Konica Minolta magicolor 4695MF User Manual

Replacing Consumables 227
18Close the right door.
19Install the all imaging units.
For details on installing 
the imaging unit, refer to 
“Replacing an Imaging 
Unit” on page 207.
YMC
K
K
K
K
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 228
20Install the waste toner bottle.
For details on installing 
the waste toner bottle, 
refer to “Replacing the 
Waste Toner Bottle” on 
page 213.
21Close the front cover.
22Reconnect the power cord, and 
turn on the machine.
23Reset the counter with ADMIN. MANAGEMENT/SUPPLIES 
REPLACE/TRANSFER BELT
 in the UTILITY menu.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 229 Replacing the Fuser Unit
When the time to replace the fuser unit is reached, the message Fuser 
Unit Life
 appears. Printing can continue even after this message 
appears; however, since the print quality is reduced, the fuser unit should be 
replaced immediately
1Turn off the machine and discon-
nect the power cord and inter-
face cables.
Note
There are extremely hot parts within the machine. Before replacing the 
fuser unit, wait about 20 minutes after turning off the machine,...

Replacing Consumables 230
3Slowly raise the scanner unit.
4Pull the lever, and then open the 
right door.
Before opening the right 
door, fold up Tray 1.
5Use a coin to loosen the two 
screws securing the fuser unit. 
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 231
6Remove the fuser unit.
7Prepare a new fuser unit.
Be careful not to touch 
the surface of the fuser 
roller.
8Insert the fuser unit.
Downloaded From ManualsPrinter.com Manuals 

Replacing Consumables 232
9Tighten the two screws to secure 
the fuser unit. 
10Close the right door; slowly 
lower the scanner unit, and then 
close the front cover.
11Reconnect the power cord, and 
turn on the machine.
12Reset the counter with ADMIN. MANAGEMENT/SUPPLIES 
REPLACE/FUSER UNIT
 in the UTILITY menu.
Downloaded From ManualsPrinter.com Manuals 

10
10Maintenance
Downloaded From ManualsPrinter.com Manuals 

Maintaining the Machine 234
Maintaining the Machine
CAUTION
Read all caution and warning labels carefully, making sure to follow any 
instructions contained in them. These labels are located on the inside of 
the machine’s covers and the interior of the machine body.
Handle the machine with care to preserve its life. Abuse handling may cause 
damage and void your warranty. If dust and paper scraps remain on the 
inside or outside of the machine, machine performance and print quality will 
suffer, so the...

Maintaining the Machine 235
„Do not cover the machine immediately after using it. Turn it off and wait 
until it cools down.
„Do not leave the machine’s covers open for any length of time, especially 
in well-lit places; light may damage the toner cartridges.
„Do not open the machine during printing.
„Do not tap media stacks on the machine.
„Do not lubricate or disassemble the machine.
„Do not tilt the machine.
„Do not touch the electrical contacts, gears, or laser devices. Doing so may 
damage the...

Cleaning the Machine 236
Cleaning the Machine
CAUTION
Be sure to turn off the machine and unplug the power cord before 
cleaning.
Exterior
„Control Panel
„Machine Exterior
„Original Cover Pad „Original Glass„Ventilation Grill
Downloaded From ManualsPrinter.com Manuals