HP C4280 User Manual

To replace the print cartridges
1.Make sure the HP All-in-One is on.
CAUTION: If the HP All-in-One is off when you open the print cartridge door to
access the print cartridges, the HP All-in-One will not release the cartridges for
changing. You might damage the HP All-in-One if the print cartridges are not
docked safely when you  try to remove them.
2.Make sure you have letter or A4 unused plain white paper loaded in the input tray.
3. Open the print cartridge door.
The print carriage moves to the far...

7.Remove the new print cartridge from its packaging and, being careful to touch only
the black plastic, gently remove the plastic tape by using the pink pull tab.
1Copper-colored contacts
2Plastic tape with pink pull tab (must be removed before installing)
3Ink nozzles under tape
CAUTION: Do not touch the copper-colored contacts or ink nozzles. Touching
these parts can result in clogs, ink failure, and bad electrical connections.
8. Slide the new print cartridge forward into the empty slot. Then gently...

9.Close the print cartridge door.
If you installed a new print cartridge, the HP All-in-One prints a print cartridge
alignment page.
10. When prompted, ensure plain white paper is loaded in the input tray, then press the
button next to  OK.
NOTE: If you have colored paper loaded in the input tray when you align the print
cartridges, the alignment will fail. Load unused plain white paper into the input
tray, and then try the alignment again.
11. Place the page print side down on the scanner glass and...

One came with a print cartridge protector, you can use an airtight plastic container to
protect your print cartridge.
NOTE:If you use a plastic container, make sure the ink nozzles on the print cartridge
do not touch the plastic.
The print cartridge protector is designed to keep a print cartridge secure and prevent it
from drying out when it is not being used. Whenever you remove a print cartridge from
the HP All-in-One with the intention of using it again later, store it in the print cartridge...

NOTE:If you remove and reinstall the same print cartridge, the HP All-in-One will
not prompt you to align the print cartridges. The HP All-in-One remembers the
alignment values for that print cartridge, so you do not need to realign the print
cartridges.
To align newly installed print cartridges
1. When prompted, ensure plain white letter or A4 paper is loaded in the input tray, then
press the button next to  OK.
NOTE: If you have colored paper loaded in the input tray when you align the print...

To clean the print cartridges from the HP Photosmart Software
1.Load letter, A4, or legal unused plain white paper into the input tray.
2. In the HP Solution Center, click  Settings, point to  Print Settings , and then click
Printer Toolbox .
NOTE:You can also open the  Printer Toolbox from the Print Properties  dialog
box. In the  Print Properties  dialog box, click the  Services tab, and then click
Service this device .
The Printer Toolbox  appears.
3. Click the  Device Services  tab.
4. Click  Clean...

3.Lightly press down on the print cartridge to release it, and then pull it toward you out
of the slot.
NOTE: Do not remove both print cartridges at the same time. Remove and clean
each print cartridge one at a time. Do not leave a print cartridge outside the HP All-
in-One for more  than 30 minutes.
4.Inspect the print cartridge contacts for ink and debris buildup.
5. Dip a clean foam rubber swab or lint-free cloth into distilled water, and squeeze any
excess water from it.
6. Hold the print cartridge...

NOTE:Clean the area around the ink nozzles only if you continue to see streaks
and smudges on your printed pages after you have already cleaned the print
cartridges by using the software you installed with the HP All-in-One.
Make sure you have the following materials available:
• Dry foam rubber swabs, lint-free cloth, or any soft material that will not come apart or
leave fibers.
TIP: Coffee filters are lint-free and work well for cleaning print cartridges.
•Distilled, filtered, or bottled water (tap...

8.Repeat if necessary for the other print cartridge.
9. Gently close the print cartridge door and plug the power cord into the back of the
HP All-in-One.
Related topics
“
Clean the print cartridges” on page 72
Remove ink from your skin and clothing
Follow these instructions to remove ink from your skin and clothing:
SurfaceRemedy
SkinWash the area with an abrasive soap.
White fabricWash the fabric in  cold water and use chlorine bleach.
Color fabricWash the fabric in  cold water and use sudsy ammonia....

12 Shop for printing supplies
You can order HP products, such as recommended types of paper and print cartridges,
online from the HP Web site.
This section contains the following topics:
•
Order paper or other media
•
Order print cartridges
•
Order other supplies
Order paper or other media
To order HP papers and other supplies, such as HP Premium Photo Papers or HP All-
in-One Paper, go to 
www.hp.com/buy/supplies . If prompted, choose your country/region,
follow the prompts to select your product, and...