GTE Omni Si Database Technical Practices Manual

TL-130400-1001Record Code AQ:17.4 Record Code AQ, Figure 17.4, provides a list of parameters
Data Systemapplied to the remote end of a data call. These parameters
Asynchronous Porttemporarily override the pre-existing parameters of the remote
Set/Read Listend of a data call while a data call is connected to/from the port
specified on this record code. This allows the port specified in
this record code to control the configuration of its call partner on
both incoming and outgoing data calls. The remote...

TL-130400-1001
Table 17.4
Entry Fields for Record Code AQCOL.COL.VALID
NO.
NAMEENTRIESCOMMENTS
12PEC0 = PEC number
This field determines the location of the port.
.~.What PEC is this card located in?
13.r GroupA-D = group
Which group (A, B, C, or D) within the PEC is
numberthis card?
14-15Card Slot00-l 0 = slotnumberWhich card slot within the group is this card?
16Circuit NumberO-7 = assignedWhich circuit on the card is being used?
circuit number
17-19Escape fromO-l 27Data TransferAssign the ASCII...

TL-130400-1001Table 17.4Entry Fields for Record Code AQ (Continued)COMMENTS
device to begin transmission of a packet.
0 = user cannot initate data forwarding
1 = alphanumericcharacters
(A-Z,a-z,O-128 = number4 = characters
ESC,BEL,ENQ, ACK
8 = characters
16 = characters
32 = characters
64 = a character inserted by the user in text
column 0 or 1, which is not any of the
characters listed in O-32 above
Indicate the allowed intervals between the user
input characters.
l-255 = number-This field specifies the...

TL-130400-1001
Table 17.4
Entry Fields for Record Code AQ (Continued)COL.COL.VALID
NO.NAMEENTRIESCOMMENTS
27Ancillary Device0 = disables flow-The PAD sends a control-S, signaling the
(cont’d) Flow Control
controldevice to stop transmission to the PAD.
1 = enables flow
Should the device continue to transmit and%.
controloverrun the buffer, data will be lost. When the
PAD becomes unblocked, it transmits a
control-Q. Transmission of this character
continues until the device starts sending data.
. .The PAD...

TL-130400-1001CQL.NO.
Table 17.4Entry Fields for Record Code AQ (Continued)
COL.VALID
NAMEENTRIESCOMMENTS
32-34Line Width
0 = functionAssign the the number of output characters to
performedbe printed per line at the user device.
.=.automatically-This parameter sets the default value of line
l-255 = number
. . .folding. This determines the number of
of characters percharacters to transmit before an automatic
linecarriage return/line feed is sent. This causes
long lines to fold or wrap to the next line....

TL-130400-1001Table 17.4Entry Fields for Record Code AQ (Continued)COMMENTS
5= combination of (1) and (4)
6= insert line feed after each carriage return
sent from the user terminal as data, plus to the
user terminal as an echo
7= combination of (1) and (6)
-This field will usually be set to 0 or 1. If the
user’s terminal is double spacing lines, this
field should be changed to 0. If the user’s
terminal is overprintinglines, this field should
-This parameter sets thedefault value
ofline
feed padding. It...