Ford F 750 Owners Manual
Have a look at the manual Ford F 750 Owners Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 41 Ford manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Headlamp Flasher Pull the lever toward you to flash the headlamps and release the lever to switch the headlamps off. INSTRUMENT LIGHTING DIMMER Use to adjust the brightness of the instrument panel and all applicable lit components in the vehicle during headlamp and parking lamp operation. • Tap the top or bottom of the control to brighten or dim all interior lit components incrementally. • Press and hold at the first position of the top or bottom of the control until you reach the desired lighting level. DAYTIME RUNNING LAMPS (If Equipped) WARNING Always remember to switch your headlamps on in low light situations or during inclement weather. The system does not activate the tail lamps and may not provide adequate lighting during these conditions. Failure to activate your headlamps under these conditions may result in a collision. The system turns on the headlamps with a reduced output in daylight conditions. To switch the system on: 1. Switch on the ignition. 2. Switch the lighting control to the off or parking lamp position. DIRECTION INDICATORS • To operate the left direction indicator, push the lever down. • To operate the right direction indicator, push the lever up. • To cancel direction indicator operation manually, push the lever again in the opposite direction. 48 F-650/750 (TBC) , enUSA, First Printing LightingE163268 E163270 E163272
If your vehicle is a tractor, the direction indicators may not shut off when you complete a turn. This is normal. Contact an authorized dealer if there are any questions about your vehicle ’s options. INTERIOR LAMPS Map Lamps The map lamps are located on the overhead console. Press the controls on either side of each map lamp to switch on the lamps. The map lamps also light when: • You open any door. • You press any of the remote entry controls when the ignition is off. Dome and Map Lamps Press the switches on either side of the dome lamp to switch on the lamps. The map lamps also light when: • You open any door. • You press any of the remote entry controls when the ignition is off. 49 F-650/750 (TBC) , enUSA, First Printing LightingE163273 E163274
POWER WINDOWS (If Equipped) WARNINGS Do not leave children unattended in your vehicle and do not let them play with the power windows. They may seriously injure themselves. When closing the power windows, you should verify they are free of obstructions and make sure that children and pets are not in the proximity of the window openings. Note: You may hear a pulsing noise when just one of the windows is open. Lower the opposite window slightly to reduce this noise. Press the switch to open the window. Lift the switch to close the window. One-Touch Up or Down (If Equipped) Press or lift the switch fully and release it. Press or lift it again to stop the window. Note: The window may disable for up to five minutes if you cycle it up and down repeatedly. This helps prevent damage to the motor. Normal operation resumes once the motor cools. Restoring the One-Touch Up Function You may lose the one-touch function if the vehicle battery is low. Note: Perform one-touch up re-calibration with the door closed. Calibrating with the door open causes the window to bounce back continuously. To reset the function after the battery recharges: 1. Pull the switch all the way up. 2. Hold the switch until the glass stops and continue to hold for two seconds. 3. Press the switch down and operate the window to the full down position. One-touch up is now functional. Bounce-Back (If Equipped) The window stops automatically while closing. It reverses some distance if there is an obstacle in the way. Overriding the Bounce-Back Feature WARNING When you override the bounce-back feature, the window will not reverse if it detects an obstacle. Take care when closing the windows to avoid personal injury or damage to your vehicle. Pull up the window switch and hold within two seconds of the window reaching the bounce-back position. The window travels up with no bounce-back protection. The window stops if you release the switch before the window closes fully. Window Lock (If Equipped) Press the control to lock or unlock the rear window controls. 50 F-650/750 (TBC) , enUSA, First Printing Windows and MirrorsE163056
EXTERIOR MIRRORS Auxiliary Convex Mirrors Convex mirrors are a ball-stud design for precise adjustment to maximize viewing area. Power Exterior Mirrors (If Equipped) WARNING Do not adjust the mirrors when your vehicle is moving. Left –hand mirror. A Off.B Right–hand mirror. C To adjust a mirror: 1. Rotate the control to select the mirror you want to adjust. 2. Adjust the position of the mirror. 3. Return the control to the center position to lock mirrors in place. Foldaway Exterior Mirrors For tight parking conditions, you can push the mirror toward the door window glass. Before driving, make sure that you fully engage the mirror in its support when returning it to its original position. Power–Folding Mirrors (If Equipped) 1. Rotate the control so the dots line up. 2. Pull the control back to fold the mirrors in or out. 51 F-650/750 (TBC) , enUSA, First Printing Windows and MirrorsE208233 E163059 B AC E163060
Note: If you repeatedly fold and unfold the mirrors several times within one minute, the system may disable to protect the motors from overheating. It resets to normal function automatically within three to five minutes. You can also fold a mirror manually by pushing it toward the door window glass. After you manually adjust the mirror, you need to reset it. To reset the power –folding mirror system and return it to its normal function: • Fold the mirror manually by pushing it toward the door window glass. • Use the power –fold control to fold and unfold the mirror two or three times. The mirror makes a sound as it resets. Heated Exterior Mirrors (If Equipped) See Heated Exterior Mirrors (page 72). Signal Indicator Mirrors (If Equipped) The outer portion of the appropriate mirror housing blinks when you use the direction indicator. Clearance Lamps (If Equipped) The lower, outer part of the mirror housings light when you switch on the headlamps or parking lamps. Telescoping Mirrors (If Equipped) This feature lets you extend the mirror about 3 in (76 mm). It is useful when towing a trailer. You can manually pull out or push in the mirrors to the desired position. PowerScope ™ Power Telescoping Mirrors (If Equipped) This feature lets you position both mirrors in or out at the same time. The control is on the door trim panel. Telescope out. A Telescope in. B 52 F-650/750 (TBC) , enUSA, First Printing Windows and MirrorsE163061 E163062BA
To adjust the mirrors: • Press and hold the control. • When you position the mirrors in or out, the motors run as long as you hold the control. The running motors allow you to make adjustments as needed. • After positioning the mirrors, return the control to the center position to help protect the motors from overheating. INTERIOR MIRROR (If Equipped) WARNING Do not adjust the mirror when your vehicle is moving. Note: Do not clean the housing or glass of any mirror with harsh abrasives, fuel or other petroleum or ammonia-based cleaning products You can adjust the interior mirror to your preference. Some mirrors also have a second pivot point. This lets you move the mirror head up or down and from side to side. Pull the tab below the mirror toward you to reduce glare at night. SUN VISORS Slide-on-rod (If Equipped) Rotate the sun visor toward the side window and extend it rearward for extra shade. 53 F-650/750 (TBC) , enUSA, First Printing Windows and MirrorsE138666
GAUGES Gasoline Engines Engine oil pressure gauge. A Engine coolant temperature gauge. B Transmission fluid temperature gauge. C Fuel gauge. D Speedometer. E Information display. F Tachometer. G 54 F-650/750 (TBC) , enUSA, First Printing Instrument ClusterE215247
Engine Oil Pressure Gauge Indicates engine oil pressure. The needle should stay in the normal operating range (between L and H). If the needle falls below the normal range, stop the vehicle, switch off the engine and check the engine oil level. Add oil if needed. If the oil level is correct, have your vehicle checked by an authorized dealer. Engine Coolant Temperature Gauge WARNING Never remove the coolant reservoir cap while the engine is running or hot. Indicates engine coolant temperature. At normal operating temperature, the level indicator is in the normal range. If the engine coolant temperature exceeds the normal range, stop the vehicle as soon as safely possible, switch off the engine and let the engine cool. Transmission Fluid Temperature Gauge Indicates transmission fluid temperature. At normal operating temperature, the level indicator is in the normal range. If the transmission fluid temperature exceeds the normal range, stop the vehicle as soon as safely possible and verify the airflow is not restricted such as snow or debris blocking airflow through the grille. Special operating conditions, such as snowplowing, towing or off-road use, can cause higher than normal operating temperatures. See Special Operating Conditions Scheduled Maintenance (page 328). Operating the transmission for extended periods with the gauge in the higher than normal area may cause internal transmission damage. We recommend altering the severity of the driving conditions to lower the transmission temperature into the normal range. If the gauge continues to show high temperatures, contact an authorized dealer. Fuel Gauge Note: The fuel gauge may vary slightly when your vehicle is moving or on a gradient. Switch the ignition on. The fuel gauge indicates approximately how much fuel is in the fuel tank. The arrow adjacent to the fuel pump symbol indicates on which side of your vehicle the fuel filler door is located. The needle should move toward F when you refuel your vehicle. If the needle points to E after adding fuel, this indicates your vehicle needs service soon. After refueling, some variability in needle position is normal: • It may take a short time for the needle to reach F after leaving the gas station. This is normal and depends upon the slope of pavement at the gas station. • The fuel amount dispensed into the tank is a little less or more than the gauge indicated. This is normal and depends upon the slope of pavement at the gas station. • If the gas station nozzle shuts off before the tank is full, try a different gas pump nozzle. Gauge Package (If Equipped) If your vehicle is equipped with the optional gauge package, it has some or all of the following gauges: 55 F-650/750 (TBC) , enUSA, First Printing Instrument Cluster
• Transmission temperature gauge: Displays the transmission fluid temperature at the transmission sump. • Hourmeter: Displays the hours of engine run time. • Voltmeter: Displays electrical system voltage. Information Display Odometer Located in the bottom of the information display. Registers the accumulated distance your vehicle has traveled. Trip Computer See General Information (page 62). Vehicle Settings and Personalization See General Information (page 62). Diesel Engines Engine oil pressure gauge. A Engine coolant temperature gauge. B Diesel Exhaust Fluid (DEF) gauge. C 56 F-650/750 (TBC) , enUSA, First Printing Instrument ClusterE207382
Fuel gauge. D Speedometer. E Information display. F Tachometer. G Engine Oil Pressure Gauge Indicates engine oil pressure. The needle should stay in the normal operating range (between L and H). If the needle falls below the normal range, stop the vehicle, switch off the engine and check the engine oil level. Add oil if needed. If the oil level is correct, have your vehicle checked by an authorized dealer. Engine Coolant Temperature Gauge WARNING Never remove the coolant reservoir cap while the engine is running or hot. Indicates engine coolant temperature. At normal operating temperature, the level indicator is in the normal range. If the engine coolant temperature exceeds the normal range, stop the vehicle as soon as safely possible, switch off the engine and let the engine cool. Diesel Exhaust Fluid (DEF) Gauge Indicates the fluid level in the DEF tank. Fuel Gauge Note: The fuel gauge may vary slightly when your vehicle is moving or on a gradient. Switch the ignition on. The fuel gauge indicates approximately how much fuel is in the fuel tank. The arrow adjacent to the fuel pump symbol indicates on which side of your vehicle the fuel filler door is located. The needle should move toward F when you refuel your vehicle. If the needle points to E after adding fuel, this indicates your vehicle needs service soon. After refueling, some variability in needle position is normal: • It may take a short time for the needle to reach F after leaving the gas station. This is normal and depends upon the slope of pavement at the gas station. • The fuel amount dispensed into the tank is a little less or more than the gauge indicated. This is normal and depends upon the slope of pavement at the gas station. • If the gas station nozzle shuts off before the tank is full, try a different gas pump nozzle. Gauge Package (If Equipped) If your vehicle is equipped with the optional gauge package, it has some or all of the following gauges: • Transmission temperature gauge: Displays the transmission fluid temperature at the transmission sump. • Hourmeter: Displays the hours of engine run time. • Voltmeter: Displays electrical system voltage. Information Display Odometer Located in the bottom of the information display. Registers the accumulated distance your vehicle has traveled. 57 F-650/750 (TBC) , enUSA, First Printing Instrument Cluster