Inter-Tel 824 Installation And Field Maintenance Manual

INTER-TEL PRACTICES 
STATION FEATURES 
824 INSTALLATION & MAINTENANCE . 
Issue 1, 
June 1984 
‘ 
(3) The called stations speaker 
is activated if handsfree 
answering has been enabled for that station and you may 
announce yourself. 
3.08 If the called station is busy, 
later or, without hanging up, you may hang up and try 
wait until it is available. camp on to. the busy station and 
and Call Waiting. Refer to Section E, Intercom..Camp-On 
- 
3.09 If the called station is busy on an outside call, you...

INTER-TEL PRACTICES 
824 IBSTALLATION & MAINTENAHCE STATION FEATURES 
Issue 1, June 1984 
3.16 To answer a waitinq intercom call while on a C.O. call: 
(1) Press the ,HOLD key to place the outside call on hold. 
The waiting intercom call will automatically connect. 
(2) TO reconnect with the C.O. call on hold, press the medium 
fluttering C.O. line key. 
The intercom call will be dis- 
connected. 
3.17 To answer a waitinq intercom call while on another intercom 
call: 
Terminate the current intercom...

INTER-TEL PRACTICES STATION FEATURES 
824 IBSTA.LLATIOI!l & MAIWIENA?ZE Issue 1, 
June 1984 
(4) The line key will flash at a delayed rate while the 
dialing and call are in progress. 
Display keysets show 
the elapsed time, which advances every ten seconds. 
4.05 Receiving a C.O. Call: 
(1) When a line key is flashing slowly and is accompanied by 
long, continuous tones (if programmed for audible ring- 
ing), lift the handset and press the flashing line key. 
(2) The call is connected and the line key...

INTER-TEL PRACTICES STATION FEATURES 
824 INSTALLATION & MAINTENANCE -Issue 1, 
June 1984 
Preselect Line On-Hook 
4.10 This feature allows the station user to preselect an avail- 
able C.O. line while on-hook. .After pressing the desired line 
key, you must take action within 15 seconds. 
This eliminates the 
possibility of a line being seized inadvertently and the line 
being tied up unnecessarily. 
4.11 To preselect a C.O. line: 
(1) Press an available C.O. line key. 
(2) After h earing the outside...

INTER-TEL PRACTICES STATION FEATURES 
824 INSTALLATION C MAINTENANCE Issue 1, June 1984 
Automatic Line Selection (AUTO) -- Incdnq Call 
4.15 Incoming calls may.be answered with the automatic 
preselect 
line feature (if it has been enabled with Maintenance Panel Pro- 
gram 91). 
If lines are ringing simultaneously, the lowest num- 
bered ringing line is selected. 
4.16 To automatically select an incoming call: 
(1) Press the AUTO key and lift the handset. 
(2) The ringing line is connected.. Elapsed...

INTER-TEL PRACTICES 
824 IBSTALLATION & MAINTENANCE STATION FEATURES 
Issue 1, June 1984 
4.22 1fthe waiting station is busy when the requested line is 
available, 
that station is placed back in the queue list. The 
next station waiting will receive a signal for the available 
line. 
If the waiting station is idle, 
the system signals the 
station for a maximum of 15 seconds. If unanswered after this 
time limit, 
the next person 
in line is signalled, and the un- 
available party is removed from the...

INTER-TEL PRACTICES STATION FEATURES 
824 ILJSTALLATION b MAINTENANCE Issue 1, June 1984 
4.27 To disconnectwhen dialing o&hook: After reaching a busy 
or unanswered line, 
you may disconnect by pressing the RLS key. 
The light under the line key will go out. 
Manually Dialing Specialized Common Carrier (SCC) Numbers 
4.28 To dial SCC numbers: 
(1) Dial the SCC 1 
ocal number and listen for the special dial 
tone. 
(2) Dial the SCC security code. 
(3) Dial th e area code and telephone number desired....

INTER-TEL PRACTICES 
824 IBSTALLATIOlY & HAIElTI3NABKE STATION FEATURJZS 
Issue 1, June 1984 
4.33 To store frequently called numbers: 
(1) Lift the h  ._ ..- . 
andset and press the MEM key. 
Display keysets 
show PROGRAM MODE. 
(2) Press the SPD key and one of the DSS keys (l-24). Dis- 
play keysets show the DSS number. 
(3) Enter the phone number, 
including 1 (if required) and 
area code (up to 16 digits). Display keysets will show 
the first 12 digits at one time. 
(4) Repeat steps 2 and 3 to store...

INTER-TEL PRACTICES STATION FEATURES 
824 INSTALLATION h MAINTEXANCE Issue 1, June 1984 
System Speed Dialinq 
4.37 Up to 100 system speed numbers are available to all station 
users. These numbers are entered by the station designated in 
Maintenance Program 52. Like station speed numbers, each can in- 
.clude up to 16 digits, including area code and phone number. If 
your area requires 
l+ dialing for direct long distance calls, 
also enter the 1 in your speed dial number. 
4.38 To store system speed...

INTER-TEL PRACTICES 
824 IPJSTAIJATION 6r MAINTE.NANCE STATION FEATURES 
Issue 1, 
June 1984 
Speed Dialinq Specialized Comon Carrier (SCC) Numbers 
4.42 Memory locations may be chained together for use with 
Specialized Common Carrier (SCC) numbers requiring more than 16 
digits or pauses in the dialing sequence. 
4.43 Three numbers (the SCC local number, your security code, 
and the telephone number)- are 
linked 
dialing process. together in the speed- 
4.44 When dialing SCC numbers, 
both station and...