Konica Minolta magicolor 5670EN User Manual

Replacing Consumables 157 Replacing a Toner Cartridge
Note
Be careful not to spill toner while replacing a toner cartridge. If toner 
spills, immediately wipe it off with a soft, dry cloth.
If 
TONER LOW on the SYS DEFAULT MENU/ENABLE WARNING is set 
to 
ON, the message TONER LOW X (where “X”. represents the color of the 
toner) appears when toner cartridge becomes empty. Follow the steps below 
to replace the toner cartridge.
If TONER LOW on the SYS DEFAULT MENU/ENABLE WARNING 
is set to 
OFF, you are...

Replacing Consumables 158
3Lower the lever to release the 
lock.
4Grab the handle of the toner car-
tridge to be replaced, and then 
pull out the cartridge.
The following instructions show 
the procedure to replace the 
toner cartridge (Y).
Note
Dispose of the used toner cartridge according to your local regulations. 
Do not burn the toner cartridge.
For details, refer to “About Toner Cartridges” on page 154.
5Check the color of the new toner cartridge to be installed.
6Remove the toner cartridge from...

Replacing Consumables 159
7Shake the cartridge to distribute 
the toner.
8Make sure that the toner car-
tridge is the same color as the 
printer compartment, and then 
insert the toner cartridge into the 
printer.
9Make sure that the toner car-
tridge is securely installed, and 
then peel off the protective film.
Y
3 ×
Y
Y
Y
Y
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 160
10Raise the front lever to its origi-
nal position.
11Pull the lever to the left to lock it 
in place.
The front lever should be 
securely returned to its 
original position; other-
wise, the front cover of 
the printer cannot be 
closed.
12Close the front cover.
Y
Y
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 161 Replacing a Print Unit
When replacing a print unit, refer to the following table. For optimum print 
quality and performance, use only approved KONICA MINOLTA print units 
for your specific printer type, as listed in the table below. You can find your 
printer type and the print unit part numbers on the consumables reorder label 
inside the front cover your printer.
“I-UNIT” displayed in the control panel refers to the print unit.
Note
Do not touch the OPC drum 
surface. This...

Replacing Consumables 162
If I-UNIT LOW on the SYS DEFAULT MENU/ENABLE WARNING is set 
to 
ON, the message I-UNIT LOW X (where “X”. represents the color of the 
toner) appears when a print unit becomes empty. Follow the steps below to 
replace the print unit.
You are advised to replace the indicated print unit when the message 
I-UNIT LIFE X appears.
1Check the message window to see which color print unit needs replacing.
2Open the printer’s front cover.
3Pull the front lever of the color 
toner...

Replacing Consumables 163
4Lower the lever to release the 
lock.
5Press down the area marked 
“Push” on the print unit to be 
replaced, and then slide the unit 
all the way out of the printer.
The following instruc-
tions show the proce-
dure to replace the print 
unit (K).
Note
Dispose of the used print unit according to your local regulations.
Do not burn the print unit.
6Check the color of the new print unit to be installed.
In order to prevent toner from spilling, leave the print unit in the 
bag...

Replacing Consumables 164
7Remove the print unit from the 
bag.
8Hold the print unit with both 
hands, and then shake it twice 
as shown in the illustration.
Do not grab the bottom of 
the bag; otherwise, the 
print unit may be dam-
aged, resulting in 
decreased print quality.
9Remove all packing tape from 
the print unit.
KPUSH
YPU
SH
YP
U
S
H
K
P
U
S
H
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 165
10Remove the protective cover 
from the print unit. The protec-
tive cover slides after having 
turned.
11Make sure that the new print unit 
to be installed is the same color 
as the printer compartment, and 
then install the print unit in the 
printer.
12Raise the front lever to its origi-
nal position.
K
P
U
S
H
K
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 166
13Pull the lever to the left to lock it 
in place.
The front lever should be 
securely returned to its 
original position; other-
wise, the front cover of 
the printer cannot be 
closed.
14Close the front cover.
K
Downloaded From ManualsPrinter.com Manuals