Land Rover Range Rover Body Repair Rover Manual

CHASSIS AND BODY
47
REPAIR GRAB HANDLE
Service repair no - 76.58.30
Remove
1.Pull down grab handle.
2.Remove 2 grab handle retaining screw access
covers.
3.Remove 2 screws, remove grab handle.
Refit
4.Position grab handle, fit 2 retaining screws.
5.Fit 2 retaining screw access covers.
6.Release grab handle.FRONT GRILLE
Service repair no - 76.55.03
Remove
1.Remove 6 screws securing grille.
2.Remove front grille.
Refit
3.Reverse removal procedure. 

76CHASSIS AND BODY NEW RANGE ROVER
48
REPAIR EXTERIOR MIRROR
Service repair no - 76.10.52
Remove
1.Release cheater panel, disconnect 2 tweeter
speaker connectors. Remove cheater panel.
2.Disconnect mirror multiplug.
3.Remove 3 screws, remove mirror.
Refit
4.Fit mirror, tighten 3 retaining screws.
5.Connect mirror multiplug.
6.Position cheater panel, connect 2 tweeter
speaker connectors, secure panel to door.INTERIOR MIRROR
Service repair no - 76.10.51
Remove
1.Remove cover.
2.If fitted, diconnect...

CHASSIS AND BODY
49
REPAIR PARCEL TRAY SUPPORT
Service repair no - 76.67.11
Remove
1.Release 2 squab catches and fold rear seats
forward.
2.Remove parcel tray.
3.Remove 3 studs securing parcel tray support.
Remove support.
Refit
4.Reverse removal procedure.PARCEL TRAY SUPPORT TRIM
Service repair no - 76.67.12 - Right Hand
Service repair no - 76.67.21 - Left Hand
Remove
1.Remove parcel tray support.
See this section.
2.Remove D post lower trim.
3.Release tailgate aperture seal from support trim
flange....

76CHASSIS AND BODY NEW RANGE ROVER
50
REPAIR
7.Disconnect multiplug from sub-woofer.
Both Trim Panels
8.Release 2 sprag clips securing support trim to
body.
9.Remove support trim panel.
10. LH Trim Only:Separate sub-woofer from trim
panel.
Refit
11.Reverse removal procedure.A,B,D and E POST TRIMS
Remove
1.Remove aperture seal from appropriate area.
2.Remove retaining screws (A post lower trims)
3.Remove seat belt top mounting (B and D post
upper trims)
4.Release retaining clips, remove finisher.
Refit...

CHASSIS AND BODY
51
REPAIR 

76CHASSIS AND BODY NEW RANGE ROVER
52
REPAIR E POST - EXTERIOR TRIM
Service repair no - 76.43.
Remove
1.Open upper tailgate.
2.Remove 3 screws securing trim to E post.
3.Remove trim.
Refit
4.Position trim to E post, engage slot beneath
special washer on tailgate strut ball joint and
engage channel to rear edge of quarter glass.
5.Secure trim with screws.
6.Close tailgate.SEAT BELT - FRONT
Service repair no - 76.73.13
Remove
1.Remove lower B post finisher.
2.Remove cover and nut securing seat belt to...

CHASSIS AND BODY
53
REPAIR 6.Remove bolt securing belt reel to B post,
remove belt reel.
7.Move seat fully rearwards.
8.Remove cover from seat belt stalk fixing.
Remove bolt. Collect stalk.Refit
9.Position seat belt stalk. Secure with retaining
bolt. Tighten to
35 Nm. (26 lbf.ft).Fit bolt
cover.
10.Fit seat belt reel to B post. Secure with retaining
bolt. Tighten to
35 Nm. (26 lbf.ft)
11.Move seat fully forwards.
12.Secure seat belt to lower anchorage point. Fit
bolt cover.
WARNING: Ensure that belt is...

76CHASSIS AND BODY NEW RANGE ROVER
54
REPAIR FRONT SEAT BELT ADJUSTABLE MOUNTING
Service repair no - 76.73.26
Remove
1.Remove B post trim upper.
2.Remove 2 screws securing adjustable mounting.
Remove mounting.
Refit
3.Position adjustable mounting. Secure with
screws. Tighten to
25 Nm. (18 lbf.ft)
4.Fit B post trim upper.SEAT BELT ADJUSTABLE MOUNTING - D POST
Service repair no - 76.73.36
Remove
1.Remove D post trim - upper.
2.Remove 2 screws securing adjustable mounting.
Remove mounting.
Refit
3.Position...

CHASSIS AND BODY
55
REPAIR REAR SEAT BELT - CENTRE
Service repair no - 76.73.20
Remove
1.Remove right hand rear seat.
See SEATS,
Repair.
2.Remove 3 screws securing squab hinge cover.
Remove cover.
3.Remove 2 bolts securing squab to cushion
assembly.
4.Remove squab from cushion assembly.
5.Remove bolt and wave washer securing stalk to
squab hinge. Remove stalk. Collect plain
washer.
6.Release beaded edge of cushion cover from
seat pan flange. Remove cushion cover/foam
assembly.
CAUTION: Take care when...

76CHASSIS AND BODY NEW RANGE ROVER
56
REPAIR 7.Remove 3 screws securing anchorage cover to
seat pan. Remove cover in 2 pieces.
8.Remove bolt securing seat belt to seat pan.
Remove belt, collect spacer.
Refit
9.Fit seat belt to seat pan. Secure with bolt and
spacer. Tighten to
35 Nm. (26 lbf.ft)
10.Fit seat belt anchorage cover. Secure with
screws.
11.Fit cushion assembly to seat pan. Secure
beaded edge of cover to seat pan flange.
12.Fit stalk to squab hinge. Secure with bolt.
Tighten to
35 Nm. (26...