Konica Minolta magicolor 5670EN User Manual

Replacing Consumables 177
9Prepare a new transfer belt unit.
Be careful not to touch 
the surface of the belt.
Do not remove the blue 
lever.
10Insert the new remove all pack-
ing tape from the transfer belt 
unit.
11Remove the protective cover 
from the transfer belt unit.
12Insert the new transfer belt unit 
along the rails.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 178
13From the right side cover side, 
tighten the screws to secure the 
transfer belt unit and then close 
the right side cover.
14Close the right side cover.
15Attach the left-side cover.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 179
16Tighten the four screws on the 
left side.
17Install the print unit and waste 
toner bottle.
For details on installing 
the print unit or waste 
toner bottle, refer to 
“Replacing a Print Unit” 
on page 161 or “Replac-
ing the Waste Toner Bot-
tle” on page 167.
18Close the front cover.
19Reset the counter in the MAINTENANCE MENU/SUPPLIES/
REPLACE/TRANS. BELT
 menu.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 180
Replacing the Backup Battery
When the backup battery is at its end of life, the printer’s date and time can-
not be retained. Follow the procedure described below to replace the backup 
battery.
Note
Only use the coin-shaped 3V lithium battery CR2032. It’s very important 
to protect the printer controller board and any associated circuit boards 
from electrostatic damage. Before performing this procedure, review 
the antistatic caution on page 250. In addition, always handle...

Replacing Consumables 181
3Using a screwdriver, loosen the 
seven screws. (Do not remove 
them from the printer.)
4Slide the panel slightly to the 
right and lift it off the printer.
5Remove the hook, and then 
remove the backup battery.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 182
6Insert a new backup battery.
When inserting the new 
backup battery, be sure 
that the + side faces 
toward the left.
Note
Risk of explosion if battery is replaced by an incorrect type. Dispose of 
used batteries according to your local regulations. Do not burn the 
backup battery.
7Reinstall the panel and tighten the seven screws.
8Attach the rear cover.
9Reconnect all interface cables.
10Reconnect the power cord, and 
turn on the printer.
11Use DATE on the SYS DEFAULT...

Replacing Consumables 183 Replacing the Staple
When there are no more staples, the message STAPLER EMPTY appears. 
Replace the staple cartridge.
1Open the stapler cover.
2Pull out the stapling unit.
3Pull out the stapler.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 184
4Remove the empty cartridge, 
and then insert the new one.
5Install the stapler.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 185
6Install the stapling unit.
7Close the stapler cover.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 186
Downloaded From ManualsPrinter.com Manuals