Mitel Sx 200 Ml Pabx Lightware 16 Instructions Guide

CDE Form Descriptions 
1:25 PM 12-JfiN-97 alarm status = NO f?LfiRM 
> 
[GRP 1: IfTERMlfRECORD. 1 
Name 
Message Length OPTIONS 
0:00 
Name 
l- 
+QLlIT 2- 3- h- S- 
7- 8- 9- 0- 
Figure 4-26 Recording Hunt Group Options Subform Layout 
5:ill Prl 19-ml+97 alarn status = HO flLfMl 
S#-2@D nL LIGHTWIRE 16 1.a 17-nRR-1997 nain mm 
I 
I-SfsTEn 
i-QUIT 2- 
7-LOGS 3-DIRGtlOSTICS 4- 
S-RCD-REPORTS g-REPORTS 5-TRRFFICJIERS 
e- 
Figure 4-27 Auto Attendant Hunt Group Options Subform Layout 
March 1997 Issue 1...

Customer Data Entry 
11:00 flM 10-.JflN-97 
[GRP l:Zq l[TERMl[STN/SET 1 
> Name 
Ouerf low alarm status 
= NO fiLfiRM 
OPTIONS 
mktg < 
Name 
l- 
6-QUIT Z- 3- 
7- 8- mktg 
4- 5- 
g-DELETE FIELD 0- 
Figure 4-28 Station / Set Hunt Group Options Subform Layout 
11:04 fiM 10-JfiN-97 alarm status = NO flLflRM 
Figure 4-29 RABTOS Hunt Group Options Subform Layout 
4-82 Issue 1 Revision 0 March 1997  

CDE Form Descriptions 
Form 18 - Miscellaneous System Ports 
4.22 This form assigns a physical location to three types of devices and three alarms. The 
devices are a Music on Hold source, paging equipment and night bells equipment. 
The alarms are minor, major and critical. The system 
supports 25 night bells, nine 
paging zones and one Music on Hold source. Refer to Figure 4-30 for the form layout. 
5:50 PM 9-JflN-97 alarm status = NO fiLfiRM 
> 
ENTRY DESCRIPTION BfW SLT CCT SCT DIR PflGER 
EXT #I 
01...

Customer Data Entry 
EXT 
This field applies only to the night bell entries. The EXTENSION NUMBER field 
lists the extension numbers (a maximum of five digits) assigned to the night bells. This 
field links the night bell designations to Form 19 (Call Rerouting Table). This field also 
links the incoming trunks of Form 14 (Non-Dial-In Trunks) to the night bell designations. 
Softkeys 
ENTRY NUM: 
This softkey selects an entry number. Pressing the ENTRY NUM softkey 
displays the ENTER ENTRY NUM: prompt on...

CDE Form Descriptions 
Form 19 - Call Rerouting Table 
4.23 This form designates where intercepted and attendant-directed calls will route based 
on Day Service, Night1 Service and Night2 Service. Dial-in trunks to ACD Paths may 
also be rerouted as defined in this form. The ACD Path is assigned a tenant number 
in Form 41. 
Refer to Figure 4-31 for the form layout and to Table 4-9 for Call Rerouting Options. 
Each Tenant Group requires a Call Rerouting Table. “DIAL 0” calls can be directed to 
an LDN,...

Customer Data Entry 
Not Disturb intercept. 
An ONS Voicemail port with a caller on soft hold will receive dial 
tone. 
Nl: This field specifies the extension that calls are routed to during Night1 Service 
Mode. If this field is blank, the call reroutes to the extension specified in the DAY field. 
N2: This field specifies the extension number where calls are routed to during Night2 
Service Mode. If this field is blank, the call does not reroute. 
4-86 Table 4-9 Call Rerouting Options 
Station Dial 0...

CDE Form Descriptions 
Table 4-9 Call Rerouting Options (continued) 
DND Intercept Routing for this Tenant - An extension with Do Not Disturb activated has 
its incoming calls routed here. This rerouting option is based in the extension’s tenant. 
Automatic Wake-up Routing for this Tenant - Extensions answering a wakeup call are 
routed here. Normally the routing point is a recording group. This rerouting option is based 
on the extension’s tenant. Ensure there are sufficient RADs to provide good wakeup...

Customer Data Entry 
Form 20 - ARS: Class of Restriction Groups 
4.24 Class of Restriction groups together users with the same outside call capabilities. A 
COR is assigned to each attendant console, station, SUfEKXTtelephone and Di- 
al-In Trunk. This form specifies the Class-of-Restriction (COR) Group members. 
Refer to Figure 4-32 for the form layout. The system supports a maximum of 50 COR 
Groups with up to 25 CORs per group. Each COR Group specifies by COR number 
those extensions which are...

CDE Form Descriptions 
Form 21 - ARS: Day Zone Definition 
4.25 This form defines the day zones for each day of the week. There is a maximum of 
three day zones. All days of the week must have a zone specification before this form 
can be saved. Refer to Figure 4-33 for the form layout. 
5:55 PM 9-JfiN-97 alarm status = NO flLFiRM 
ION. TUE. WED. THU. FRI. !if~T SUN. 
DI%’ ZONE 
r 
> 
01 * * * * * * * 
< 
02 
03 
01 * * * * * * * 
1-DISfiBLE 2- 3- 4- 5- 
6-QUIT 7- 8- 9- 0- 
Figure 4-33 Form 21 Layout...

Customer Data Entty 
Form 22 - ARS: Modified Digit Table 
4.26 This form specifies those digits that modify the user-dialed digits. The digit modifica- 
tion prepares the dialed digits for dialing out on certain trunks such as FX, TIE and 
WATS. Refer to the Automatic Route Selection and Toll Control Practice for details. 
Refer to Figure 4-34 for the form layout. 
11:14 BM 10-JON-97  11:14 BM 10-JON-97 alarm status q NO BLORM alarm status q NO BLORM 
ENTR’f QT’f TO DEL  UTR’f QT’f TO DEL DIGITS TO BE...