HP Z5200 Owners Manual

5.Remove the Encoder Strip Spring.
NOTE: When you finish installing or  replacing this component, yo u must perform the necessary
Service Calibrations. To find which calibrations you must perform, refer to 
Service Calibration Guide to
Removal and Installation on page 170 .
Trailing Cable
Removal
NOTE: Switch off the printer and remove the power cable.
1.Remove the Left  Cover (refer Left Cover on page 188).
2. Remove the Right Cover (refer 
Right Cover on page 185).
3. Remove the Front Panel (refer...

8.Push the Carriage Assembly into the print path.
9.Unclip the small cover  of the Carriage PCA.
10.Remove the small cover of the Carriage PCA.
238 Chapter 6   Removal and Installation ENWW 

11.Disconnect the two ribbon c ables of the Trailing Cables from the Carriage PCA.
12.Straighten the two ribbon cables of the Trailing Cables and remove the Ferrite Core.
13.Lift up the top trailing cable.
ENWW Trailing Cable 239 

14.Remove the lower part of the trailing cable.
15.Slide the Trailing Cables out of the atta chment clips of the Carriage Assembly.
16.Use a short torx screwdriver to remove the two T- 10 screws that secure the center attachment of
the Trailing Cables.
240 Chapter 6   Removal and Installation ENWW 

17.Unclip the center attachment of the Trailing Cables.
18.Disconnect the two ribb on cables of the Trailing Cables from the Electronics Module.
19.Unroute the Trailing Cables.
ENWW Trailing Cable 241 

20.Unclip and remove the cable  clamp of the Trailing Cables.
21.Unclip and remove the cable  clamp of the Trailing Cables.
22.Unroute the Trailing Cables.
242 Chapter 6   Removal and Installation ENWW 

23.Remove the Trailing Cables from the printer.
Installation
NOTE: When you finish installing or  replacing this component, yo u must perform the necessary
Service Calibrations. To find which calibrations you must perform, refer to 
Service Calibration Guide to
Removal and Installation on page 170 .
NOTE: Make sure you carry out the following actions  during the installation of the Trailing Cable.
1.Use an alcohol (from the Lubrication Kit or Tool Kit) dampened cloth to remove all traces of residual...

3.Make sure that the Ferrite Core is correctly posit ioned so that the small cover of the Carriage PCA
closes correctly to avoid possible friction damag e to the Trailing Cable during operation of the
printer.
Carriage Assembly (with or without Trailing Cable)
Removal
NOTE: Switch off the printer and remove the power cable.
NOTE:If you replace the Carriage Assembly with  service parts Q6683-60231 (24 inch) or
Q6687-60087  (44 inch) that include a Trailing Cable, reme mber to remove the Trailing Cable...

12.Use a short torx screwdriver to remove the two T- 10 screws that secure the center attachment of
the Trailing Cables.
13. Unclip the center attachment of the Trailing Cables.
14.Disconnect the two ribb on cables of the Trailing Cables from the Electronics Module.
ENWW Carriage Assembly (with or without Trailing Cable) 245 

15.Unroute the Trailing Cables.
16.Unclip and remove the cable  clamp of the Trailing Cables.
17.Unclip and remove the cable  clamp of the Trailing Cables.
246 Chapter 6   Removal and Installation ENWW