HP Z5200 Owners Manual

18.Unroute the Trailing Cables.
19.Open the Carriage Cover.
20.Remove all the Printheads.
ENWW Carriage Assembly (with or without Trailing Cable) 247 

21.Remove the four T-15 screws that secure t he Ink Supply Tubes to the Carriage Assembly.
22.Carefully lift out the Ink Supply Tubes and close the carriage cover at the same time.
23.Close and lock the Carriage Cover.
248 Chapter 6   Removal and Installation ENWW 

24.Loosen the T-10 uncapping scre w sufficiently so you can manually move the Carriage Assembly
in step 26.
25. Push the Carriage Assembly into the print path.
26.Unclip the small cover of the Carriage PCA.
ENWW Carriage Assembly (with or without Trailing Cable) 249 

27.Remove the small cover of the Carriage PCA.
28.Disconnect the two ribbon  cables of the Trailing Cables from the Carriage PCA.
29.Straighten the two ribbon c ables of the Trailing Cables  and remove the Ferrite Core.
250 Chapter 6   Removal and Installation ENWW 

30.Slide the Trailing Cables out of the atta chment clips of the Carriage Assembly.
31.Loosen the T-15 screw Belt Tensioner to the  printer to remove the tension from the belt.
32.Leave the Belt Tensioner in place with all the tension removed.
NOTE: The belt tensioner has a spacer between the tensioner and the right end plate.
ENWW Carriage Assembly (with or without Trailing Cable) 251 

33.Remove the Belt Assembly from the Scan- Axis Motor drive wheel.
34.Remove the two T-15 screw that secure the Media Lever attachment plate.
35.Remove the Media Lever attachment plate.
252 Chapter 6   Removal and Installation ENWW 

36.Disconnect the Pinchwheel Lifter Sensor.
37.Unroute the cables from the cable clamps on the Scan Side Panel.
38.Remove the seven T-15 screw that secure the Scan Side Panel to the printer.
ENWW Carriage Assembly (with or without Trailing Cable) 253 

39.Remove the Scan Side Panel.
40.Carefully slide the Carriage Assembly and Belt Assembly out of the printer (and the Trailing Cable
if you are removing it with the Carriage Assembly).
NOTE: Before you reinstall the Carriage Assembly use an alcohol dampened cloth to remove all
traces of residual adhesive (remaining from the double sided pads removed in step 14) from the
printer before applying new pads in t he same positions as the original pads.
NOTE:When you finish installing or  replacing this...

9.Remove the Encoder Strip (with spring and attachment nut) (refer Encoder Strip (with spring and
attachment nut) on page 231).
10. Remove the Carriage Assembly (with or without Trailing Cable) (refer 
Carriage Assembly (with or
without Trailing Cable) on page 244).
11. Squeeze the left hand clip of the Carriage Rear Bush ing sufficiently to be able to release it from
the Carriage Assembly.
12. Rotate the Carriage Rear Bush ing vertically and remove it from the Carriage Assembly.
NOTE:When you reinstall...

Belt Assembly
Removal
NOTE:Switch off the printer and remove the power cable.
1.Remove the Carriage Asse mbly (with or without Trailing Cable) (refer Carriage Assembly (with or
without Trailing Cable) on page 244.
2. Slide the Belt Assembly out of the a ttachment on the Carriage Assembly.
3.Remove the pulley to release the Belt  Assembly from the Belt Tensioner.
NOTE:There is a spacer between the right end plate and the tensioner.
NOTE:When you finish installing or  replacing this component, you must...