Land Rover Range Rover Body Repair Rover Manual

CHASSIS AND BODY
57
REPAIR REAR SEAT BELT - LEFT HAND
Service repair no - 76.73.23
Remove
1.Remove parcel shelf support trim.
See this
section.
2.Remove D post lower trim.See this section.
3.Remove cover and nut securing seat belt to
upper anchorage point.
4.Remove bolt securing seat belt reel.
5.Remove seat belt reel.
6.Remove left hand rear seat.
See SEATS,
Repair.
7.Remove 3 screws securing squab hinge cover.
Remove cover.
8.Remove 2 bolts securing squab to cushion
assembly.
9.Remove squab from...

76CHASSIS AND BODY NEW RANGE ROVER
58
REPAIR REAR SEAT BELT - RIGHT HAND
Service repair no - 76.73.24
Remove
1.Remove parcel shelf support trim.
See this
section.
2.Remove D post lower trim.
3.Remove cover and nut securing seat belt to
upper anchorage point.
4.Remove bolt securing seat belt reel.
5.Remove seat belt reel.
6.Remove right hand rear seat.
See SEATS,
Repair.
7.Remove 3 screws securing squab hinge cover.
Remove cover.
8.Remove 2 bolts securing squab to cushion
assembly. Remove squab.
9.Release...

CHASSIS AND BODY
59
REPAIR
CAUTION: Take care when releasing
cover/foam from belt anchorage finisher.
10.Remove 3 screws securing anchorage cover to
seat pan. Remove cover in 2 pieces.
11.Remove bolt securing stalk to seat pan. Remove
stalk. Collect 2 spacers and wave washer. 

76CHASSIS AND BODY NEW RANGE ROVER
60
REPAIR
Refit
12.Fit stalk to seat pan. Secure with bolt, spacers
and wave washer. Tighten to
35 Nm. (26 lbf.ft)
13.Fit seat belt anchorage cover. Secure with
screws.
14.Fit cushion assembly to seat pan. Secure
beaded edge of cover to seat pan flange.
15.Fit stalk to squab hinge. Secure with bolt.
Tighten to
35 Nm. (26 lbf.ft)
16.Position seat squab to cushion assembly.
Secure with bolts. Tighten to
45 Nm. (33 lbf.ft)
17.Refit squab hinge cover. Secure with screws....

CHASSIS AND BODY
61
REPAIR SLIDING ROOF - ELECTRIC
Service repair no - 76.82.44
Remove
1.Remove headlining.
See this section.
2.Disconnect motor multiplug.
3.Disconnect sliding roof drain tubes.
4.Remove 8 bolts securing sliding roof.
5.With assistance, remove 2 remaining bolts.
Remove sliding roof.
6.Remove seal from sliding roof.Refit
7.Ensure mating faces are clean.
8.Fit new seal to sliding roof.
9.With assistance, position sliding roof. Fit 2 bolts.
10.Fit remaining bolts.
11.Connect drain tubes....

76CHASSIS AND BODY NEW RANGE ROVER
62
REPAIR HEADLINING - SLIDING ROOF
Service repair no - 76.64.15
Remove
1.Remove upper trims from A,B,D & E posts.
See this section.
2.Remove both sun visors.See this section.
3.Remove grab handles.See this section.
4.Remove parcel tray support trim.See this
section.
5.Remove interior lamps.See ELECTRICAL,
Repair.
6.Remove front courtesy lamp.See
ELECTRICAL, Repair.
7.Remove ultrasonic sensor.See ELECTRICAL,
Repair.
8.Fold down rear seat squabs. Recline front seat...

CHASSIS AND BODY
63
REPAIR SUNROOF DRAIN TUBE - FRONT
Service repair no - 76.82.21
Remove
1.Remove headlining.
See this section.
2.Remove wheelarch liner.See this section.
3.Release drain tube from sunroof.
4.Release drain tube grommet from body behind
wheel arch liner.
5.Tie draw string to one end of drain tube and pull
tube from A post.
Refit
6.Tie draw string to new drain tube and pull
through A post.
7.Fit grommet to drain tube, secure to body.
8.Secure drain tube to sunroof.
9.Fit headlining.
See...

76CHASSIS AND BODY NEW RANGE ROVER
64
REPAIR SUNROOF DRAIN TUBE - REAR
Service repair no - 76.82.22
Remove
1.Remove headlining.
See this section.
NOTE: Ensure that parcel shelf support
panel is removed from side of drain tube
to be removed.
2.Release clip from drain tube.
3.Disconnect drain tube from sunroof.
4.Remove drain tube from wheel arch grommet.
Refit
5.Fit drain tube to sunroof, secure with clip.
6.Fit drain tube through wheel arch grommet.
7.Refit headlining.
See this section. 

CHASSIS AND BODY
65
REPAIR SUN VISOR
Service repair no - 76.10.47
Remove
1.Release visor from clip.
2.Remove 3 visor retaining screws.
3.Disconnect visor lamp multiplug.
4.Remove visor.
5.Remove clip if required. Carefully lever plastic
tag down.
6.Remove screw, remove clip.
Refit
7.Reverse removal procedure.SILL FINISHER
Service repair no - 76.43.84
Remove
1.Remove 3 screws securing front tread plate.
2.Remove 2 screws securing rear tread plate.
3.Remove trim stud securing rear of sill finisher....

76CHASSIS AND BODY NEW RANGE ROVER
66
REPAIR TAILGATE - UPPER
Service repair no - 76.28.29
Remove
1.Remove both E post finishers.
2.Remove 2 trim fixing studs. Release headlining
from E posts.
3.Release 4 turn buckles securing access panel to
LH side load space trim. Remove panel.
4.Locate rear screen washer non-return valve.
Disconnect tailgate feed tube from valve.
5.Attach draw string to tube to aid re-assembly.
6.Release tailgate harness protective sleeve from
roof panel.
7.Disconnect 3 tailgate...