Konica Minolta bizhub C552 User Manual

							bizhub C652/C652DS/C552/C552DS/C4528-4
8.1 Paper8
Loading paper into trays 3 and 4
The same procedures can be used to load paper into trays 3 and 4.
The following procedure describes how to load paper into tray 3.
1Pull out tray 3.
NOTICE
Be careful not to touch the surface of the paper take-up roller with 
your hand.
2Lift up the paper take-up roller, and then load the paper into the 
tray.
%Load the paper into the tray so that the side of the paper to be 
printed on (the side facing up when the package was 
unwrapped) faces up.
%Do not load so many sheets of paper that the top of the stack 
is higher than the  mark.
%Do not load tray 3 with paper of a size other than that 
previously specified.
%If paper is curled, flatten it before loading it.
%If special paper is loaded, the paper type must be specified.
%Load letterhead paper so that the side to be printed on faces down.
%To change the paper size for tray 3, contact your service representative.
3Lower the paper take-up roller, and then close tray 3.
dReference
To configure paper settings:
Press [Basic] ö [Paper].
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-5
8.1 Paper8
Loading paper into the bypass tray
1Open the bypass tray.
%To load large-sized paper, pull out the tray extension.
NOTICE
Be careful not to touch the surface of the paper take-up roller with 
your hand.
2With the side to be printed on facing down, insert the paper as far as possible into the feed slot.
%The image will be printed on the surface of the paper facing down when the paper is loaded into the 
bypass tray.
%Do not load so many sheets of paper that the top of the stack is higher than the  mark.
%If paper is curled, flatten it before loading it.
%Push the paper guides firmly up against the edges of the paper.
%Load letterhead paper so that the side to be printed on faces up.
%When loading postcards:
Load them in the w orientation, as shown in the illustration.
To use postcards other than 4 e 6-size (A6-size), check the 
size of postcards to be used, and then select the size on the 
Custom Size screen before using them.
%When using envelopes: 
Expel air from the envelopes, and then load them while holding 
the folds of the envelopes.
Load them with the flap side up, as shown in the illustration. 
The flap side of envelopes cannot be printed on.
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-6
8.1 Paper8
%To load label sheets:
Load them in the w orientation, as shown in the illustration.
A label sheet consists of the printing surface, sticking layer, 
and pasteboard. Peel off the pasteboard, then you can stick 
the label to other objects.
3Slide the lateral guides to fit the size of paper being loaded.
4Select the paper type.
%To use label sheets, select [Thick 1].
%OHP transparencies can be printed only in black. Before selecting OHP transparencies, select 
[Black] in the Color tab.
%If you select [4 e 6 w (A6 Card w)], the paper type is automatically set to [Thick 3].
dReference
To configure paper settings:
Press [Basic] ö [Paper].
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-7
8.1 Paper8
Loading paper into the LCT
The same procedures can be used to load paper into the Large capacity unit LU-301 and LU-204.
The following procedure describes how to load paper into Large capacity unit LU-301.
0To change the paper size, contact your service representative.
1Open the upper door.
NOTICE
Be careful not to touch the surface of the paper take-up roller with 
your hand.
2Lift up the paper take-up roller, and then load the paper into the 
tray.
%Load the paper into the tray so that the side of the paper to be 
printed on (the side facing up when the package was 
unwrapped) faces down.
%Do not load so many sheets of paper that the top of the stack 
is higher than the  mark.
%Do not load the LCT with paper of a size other than that 
previously specified.
%If paper is curled, flatten it before loading it.
%If special paper is loaded, the paper type must be specified.
%Load letterhead paper so that the side to be printed on faces 
up.
dReference
To configure paper settings:
Press [Basic] ö [Paper].
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-8
8.2 Consumables8
8.2 Consumables
8.2.1 Checking comsumables
Replacement message
When it is time to replace the Toner Cartridge or Imaging Unit, an advanced warning message appears at the 
top of the screen.
For the replacement procedure, refer to the guidance or the [Quick Guide Copy/Print/Fax/Scan/Box 
Operations].
For details on using the guidance, refer to the [Quick Guide Copy/Print/Fax/Scan/Box Operations].
When the message appears, make a preparation and replace the Toner Cartridge or Imaging Unit according 
to the guidance contained in your maintenance agreement.
When it is almost time to replace the Toner Cartridge, an advanced warning message similar to the one 
shown below appears.
When the message appears, prepare to replace the Toner Cartridge according to the guidance contained in 
your maintenance agreement. 
When it is time to replace the Toner Cartridge or Imaging Unit, an advanced warning message similar to the 
one shown below appears. Replace them according to the guidance contained in your maintenance 
agreement.
-Do not replace any color other than the one indicated in the message in the touch panel.
-For the Toner Cartridge, the machine stops operating after the message appears.
Toner Cartridge
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-9
8.2 Consumables8
Imaging Unit
NOTICE
Do not replace the Imaging Unit until a Please replace following unit(s). message appears.
If you continue to use the drum unit while an advanced warning message is displayed, the following 
replacement message appears. Replace the drum unit according to the guidance contained in your 
maintenance agreement.
Toner Cartridge
Imaging Unit
If a Toner Cartridge other than for black or the Imaging Unit is empty, printing can continue using black. Press 
[Continue], and then select the job to be printed.Replacement by user Replacement by service representative
Replacement by user Replacement by service representative
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-10
8.2 Consumables8
Checking consumables status
In the Check Consumable Life screen, you can check the status (usage level) of consumables.
1Press the [Utility/Counter] key.
2Press [Check Consumable Life].
%To print the list of usage levels, press [Print List], then [Start] or the [Start] key.
Viewing counters
In the Meter Count screen, you can check the total number of prints since counting started. In the Coverage 
Rate screen, the consumed amount of toner can be viewed.
1Press the [Utility/Counter] key.
2Press [Meter Count] ö [Check Details].
%To print the counter list, press [Print List], select paper, and then press the [Start] key.
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-11
8.2 Consumables8
%To display the Coverage Rate screen, press [Coverage Rate].
Checking the total number of pages printed
Pressing Total Counter displays the total number of pages printed to 
date.
Total Counter
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-12
8.3 Cleaning procedure8
8.3 Cleaning procedure
Slit glass (bizhub C652/C552/C452)
NOTICE
Do not touch the slit glass.
1Open the ADF, and then remove the slit glass cleaner.
2Wipe stains off the slit glass using the slit glass cleaner.
%Wipe off stains from the back side to the front side along the 
guide. 
Slit glass (front) (bizhub C652DS/C552DS)
NOTICE
Do not touch the slit glass (front).
1Open the ADF, and then remove the slit glass cleaner.
2Wipe stains off the slit glass using the slit glass (front) cleaner.
%Wipe off stains from the back side to the front side along the 
guide. 
Downloaded From ManualsPrinter.com Manuals 
						

							bizhub C652/C652DS/C552/C552DS/C4528-13
8.3 Cleaning procedure8
Slit glass (back) (bizhub C652DS/C552DS)
NOTICE
Do not touch the slit glass (back).
1Open the ADF, and then remove the slit glass cleaner.
2Open the opening and closing guide.
3Wipe stains off the slit glass using the slit glass (back) cleaner.
%Wipe off stains from the back side to the front side along the 
guide. 
Original glass, control panel, paper take-up roller
NOTICE
Do not press the control panel hard, or the keys and touch panel may be damaged.
%Wipe the surface using a soft, dry cloth.
Downloaded From ManualsPrinter.com Manuals