Inter-Tel 824 Installation And Field Maintenance Manual

._ 
.’ 
. 
INTER-TEL ADDENDUM TO824 MANUAL 
DECEMBER 1985 
PLANTRONICS PHONEBEAM SPEAKERPHONE 
. . . . 
A Plantronics PhoneBeam Speakerphone (model IR 101-01 or IR lOl- 
03) can be connected to a keyset for handsfree operation on out- 
side (C.O.) calls. 
The model 01 interface cable is terminated on 
a SO-pin connector; 
an IR-2 Adapter can be ordered from Plantron- 
its to provide individual spade lug connectors. 
The model 03 
interface cable is terminated on .individual spade connectors....

. 
INTER-TEL ADDENDUM TO 824 MANUAL 
DECEMBER 1985 
-. 
B. Operate the Companion II Speakerphone 
The speakerphone can be turned on or off at any time during a 
call. To transfer from the speakerphone to .the handset, lift the 
handset and press the speakerphone OFF key. 
To disconnect, hang 
up= To transfer from the handset to the speakerphone, press the 
keyset HOLD key and replace the handset. 
Then press the speaker- 
phone ON key and the flashing line key. 
To disconnect, press the 
speakerphone OFF...

. 
INTER-TEL ADDENDUM TO 824 MANUAL 
DECEMBER 1985 
PAGING FEATURES 
Page 8-34, 
paragraphs 5.13 and 5.14. 
Delete double tone and 
insert three tones. 
ADDITIONS TO 824 MANUAL 
NORTHERN TELECOM COMPANION II SPEAKERPHONE 
A Northern Telecomm Companion II Speakerphone can be connected to 
a keyset for handsfree operation on outside (C.O.) calls. In- 
stallation and operation procedures appear below. 
A. 
1. 
2. 
I 3. 
4. 
5. 
6. 
7. 
8. 
9. 
Install the Companion II Speakerphone 
Connect the speakerphone...

IhTER-TEL ADDENDUM TO 824 MANUAL 
DECEMBER 1985 
, 
BATTERY BACK-UP 
Page 3-47, paragraph 8.01.(6). 
Correct text to read as follows: 
If external batteries are installed, 
they must 
be fully charged 
at the time of installation. 
Because they are not charged by the 
system, they must 
be disconnected and recharged after use. 
Con- 
sult your back-up power representative for assistance in choosing 
the proper charger and batteries. 
NOTE: This completes 
the installation procedure for external...

. 
INTER-TEL ADDENDUM TO 824 MANUAL 
DECEMBER 1985 
I CHANGES AND ADDITIONS 
TO THE 824 INSTALLATION & FIELD MAINTENANCE MANUAL 
Part No. 
247.8002 
This addendum updates the current issue of the 824 Installation & 
Field.Maintenance Manual and provides additional information that 
previously did not appear in the manual. 
Make changes to your 
. 
manual as indicated on pages 1 through 3 and insert .pages 3 
. through 7 in your manual for future reference. 
. 
CHANGES TO THE 824 MANUAL -_ .~ 
KTI-4 CARD...

. . . Page Numbers 
Owner Installation 
3-8 8-8 ADDl Interdigital Time-Out: 
Default = 15 seconds 
Variable Range 01-99 
4-8 Program # 16 
Name: Add-l Timer 
Data LED A: O-9 
Data LED B: l-9 
Initialized: Preset to 15 
4-13 Between F and G: 
Program Number 16 - Add-l Timer: 
This sets the 
time delay (plus 30 
seconds if SMDR option 2 or 3 
is selected) before the SMDR starts timing a call 
after the last digit 
is dialed. 
The timer resets 
for every digit dialed. 
Digits dialed will not be 
monitored...

Page Numbers 
Owner Installation 
3-10 8-10 
AUTO KEY description: 
..line for 
incoming Automatically selects a C.O. 
calls, 
transferred 
calls, 
and 
calls placed on hold on the keyset in use. 
3-19 
8-19 
Automatic Line Selection (AUTO) -- Outgoing Call: 
Delete this section, 
4.14. including paragraphs 4.12 to 
3-20 
8-20 
In paragraph 4.17, delete priority (3). 
3. PR0GwL.E ADD-l INTERDIGITAL TIMER 
For the System Message Detail Recording,. the type of call to mon- 
itor and the 
mable. time to...