NEC Neax 2400 Imx Callcenterworx Enterprise Acd System Manual

CHAPTER 4 NDA-24282
Pag e 1 22
Revision 1.0
PA-16ELCH (16ELC)
Figure 4-9   Connecting Route Diagram
NEAX2400 IMS
A0MDF
Rosette
A0
B0
B0ELC
Dterm 

NDA-24282 CHAPTER 4
Page 123
Revision 1.0
PA-16ELCH (16ELC)
Switch Setting Sheet
MODULE SLOT NO.SWITCH 
NAMESWITCH SHAPE REMARKS
PIMU-A SW0
MB DOWN Circuit card make idle.ON
12 3 45678 

CHAPTER 4 NDA-24282 (E)
Pag e 1 24
Revision 1.0
PA-16ELCJ (16ELC)
PA-16ELCJ (16ELC)
1. Function
This circuit card is a line circuit card which supports the interface of 16 circuits or eight circuits of a 2W-
Digital Terminal based on TCM transmission system (Time Compression Multiplex).
This circuit card can be used as an eight-circuit voice/data digital line (8DLC Mode) and a 16-circuit voice
only digital line circuit (16ELC Mode), and can be connected to any D
term of the Dterm Series III.
Differences...

NDA-24282 (E) CHAPTER 4
Page 125
Revision 1.0
PA-16ELCJ (16ELC)
2. Mounting Location/Condition
The mounting locations of this circuit card and the conditions related to mounting are shown below.
(a) When this circuit card is mounted in PIMJ
(b) When this circuit card is mounted in PIMK
Mounting Module PIMU-A
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
Note:Indicates universal slots for line/trunk circuit cards.
Mounting Module PIMK
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14...

CHAPTER 4 NDA-24282 (E)
Pag e 1 26
Revision 1.0
PA-16ELCJ (16ELC)
3. Face Layout of Lamps, Switches, and Connectors
The face layout of lamps and switches on this circuit card is shown below.
4. Lamp Indications
The contents of lamp indications of this circuit card are shown in the table below.
Note:When the PALM lamp lights red, observe the following instructions. 
i)  Identify the location where any in-house wires have a short circuit as to all lines which belong to the
PA-16ELCJ card whose PALM is on....

NDA-24282 (E) CHAPTER 4
Page 127
Revision 1.0
PA-16ELCJ (16ELC)
5. Switch Settings
Standard settings of various switches on this circuit card are shown in the table below.
Note 1:APR-J/APA-J is an optional device to be connected to Dterm and provides interface for analog terminal.
Note 2:By setting SW01-1 and SW01-7 as explained in the table below, either APR-J/APA-J or Data Adapter can be used. SWITCH
NAMESWITCH
NO.SETTINGSTANDARD
SETTINGMEANING
SW011
Note 1
Note 2
ON When APR-J/APA-J is not connected....

CHAPTER 4 NDA-24282 (E)
Pag e 1 28
Revision 1.0
PA-16ELCJ (16ELC)
6. External Interface
Accommodation of the LT connector leads of this circuit card and connecting route diagram are shown
below.
(a) LT Connector Lead Accommodation when this circuit card is mounted in PIMJ
 When the mode is 16ELC Mode/Single Port Mode.
Figure 4-10   LT Connector Leads Accommodation of PIMU-A (1 of 3)
LT Connector Accommodation
26 
27 
28 
29 
30 
31 
32 
33 
34 
35 
36 
37 
38 
39 
40 
41 
42 
43 
44 
45 
46 
47 
48 
49...

NDA-24282 (E) CHAPTER 4
Page 129
Revision 1.0
PA-16ELCJ (16ELC)
Figure 4-10  LT Connector Lead Accommodation of PIMU-A (2 of 3)
LT Connector Accommodation
26 
27 
28 
29 
30 
31 
32 
33 
34 
35 
36 
37 
38 
39 
40 
41 
42 
43 
44 
45 
46 
47 
48 
49 
50
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
LT0
PIMJ LT Connector Name
Slot No.
LT1, 3, 5, 7, 9, 11 Connector
B8 
B9 
B10 
B11 
B12 
B13 
B14
B15
 
 1 
2 
3 
4 
5 
6 
7 
8 
9 
10 
11 
12 
13 
14 
15 
16 
17 
18 
19 
20 
21 
22...

CHAPTER 4 NDA-24282 (E)
Pag e 1 30
Revision 1.0
PA-16ELCJ (16ELC)
 When the mode is 8DLC Mode/Dual Port Mode.
Figure 4-10  LT Connector Leads Accommodation of PIMU-A (3 of 3)
LT Connector Accommodation
26 
27 
28 
29 
30 
31 
32 
33 
34 
35 
36 
37 
38 
39 
40 
41 
42 
43 
44 
45 
46 
47 
48 
49 
50
00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
LT0
PWR
PIMJ LT Connector Name
Slot No.
LT1, 3, 5, 7, 9, 11 Connector
Accommodated in *2
1 
2 
3 
4 
5 
6 
7 
8 
9 
10 
11 
12 
13 
14...

NDA-24282 (E) CHAPTER 4
Page 131
Revision 1.0
PA-16ELCJ (16ELC)
(b) LT Connector Lead Accommodation when this circuit card is mounted in PIMK
 When the mode is 16ELC Mode and the APR-J/APA-J is used.
Figure 4-11   LT Connector Leads Accommodation of PIMK (1 of 3)
LT Connector Accommodation
26 
27 
28 
29 
30 
31 
32 
33 
34 
35 
36 
37 
38 
39 
40 
41 
42 
43 
44 
45 
46 
47 
48 
49 
50
LT1, 3, 5, 8, 10 Connector
1 
2 
3 
4 
5 
6 
7 
8 
9 
10 
11 
12 
13 
14 
15 
16 
17 
18 
19 
20 
21 
22 
23 
24 
2526...