Mitel SX 200 DIGITAL Pabx Superset 3 Telephone Description Manual

SECTION MITL9141-753-526-NAPage 2 

Datashelf 9100
2. DATASHELF 9100
General2.01The DATASHELF 9100 is 8.75 in. high. The left side of the shelf
holds up to 16 
DATASETs, while the right side contains an
integral shelf power supply. All connections to the DATASHELF 9100
are made at the back of the shelf. Each card has connectors which are
connected directly to the device with which the 
DATASET is to cbm-municate. Each 
DATASET also has an edge connector which plugs into
the shelf backplane; this connector provides power to the card, and...

SECTION MITL9141-753-526-NARACK-MOUNTED
DATASET CARDON/OFF
SWITCH
POWER
SUPPLV
KAo317m
IFigure 2-l Front View of the DATASHELF 9100
Page 4 

Datashelf 9100IWMARVINIPUT FUSE
GROUND/
STUD
POWER CORDCONNECTOR
\
KA0344RZEFigure 2-2 Backplane and Connectors of the DATASHELF 9100
Page 5 

SECTION MITL9141-753-526-NAPage 6 

Datashelf 9100
3. DATASHELF 9100 INSTALLATION AND WIRING
Note:Each card slot not equipped with a DATASET set must be
equipped with a filler plate to maintain correct flow of cooling
air within the shelves; this does not apply to the top shelf of
any configuration.
CHART 3-1
INSTALL DATASHELF 9100 INTO A DATACABINET 9000
StepAction
1Unpack and inspect the shelf for damage or missing items.
2Turn off the DATACABINET 9000 power switch and remove the line cord from its
outlet. Open the doors of the cabinet....

SECTION MITL9141-753-526-NA
CARDFILE RAIL
I
FAN UNIT
KAO60 1 ROE0Figure 3-l Installation of 
Cardfile Rail
Page 8 

Datashelf 9100l!L
0DATASHELF 9100
80
0DATACABINET 9000
SIDE RAIL 
-
CARDFILE
RAILII“I III0
0
0
0
0
r
0
Q0
0
III/f--L- I:: . .
Figure 3-2 Connection of Shelf Ground Wire
Page 9 

MITEL STANDARD PRACTICESECTION MITL9141-753-528-NAIssue 1, April 1988
MODEM INTERCONNECT PANEL
@Copyright 1988, MITEL Corporation. All rights reserved.
T”Trademark of MITEL Corporation
@Registered Trademark of MITEL Corporationi 

SECTION MITL9141-753-528-NANOTICE
The information contained in this document is believed to be accurate in all respects but is
not warranted by 
Mite1 Corporation (MITEL). The information is subject to change without
notice and should not be construed in any way as a commitment by 
Mite1 or any of its
affiliates or subsidiaries. 
Mite1 and its affiliates and subsidiaries assume no responsibility
for any errors or omissions in this document. Revisions of this document or new editions of
it may be issued...