HP Z5200 Owners Manual
Here you can view all the pages of manual HP Z5200 Owners Manual. The HP manuals for Printer are available online for free. You can easily download all the documents as PDF.
Page 201
8.Remove one T-15 screw that secures the Right Cover to the printer (accessible from within the cartridge bay). 9.Unclip the Right Trim. 10.Remove the Right Cover from the printer. ENWW Right Cover 187
Page 202
Left Cover Removal NOTE:Switch off the printer and remove the power cable. 1.Remove the Front Cover (refer Front Cover on page 177). 2. Open the Left Ink Cartridge Door. 3.Press the clip to release the Left Cover Finishing Panel. 4.Remove the Left Cover Finishing Panel. 188 Chapter 6 Removal and Installation ENWW
Page 203
5.Unclip the spring from the attachment points on the Media Lever and Left Cover. 6.Remove three T-15 screws that secure the Media Lever. 7.Remove all the Ink Cartridges from the Printer. ENWW Left Cover 189
Page 204
8.Carefully push the edge of the Ink Cartridge Blanking Plate to the left. 9.Carefully push the edge of the Ink Cartridge Blanking Plate to the left. 10.Lift the right edge of the Ink Cartridge Blanking Plate. 190 Chapter 6 Removal and Installation ENWW
Page 205
11.Remove the Ink Cartridge Blanking Plate from the Printer. 12.Use a flat bladed screwdriver to unclip the two attachment clips of the Formatter Housing. 13.Lift the Formatter Housing out of the printer. ENWW Left Cover 191
Page 206
14.Remove one T-15 screw that secures the Left Cover (top rear, accessible under the Formatter Housing). 15.Remove one T-15 screw that secures the Left Cover (bottom rear). 16.Remove one T-15 screw that secures the Left Cover (bottom rear). 192 Chapter 6 Removal and Installation ENWW
Page 207
17.Remove one T-15 screw that secures the Left Cover (bottom front, accessible under Front Cover). 18.Remove one T-15 screw that secures the Left Cover (top front, accessible Ink Cartridge Door). 19.Unclip the Left Trim. ENWW Left Cover 193
Page 208
20.Remove the Left Cove r from the Printer. Rear Tray Removal NOTE:Switch off the printer and remove the power cable. 1.Open the Rear Tray to approximately 10 degrees less than the fully open position. 2.Lift the Rear Tray vertically enough (approximately 20 mm) to allow the rear attachment lugs to be out of the locked position. 194 Chapter 6 Removal and Installation ENWW
Page 209
3.Carefully slide th e Rear Tray out of the printer. Rear Cover Removal NOTE:Switch off the printer and remove the power cable. 1.Remove the Rear Tray (refer Rear Tray on page 194). 2. Remove the Right Cover (refer Right Cover on page 185). 3. Remove the Left Cover (refer Left Cover on page 188). 4. Remove ten T-15 screws that secure the Rear Cover to the printer. 5.Remove the Rear Cover from the printer. ENWW Rear Cover 195
Page 210
Media Lever Removal NOTE:Switch off the printer and remove the power cable. 1.Open the Ink Cartridge Door. 2.Press the clip to release the Left Cover Finishing Panel. 3.Remove the Left Cover Finishing Panel. 196 Chapter 6 Removal and Installation ENWW