Canon Lbp 3000 User Guide

							Printing on Index Card2-32
Loading and Delivering Paper
2
3Set the [Output Size] setting to [Index Card] as necessary.
Leave the setting set to [Match Page Size] when the page size and the size of 
the paper loaded in the multi-purpose tray are the same, since there is no need 
to change the setting.
IMPORTANT
If the [Page Size] and [Output Size] settings are different, the printer produces an 
enlarged or reduced print automatically.
4Click [OK] to close the Properties dialog box.
 
						

							Printing on Index Card2-33
Loading and Delivering Paper
2
5Click [OK] to start printing.
 
						

							Printing on Envelopes2-34
Loading and Delivering Paper
2
Printing on Envelopes
This section describes how to print to envelopes.
Loading Envelopes
Envelopes can be loaded into either the multi-purpose tray or the manual feed tray. 
You can only load one envelope at a time, regardless of whether you use the 
multi-purpose tray or the manual feed tray.
If you are printing a single sheet of paper that is different from the paper already 
loaded in the multi-purpose tray, load the paper in the manual feed tray.
IMPORTANT
•When you are printing from the multi-purpose tray, make sure that there is no paper in 
the manual feed tray. If there is any paper in the manual feed tray, paper will feed from the 
manual feed tray because manual feed tray has priority over the multi-purpose tray.
•Do not load paper into the manual feed tray while the printer is printing from the 
multi-purpose tray. The paper loaded in the manual feed tray will feed into the printer, 
causing overlapping paper feeds and paper jams.
•Printing speed drops when printing on envelopes.
•The envelopes that can be used with this printer are as follows:
*Envelopes with a flap on the short edge cannot be used.
Envelope DL110.0 mm x 220.0 mm
(4.33 inch x 8.66 inch)Envelope Monarch98.4 mm x 190.5 mm
(3.88 inch x 7.50 inch)
Envelope COM10104.9 mm x 241.3 mm
(4.13 inch x 9.50 inch)Envelope C5162.0 mm x 229.0 mm
(6.38 inch x 9.02 inch)
 
						

							Printing on Envelopes2-35
Loading and Delivering Paper
2
•The following envelopes cannot be used with this printer. Using any of these envelopes 
may result in paper jams that are difficult to clear or may cause damage to the printer.
-Envelopes with fasteners or snaps
-Envelopes with address windows
-Envelopes with adhesive on the surface
-Wrinkled or creased envelopes
-Poorly manufactured envelopes in which the glued parts are uneven
-Irregularly-shaped envelopes
•Before loading the envelopes, push down on the stack of envelopes to release any 
remaining air, and press down firmly along the folded edges of the envelopes.
•Do not print on the reverse side (glued side) of envelopes.
NOTE
When printing envelopes, the envelopes may become creased.
Loading Envelopes into the Multi-Purpose Tray
Use the following procedure to load envelopes into the multi-purpose tray.
Always load envelopes lengthways into the multi-purpose tray.
IMPORTANT
•You can only load a single envelope in the manual feed tray.
•Do not touch or pull envelopes out of the multi-purpose tray during printing. Doing so may 
cause the printer to malfunction.
1Open the tray cover up to the position where it stops a, and 
then pull out the rear paper guide 
b.
a
b
 
						

							Printing on Envelopes2-36
Loading and Delivering Paper
2
2Push the side paper guides out a little wider than the actual 
width of the paper.
3Load the envelopes with the printing surface facing up and 
the flaps closed and on the left side, then gently insert them 
all the way to the back of the tray.
Make sure that the envelopes passes under the paper limit guides.
CAUTION
When loading envelopes, be careful not to cut your hands with the edges 
of the envelopes.
IMPORTANT
•You cannot print on the reverse side (glued side) of envelopes.
•Load the stack of envelopes straight.
•If the leading edges of the envelopes are curled or folded at the corners, flatten 
them out before loading.
Paper Limit Guide
 
						

							Printing on Envelopes2-37
Loading and Delivering Paper
2
NOTE
When you are printing on envelopes, load the envelopes with the paper surface 
(the side you want to print on) facing up, and the envelope flap on the left side.
4Slide the paper guides to meet both sides of the envelopes.
IMPORTANT
Always make sure the paper guides match the width of the paper. If the paper 
guides are too loose or too tight, the paper will not feed properly and this will cause 
paper jams.
 
						

							Printing on Envelopes2-38
Loading and Delivering Paper
2
5Adjust the rear paper guide to match the paper a, and close 
the tray cover 
b.
IMPORTANT
If you run out of envelopes and then refill the paper tray, the Paper Indicator will 
flash. Press the   (Paper Key) to resume printing.
Loading Envelopes into the Manual Feed Tray
Use the following procedure to load envelopes into the manual feed tray.
Always load envelopes lengthways into the manual feed tray.
IMPORTANT
•You can only load a single envelope in the manual feed tray.
•You cannot print from the manual feed tray if the printer settings are set to multiple copies 
or multiple pages. If you start a print job set for multiple copies or multiple pages, the 
second and subsequent sheets will feed from the multi-purpose tray regardless of the 
paper size and paper type.
•Do not touch or pull envelopes out of the manual feed tray during printing. Doing so may 
cause the printer to malfunction.
a
b
 
						

							Printing on Envelopes2-39
Loading and Delivering Paper
2
1Push the side paper guides out a little wider than the actual 
width of the paper.
2Load the envelope with the printing surface facing up and the 
flaps closed and on the left side, then gently insert them all 
the way to the back of the tray.
Be sure that the envelope passes beneath the paper limit guides.
CAUTION
When loading envelope, be careful not to cut your hands with the edges of 
the envelope.
IMPORTANT
•You cannot print on the reverse side (glued side) of envelope.
•Load the envelope straight.
•If the leading edge of the envelope is curled or folded at the corners, flatten it out 
before loading.
Paper Limit Guide
 
						

							Printing on Envelopes2-40
Loading and Delivering Paper
2
NOTE
When you are printing on envelopes, load the envelopes with the paper surface 
(the side you want to print on) facing up, and the envelope flap on the left side.
3Slide the paper guides to meet both sides of the envelope.
IMPORTANT
•If you run out of envelopes and then refill the paper tray, the Paper Indicator will 
flash. Press the   (Paper Key) to resume printing.
•Always make sure the paper guides match the width of the envelope. If the paper 
guides are too loose or too tight, the envelope will not feed properly and this will 
cause paper jams.
 
						

							Printing on Envelopes2-41
Loading and Delivering Paper
2
Selecting Printer Driver Settings and Printing
This section describes how to set the printer driver settings.
1Select [Print] from the [File] menu in the application. Select 
the name of your printer from the [Name] or [Printer Name] 
field and click [Properties].
The [Properties] dialog box for the printer is displayed.