Mitel SX 200 DIGITAL Pabx Superset 3 Telephone Description Manual

Attendant Console Description
automatic wake-up report is given below:
12345 01/23 11:2OP WU 7:00 SET BY ROOM
MESSAGE REGISTRATION: Message registration single-line re-
ports have only one type of printout suffix. This suffix is gen-
erated whenever a room’s message register is cleared from the
Attendant Console. The register count field is five digits in
length, and all leading zeros are displayed. The format of the
suffix is:
REG. CLEARED AT nnnnn.
nnnnn represents the register contents prior to being...

SECTION MITL9109-094-315-NATABLE 4-2
AUTOMATIC WAKE-UP SINGLE-LINE REPORT SUFFIXES
OPERATION TYPESUFFIX
DEFINITIONS 
& NOTES
Console OperationsWU hh:mmP SET BY CONS
WU = Wake-Up hh:mmP =
time and PM indicator SET BY
CONS = Set by Attendant
Console
WU hh:mmP CHG BY CONS
CHG BY CONS = Changed by
Attendant Console
WU hh:mmP CAN BY CONSCAN BY CONS = Canceled by
Attendant Console
Room OperationsWU hh:mmP aaa BY ROOMaaa = either :
SET, CHG, or CAN
Wake-Up AttemptsWU hh:mmP aaaaaaaaaaaaaa= either:
ANSWERED,NO...

Attendant Console Description
APPENDIX A
Superconsole1000 Attendant Console RS-232C Interface SpecificationsPin
1
23
4
5
6
7
820General
Al.01 This appendix provides the information necessary to identify all
the pins on the RS-232C connector of the Superconsole 
1000attendant console. The printer port on the Superconsole 1000 atten-
dant console acts like a 
DATASET 1101 cartridge with the following
exceptions:
lno autobaud
lbaud rate limited to 2400
ldevice ID different from that of data cartridge
lno...

MITEL STANDARD PRACTICESECTION MlTL9141-753-503-NAIssue 3, April 1988
SX-200” DIGITAL
PRIVATE AUTOMATIC BRANCH EXCHANGE
DATASET 1100 SERIES
@Copyright 1988, MITEL Corporation. All rights reserved.
T”Trademark of MITEL Corporation
@Registered Trademark of MITEL Corporation 

SECTION MlTL9141-753-503-NANOTICE
The information contained in this document is believed to be accurate in all respects but is
not warranted by 
Mite1 Corporation (MITEL). The information is subject to change without
notice and should not be construed in any way as a commitment by 
Mite1 or any of its
affiliates or subsidiaries. 
Mite1 and its affiliates and subsidiaries assume no responsibility
for any errors or omissions in this document. Revisions of this document or new editions of
it may be issued...

DATASET 1100 Series
CONTENTS
PAGE
1. INTRODUCTION
Reason for Issue
......................................
12. GENERAL DESCRIPTION
Baud Rates
...........................................
3Connector Pin Assignment Tables
.........................
43. 
DATASET 1101 CARTRIDGE
Description
..........................................
5Controls, Indicators, and Connectors
.......................
5Installation
...........................................
64. 
DATASET 1102 DUAL RACK MOUNTED CARD
Description...

SECTION MITL9141-753-503-NA
iv 

DATASET 1100 Series
1. INTRODUCTION
1.01This Section describes three DATASET 1100 series asynchro-
nous data sets; a 
DATASET 1101 Cartridge, a DATASET 1102
Dual Rack Mounted card, and a Standalone 
DATASET 1103.
Reason for Issue
1.02 This Section is issued to describe the 
DATASET 1100 series
data sets used with the 
SX-ZOO8 DIGITAL PABX.
Page 1 

SECTION MITL9141-753-503-NAPage 2 

DATASET 1100 Series
2. GENERAL DESCRIPTION
2.01The DATASET 1100 series asynchronous data sets are com-
posed of three variants; a 
DATASET 1101 Cartridge, a DATASET1102 Dual Rack Mounted card, and a Standalone 
DATASET 1103 unit.
The 
DATASET 1100 series support asynchronous data communications
at rates up to 19.2 
kilobits per second, and interface with an SX-200
DIGITAL PABX through a Digital Line Card within the PABX.
2.02These 
DATASETs operate with the Mite1 Digital Network Inter-
face Circuit...