Mitel SX 200 DIGITAL Pabx Superset 3 Telephone Description Manual

SECTION MITL9141-753-525-NAWARNING
THIS EQUIPMENT GENERATES, USES, AND CAN RADIATE RADIO FREQUENCY ENERGY AND IF
NOT INSTALLED AND USED IN ACCORDANCE WITH THE INSTRUCTION MANUAL, MAY CAUSE
INTERFERENCE TO RADIO COMMUNICATIONS. IT HAS BEEN TESTED AND FOUND TO COMPLY
WITH THE LIMITS FOR CLASS A COMPUTING DEVICE PURSUANT TO SUBPART J OF PART 15 OF
FCC RULES, WHICH ARE DESIGNED TO PROVIDE REASONABLE PROTECTION AGAINST SUCH
INTERFERENCE WHEN OPERATED IN A COMMERCIAL ENVIRONMENT. OPERATION OF THIS
EQUIPMENT IN...

Datacabinet 90001. INTRODUCTIONCONTENTSPAGE
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Reason for Issue . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . , . . . 1
2. DESCRIPTION
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
3. CONFIGURATIONS
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
4. DATACABINET 9000 INSTALLATION AND...

SECTION MITL9141-753-525-NA
iv 

Datacabinet 90001. INTRODUCTION
General
1 
.OlThis Section describes the MITEL DATACABINET 9000, part
number 
9141-900-lOO-NA. The data shelves and DATASETswhich mount in these shelves are described in separate practices.
Reason for Issue
1.02This Section is issued to describe the cabinet in which MITEL
rack mounted 
DATASETs are installed.
1.03Only MITEL designed and approved equipment is to be installed
in the DATACABINET 9000.
Page 1 

SECTION MITL9141-753-525-NAPage 2 

Datacabinet 9000
2. DESCRIPTIONGeneral
2.01The DATACABINET 9000 is a free-standing metal cabinet ap-
proximately 60 cm x 60 cm x 98 cm high (24 inches by 24
inches by 39 inches high). It has locking doors at the front and the
rear, and contains rails inside for mounting data shelves and other
equipment.
2.02Figure 2-l shows the front view of the cabinet, with the door
open, and a configuration of three DATASHELF 9100 assemblies
and a Modem interconnect Panel. Figure 2-2 shows a rear view of the
cabinet...

SECTION MITL9141-753-525-NA
DATASET 1100
SERIES
ORDATASET 2100
SEORaESDATASET 2200cSERIES
00
0
r
0
3ii
/
-\
-0
\
c
U
/MODEM
__ INTERCONNECT
PANEL
>DATASHELF 9100
-FAN UNIT
KA0548Rl E2
Figule 2-lDATACABINET 9000, Front View, with Three DATASHELF 9100 Assemblies and a
Modem Interconnect Panel
Page 4 

Datacabinet 9000SHELF
POWER
CORDS
DISTRIBUlPANELSIGNAL
CABLES
.lON
- CABLE ENTRY
SLOTS AND
COVERSPOWER 
DIS;RIEUTION25 LAIRUNIT PANELSIGNAL CABLES
KA0586RlEFigure 2-2 DATACABINET 9000, Rear View
Page 5 

SECTION MITL9141-753-525-NAPage 6 

3. CONFIGURATIONS
General3.01A DATASHELF 9100 and a Modem lnterconnnect Panel are avail-
able for mounting within the DATACABINET 9000. This Part
describes different configurations that can be set up within the cabi-
net. Configurations are restricted only by the 35 inch height limit of the
19 inch rack and the total heights of the equipment being installed on
it. The DATASHELF 9100 is 8.75 inches high, and the Modem Intercon-
nect Panel is 3.5 inches high. Part 4 contains instructions for installing
the...