HP Color LaserJet CP6015xh User Manual

stored on a system RAM disk (if one is used). This feature does not impact data that is stored on the
flash-based system boot RAM.
Changing the Secure Disk Erase mode does not overwrite previous data on the disk, nor does it
immediately perform a full-disk sanitization. Changing the Secure Disk Erase mode changes how the
product cleans up temporary data for jobs after the erase mode has been changed.
Additional Information
For additional information about the HP Secure Disk Erase feature, see the HP...

Set the real-time clock
Use the real-time clock feature to set the date and time settings. The date and time information is
attached to stored print, so you can identify the most recent versions.
Set the real-time clock
Set the date1.Press Menu.
2.Press the down arrow 
 to highlight CONFIGURE DEVICE, and then press the
checkmark button 
.
3.Press the down arrow 
 to highlight SYSTEM SETUP, and then press the checkmark
button .
4.Press the checkmark button 
 to select DATE/TIME.
5.Press the down arrow...

5.Press the down arrow  to highlight TIME FORMAT, and then press the checkmark
button 
.
6.Select the appropriate TIME FORMAT, and then press the checkmark button 
 to
save.
ENWWSet the real-time clock 149
 

Manage supplies
Use genuine HP print cartridges for the best printing results.
Print-cartridge storage
Do not remove the print cartridge from its package until you are ready to use it.
CAUTION:To prevent damage to the print cartridge, do not expose it to light for more than a few
minutes.
HP policy on non-HP print cartridges
Hewlett-Packard Company cannot recommend the use of non-HP print cartridges, either new or
remanufactured.
NOTE:Any damage caused by a non-HP print cartridge is not covered under the...

Replace supplies
When you use genuine HP supplies, the product automatically notifies you when supplies are nearly
depleted. The notification to order supplies allows ample time to order new supplies before they need
to be replaced. For more information about ordering supplies, see 
Supplies and accessories
on page 253
Locate supplies
Supplies are identified by their labeling and their blue plastic handles.
The following figure illustrates the location of each supply item.
Figure 11-1  Supply item...

Approximate replacement intervals for supplies
The following table lists the estimated replacement intervals for supplies and the control panel messages
that prompt when to replace each item. Usage conditions and print patterns may cause results to vary.
ItemPrinter messagePage countApproximate time period
Print cartridgesREPLACE 
CARTRIDGE17,000 pages13 months
Image drumsREPLACE  DRUM35,000 pages1
Image transfer kitREPLACE TRANSFER KIT100,000 pages225 months
Image fuser kitREPLACE FUSER KIT100,000...

Replace print cartridges
1.Grasp the grips on the sides of the front door and pull down to open.
2.Grasp the handle of the used print cartridge and pull out to remove.
3.Store the used print cartridge in a protective bag. Information about recycling used print cartridges
is on the print-cartridge box.
4.Remove additional print cartridges in the same manner.
5.Remove the new print cartridge from its protective bag.
NOTE:Store the protective bag in a secure place for future use.
ENWWReplace supplies 153
 

6.Hold both sides of the cartridge and shake up and down 5-6 times.
7.Align the print cartridge with its slot and insert the print cartridge until it clicks into place.
8.Insert additional print cartridges in the same manner.
9.Grasp the grips on the sides of the front door and lift up to close.
To recycle the used print cartridge, follow the instructions included with the new print cartridge.
Change image drums
When an image drum approaches the end of its useful life, the control panel displays a...

The product uses four colors and has a different image drums for each color: black (K), magenta (M),
cyan (C), and yellow (Y).
Replace an image drum when the control panel displays REPLACE  DRUM message. The
control-panel display also indicates the color that should be replaced (if a genuine HP cartridge is
currently installed). Replacement instructions are included in the image drum box.
NOTE:If toner gets on clothing, wipe it off with a dry cloth and wash the clothes in cold water. Hot
water sets toner...

5.Remove the new image drum from its protective bag.
NOTE:Store protective bag in a secure place for future use.
NOTE:Do not shake the image drum.
NOTE:Do not touch the green cylinder on the bottom of the image drum because it can damage
the drum.
6.Align the image drum with the correct slot and insert the image drum until it clicks into place. The
gray protective cover on the bottom of the drum automatically slides off as the image drum is
inserted. You can discard this cover.
7.Insert additional image...