Lucent Technologies TransTalk 9000 Digital Wireless System MDW 9030P Wireless Pocketphone Installation And Use Manual

Maintaining the MDW 9030P Pocketphone  4-1
Maintaining the MDW 9030P Pocketphone Maintaining the MDW 9030P PocketphoneMaintaining the MDW 9030P Pocketphone Maintaining the MDW 9030P Pocketphone
Maintaining the MDW 9030P Pocketphone
4
Impor ImporImpor Impor
Impor
tant Safety Instr tant Safety Instrtant Safety Instr tant Safety Instr
tant Safety Instr
uctions uctionsuctions uctions
uctions
Please see Important Safety Instructions at the beginning of Chapter 2.
Removing a Radio Module Removing a Radio...

4-2   Maintaining the MDW 9030P Pocketphone
3Press up and hold the snap lock on the bottom
rear of the radio module.
4Slowly swing the radio modules card edge out of
the card edge connector on the back of the
carrier, releasing the snap lock when clear. Unhook the
radio module from the radio module mounting rod by
gently lifting upward.
If you removed a radio module from Slot 6 of a
carrier that has another carrier to the right of it,
you must insert another radio module into this slot.
Slot 6 of any...

Maintaining the MDW 9030P Pocketphone  4-3
Swapping Extensions Swapping ExtensionsSwapping Extensions Swapping Extensions
Swapping Extensions
If you want to change your phone’s extension number assignment, make sure the radio
module or carrier(s) is unplugged before you unplug the telephone line cord from the
communications system switch/control unit. Power down and then repower the carrier(s)
after all extension changes are made.
Unplug the telephone line cords from the
communications system...

4-4   Maintaining the MDW 9030P Pocketphone
4
5
12346
4TRANSTALK
2 1O   N2 1O   N
5
CAUTIONU
S
E
 O
N
L
Y
A
T
&
T
 C
A
B
L
E
P
⁄N
 847
667896IN
O
U
T
O
U
T O
F S
YN
C
OUT
OUT OF SYNC
Verify that the carrier’s Out of Sync LED is not
lit. If the LED is lit, power down and then
repower the carrier.  If the LED is still lit, follow the
suggestions in the Installation Problems section of
Chapter 5, Troubleshooting. If the LED is still lit, call
for help as described on the inside front cover of this
book....

Maintaining the MDW 9030P Pocketphone  4-5
Ordering Replacement & Optional Parts Ordering Replacement & Optional PartsOrdering Replacement & Optional Parts Ordering Replacement & Optional Parts
Ordering Replacement & Optional Parts
To order replacement parts or optional equipment in the continental U.S., call the
Sourcebook Sales, Catalog Sales, or National Parts Sales Center toll free. When ordering,
please use the part numbers shown in the table below:
Item Sourcebook
Sales
1 800 451-2100Catalog
Sales...

Troubleshooting
              
   5-1
Troubleshooting
5
Procedures
If you have a problem with your MDW 9030P Pocketphone, you may be able to solve it by
following the procedures included in this chapter. If you cannot resolve the problem, call
for customer support as described on the inside front cover of this book.
The problems in this chapter are organized as follows:
nInstallation
nHandset
nBattery
nVoice Quality
nRange
nBattery Charger
Installation Problems Installation ProblemsInstallation Problems...

5-2   Troubleshooting
Installation Problems (continued) Installation Problems (continued)Installation Problems (continued) Installation Problems (continued)
Installation Problems (continued)
SymptomPossible Solutions
After plugging the
radio module or
carrier into an
electrical outlet, one
or more radio module
POWER and PASS
LEDs do not light.Plug the radio module or
carrier(s) into an outlet not
controlled by a switch. Radio module or carrier(s) is
plugged into an electrical
outlet controlled by a...

Troubleshooting
              
   5-3
Installation Problems (continued) Installation Problems (continued)Installation Problems (continued) Installation Problems (continued)
Installation Problems (continued)
Symptom
Possible CausesPossible Solutions
* See “Customer Support” on the inside front cover of this book.
After plugging the
carrier into an
electrical outlet, the
PASS LED of one or
more radio modules
does not light.Radio modules are out of
synchronization.Power down the carrier and
repower it.  If...

5-4   Troubleshooting
Possible Solutions Symptom Possible Causes
Battery pack is not inserted
properly in the handset.Reinsert the battery pack in the
handset.
Insert a battery pack in the
handset. After pressing
O, one or more
of the following
applies:
nDial tone is not
heard.
nDisplay does not
show anything.
nRadio modules
RADIO LED does
not light.
Handset Problems Handset ProblemsHandset Problems Handset Problems
Handset Problems
There is no battery pack in
the handset.
Battery pack is not charged...

Troubleshooting
              
   5-5
Handset Problems (continued) Handset Problems (continued)Handset Problems (continued) Handset Problems (continued)
Handset Problems (continued)
Symptom Possible Causes Possible Solutions
You can hear the
party on the other
end, but they cannot
hear you. MUTE
appears in the
handset display.The M button was
pressed inadvertently.Press M again to turn off the mute
feature.
Plug the battery charger into an outlet
not controlled by a switch. Battery charger is
plugged...