HP Color LaserJet CP2025dn User Manual

							Software will agree to this EULA. Upon transfer of the HP Software, your license is automatically
terminated.
b. Restrictions. You may not rent, lease or lend the HP Software or Use the HP Software for commercial
timesharing or bureau use. You may not sublicense, assign or otherwise transfer the HP Software except
as expressly provided in this EULA.
5. PROPRIETARY RIGHTS. All intellectual property rights in the Software and User Documentation are
owned by HP or its suppliers and are protected by law, including applicable copyright, trade secret,
patent, and trademark laws. You will not remove any product identification, copyright notice, or
proprietary restriction from the Software.
6. LIMITATION ON REVERSE ENGINEERING. You may not reverse engineer, decompile, or
disassemble the HP Software, except and only to the extent that the right to do so is allowed under
applicable law.
7. CONSENT TO USE OF DATA. HP and its affiliates may collect and use technical information you
provide in relation to (i) your Use of the Software or the HP Product, or (ii) the provision of support
services related to the Software or the HP Product. All such information will be subject to HP’s privacy
policy. HP will not use such information in a form that personally identifies you except to the extent
necessary to enhance your Use or provide support services.
8. LIMITATION OF LIABILITY. Notwithstanding any damages that you might incur, the entire liability of
HP and its suppliers under this EULA and your exclusive remedy under this EULA will be limited to the
greater of the amount actually paid by you for the Product or U.S. $5.00. TO THE MAXIMUM EXTENT
PERMITTED BY APPLICABLE LAW, IN NO EVENT WILL HP OR ITS SUPPLIERS BE LIABLE FOR
ANY SPECIAL, INCIDENTAL, INDIRECT, OR CONSEQUENTIAL DAMAGES (INCLUDING
DAMAGES FOR LOST PROFITS, LOST DATA, BUSINESS INTERRUPTION, PERSONAL INJURY,
OR LOSS OF PRIVACY) RELATED IN ANY WAY TO THE USE OF OR INABILITY TO USE THE
SOFTWARE, EVEN IF HP OR ANY SUPPLIER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH
DAMAGES AND EVEN IF THE ABOVE REMEDY FAILS OF ITS ESSENTIAL PURPOSE. Some states
or other jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply to you.
9. U.S. GOVERNMENT CUSTOMERS. If you are a U.S. Government entity, then consistent with FAR
12.211 and FAR 12.212, Commercial Computer Software, Computer Software Documentation, and
Technical Data for Commercial Items are licensed under the applicable HP commercial license
agreement.
10. COMPLIANCE WITH EXPORT LAWS. You will comply with all laws, rules, and regulations (i)
applicable to the export or import of the Software, or (ii) restricting the Use of the Software, including
any restrictions on nuclear, chemical, or biological weapons proliferation.
11. RESERVATION OF RIGHTS. HP and its suppliers reserve all rights not expressly granted to you
in this EULA.
(c) 2007 Hewlett-Packard Development Company, L.P.
Rev. 11/06
ENWW End User License Agreement 131
 
						

							Customer support
Get telephone support, free during your warranty period, for
your country/region
Have the product name, serial number, date of purchase, and
problem description ready.Country/region phone numbers are on the flyer that was in the
box with your product or at 
www.hp.com/support/.
Get 24-hour Internet supportwww.hp.com/support/ljcp2020series
Get support for products used with a Macintosh computerwww.hp.com/go/macosx
Download software utilities, drivers, and electronic informationwww.hp.com/go/ljcp2020series_software
Order supplies and paperwww.hp.com/go/suresupply
Order genuine HP parts or accessorieswww.hp.com/buy/parts
Order additional HP service or maintenance agreementswww.hp.com/go/carepack
132 Appendix B   Service and support ENWW
 
						

							
Repack the product
If your product needs to be moved or shipped to another location, perform the following procedure to
repack it.
CAUTION: Shipping damage as a result of inadequate pa cking is the customers responsibility. The
product must remain upright during shipment.
Repack the product
CAUTION: It is extremely important  to remove the print cartridges be fore shipping the product. Print
cartridges left in the product during shipping wi ll leak and entirely cover the product with toner.
To prevent damage to the print cartridges, avoid to uching the rollers, and store them in the original
packing material or so that  they are not exposed to light.
1.Remove all four print cartridges and ship separately.
2. Use the original shipping container and packing ma terial, if possible. If you have already disposed
of the packing material, contact  a local mailing service for informat ion about repacking the product.
HP recommends insuring the equipment for shipment.
ENWW Repack the product 133
 
						

							Service information form
WHO IS RETURNING THE EQUIPMENT?Date:
Person to contact:Phone:
Alternate contact:Phone:
Return shipping address:
 
 Special shipping instructions:
WHAT ARE YOU SENDING?
Model name:
Model number:Serial number:
Please attach any relevant printouts. Do NOT ship accessories (manuals, cleaning supplies, and so on) that are not required to complete
the repair.
HAVE YOU REMOVED THE PRINT CARTRIDGES?
You must remove them before shipping the printer, unless a mechanical problem prevents you from doing so.
[  ] Yes.
[  ] No, I cannot remove them.
WHAT NEEDS TO BE DONE? (Attach a separate sheet if necessary.)
1. Describe the conditions of the failure. (What was the failure? What were you doing when the failure occurred? What software were you
running? Is the failure repeatable?)
 
2. If the failure is intermittent, how much time elapses between failures?
3. If the unit connected to any of the following, give the manufacturer and model number.
Personal computer:
Modem:Network:
4. Additional comments:
 
HOW WILL YOU PAY FOR THE REPAIR?
[  ] Under warranty
Purchase/received date:
(Attach proof of purchase or receiving document with original received date.)
[  ] Maintenance contract number:
[  ] Purchase order number:
Except for contract and warranty service, a purchase order number and/or authorized signature must accompany any request for
service. If standard repair prices do not apply, a minimum purchase order is required. Standard repair prices can be obtained by contacting
an HP-authorized repair center.
Authorized signature:
Phone:
Billing address:
 
 Special billing instructions:
134 Appendix B   Service and support ENWW
 
						

							C Specifications
●Physical specifications
●
Electrical specifications
●
Acoustic emissions
●
Environmental specifications
ENWW135
 
						

							Physical specifications
Table C-1  Physical specifications
ProductHeightDepthWidthWeight
Non-duplexing model322 mm (12.7 inches)454 mm (17.9 inches)405 mm (15.9 inches)19.90 kg (43.78 lb)
Duplexing model 322 mm (12.7 inches) 484 mm (19.1 inches) 400 mm (15.7 inches) 21.10 kg (46.42 lb)
136 Appendix C   Specifications ENWW
 
						

							
Electrical specifications
WARNING!Power requirements are based on the country/r egion where the product is sold. Do not
convert operating voltages. This may damage  the product and void the product warranty.
Table C-2  Electrical specifications
Item110-volt models220-volt models
Power requirements100 to 127 V (+/-10%)
50 to 60 Hz (+/-2 Hz)220 to 240 V (+/-10%)
50 to 60 Hz (+/-2 Hz)
Minimum recommended circui t capacity 6.0 A 3.0 A
Table C-3  Power consumption (average, in watts)1,4
Product ModelPrinting (21 PPM)2,3Ready2Sleep2Off2
HP Color LaserJet CP2020
Series Printer 260 13 3.8 0.0
1Values are based on preliminary data, see www.hp.com/support/ljcp2020series  for current information.2The power consumption reflects the hi ghest values measured for color and monoc hrome printing when using all standard
voltages.
3HP Color LaserJet CP2020 Series print speed is 21 pages per  minute (ppm) on letter-size media and 20 ppm on A4-size
media in black-and-white or color.
4Maximum heat dissipation for all models in Ready mode = 41 BTU/Hour.
ENWW Electrical specifications 137
 
						

							Acoustic emissions
Table C-4  HP Color LaserJet CP2020 Series1,2
Sound power levelDeclared per ISO 9296
Printing (21 ppm)3LWAd = 6.4 Bels (A) [64dB (A)]
ReadyLWAd = Inaudible
Sound pressure level: bystander positionDeclared per ISO 9296
Printing (20 ppm)3LpAm = 67 dB (A)
Ready LpAm = Inaudible
1Values are based on preliminary data, see www.hp.com/support/ljcp2020series for current information.2Configuration tested: HP Color LaserJet CP2020 Series monochrome simplex printing.3HP Color LaserJet CP2020 Series speed is 21/20 ppm for color printing and 21/20 ppm for monochrome printing (Letter/A4
size).
Environmental specifications
Table C-5  Operating-environment specifications
EnvironmentRecommendedAllowed
Temperature15° to 27°C (59° to 80.6°F)10° to 30°C (50° to 86°F)
Humidity20% to 60% relative humidity (RH)10% to 80% RH
Altitude Not applicable 0 to 3048 m (0 to 10,000 ft)
NOTE:These values are based on preliminary data. See www.hp.com/support/ljcp2020series for
current information.
138 Appendix C   Specifications ENWW
 
						

							D Regulatory information
●FCC regulations
●
Environmental product stewardship program
●
Declaration of conformity
●
Country/region specific statements
ENWW139
 
						

							FCC regulations
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio
frequency energy. If this equipment is not installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
●Reorient or relocate the receiving antenna.
●Increase separation between equipment and receiver.
●Connect equipment to an outlet on a circuit different from that to which the receiver is located.
●Consult your dealer or an experienced radio/TV technician.
NOTE:Any changes or modifications to the printer that are not expressly approved by HP could void
the user’s authority to operate this equipment.
Use of a shielded interface cable is required to comply with the Class B limits of Part 15 of FCC rules.
140 Appendix D   Regulatory information ENWW