to ON, also. SW02
 (for Port 0)
SW12
 (for Port 1)1ON×PB terminal becomes minus (-) when the port 
terminal is busy.
OFFPB terminal becomes plus (+) when the port 
terminal is busy.
2ON×Sets the ER terminal of the port to Always ON.
OFFControls ON/OFF of the ER terminal of the 
port by the CPU.
3ON DR signal lead is not to be used to the port.
OFF×DR signal lead is to be used to the port....

CHAPTER 4 NDA-24282
Pag e 8 8
Revision 1.0
PA-IO02-A (IOC)
6. External Interface
The RS connector leads accommodation of this circuit card is shown below.
Figure 4-1   RS Connector Leads Accommodation
26 
27 
28 
29 
30 
31 
32 
33 
34 
35 
36 
37 
38 
39 
40 
41 
42 
43 
44 
45 
46 
47 
48 
49 
50
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
RS0
APM-A\E Slot No.
E 
E 
E 
E 
E 
CI0 
E 
E 
E 
E 
E 
E 
E 
E 
E 
E 
E 
CI1 
E 
E 
E 
E 
E 
E 
EXTA1 
2 
3 
4 
5 
6 
7 
8 
9 
10 
11...

NDA-24282 CHAPTER 4
Page 89
Revision 1.0
PA-IO02-A (IOC)
SWITCH SETTING SHEET
MODULE SLOT NO.SWITCH 
NAMESWITCH SHAPE REMARKS
APM-A\E 04 MB UP: Circuit card make busy.
MB REQ DOWN:Circuit card make idle.
OFF LINE
SW0
SW3
SW01
SW02
SW11
SW12ON
ON
ON
ON
12345678
ON
1234
ON
12345678
ON
12345678
ON
12345678
ON
12345678 

CHAPTER 4 NDA-24282
Pag e 9 0
Revision 1.0
PH-BS16 (PBI)
PH-BS16 (PBI)
1. Function
This circuit card provides an interface by which the ACDP performs inter-processor communications  with
another Processor via the Processor Bus (P-BUS) under control of the ACDP (PA-CP54 card). Also, this
circuit card is connected with the Maintenance Bus (M-BUS) and provides functions that allow the SP
(System Processor) to read out status or fault information of the ACDP and that cause the ACDP to set make-
busy or...

NDA-24282 CHAPTER 4
Page 91
Revision 1.0
PH-BS16 (PBI)
3. Face Layout of Lamps, Switches, and Connectors
The face layout of lamps, switches, and connectors of this circuit card is shown below.
OPE
MB
PWRALM
ACT
EQBY
PBIH
PBIL
B-OPE0
B-OPE1
TR BSY 
RV BSY 
M-OPE