Brother Hl 3260n User Manual

CHAPTER 5 MAINTENANCE
5-3
! Replacing the Toner bottle
✒
✒✒ ✒  Note
•  If the “Toner empty” message does not disappear after replacing
the Toner bottle, follow these instructions:
      - Confirm the printer power is on.
      - Leave the Front cover open for more than 10 seconds.
      - Close the Front cover.
Follow these steps to change the toner bottle:
☛
☛☛ ☛ 1.Open the Front cover.
ZAET010E 
Fig. 5-2
☛
☛☛ ☛ 2.Lift the green handle.
ZAET020E 
Fig. 5-3
☛
☛☛ ☛ 3.While pushing the green lever downwards...

5-4
☛
☛☛ ☛ 4.Release the green lever and then continue to gently slide the Toner holder
out until it stops.
!Caution
• If you continue to push the green lever down while you continue to slide
the Toner holder out, the toner holder may fall out.
Fig. 5-5
☛
☛☛ ☛ 5.Push the Toner bottle backwards slightly  () until you can lift the top of the
bottle upwards () and gently pull out the bottle.
1
2
ZAET040E 
Fig. 5-6
 

CHAPTER 5 MAINTENANCE
5-5
☛
☛☛ ☛ 6.Move the new toner bottle back and forth about 5 – 6 times () and remove
the black cap of the new toner bottle by turning it counterclockwise ().
ZAET030E 
1
2
Fig. 5-7
✒ Note
• Do not remove the inside cap.
• After removing the black cap from the bottle, the toner can scatter easily.
Do not shake or jar the bottle.
☛
☛☛ ☛ 7.Push the Toner bottle into the toner holder () and push the top of the bottle
downwards to lock it in place ().
ZAET040E 
1
2
Fig. 5-8
 

5-6
☛
☛☛ ☛ 8.Slide the toner holder into the printer until it clicks into place, and push down
the green handle.
ZAET022E 
Fig. 5-9
☛
☛☛ ☛ 9.Close the Front cover.
 

CHAPTER 5 MAINTENANCE
5-7
D D
r r
u u
m m
   
u u
n n
i i
t t
! Replacing the Drum unit
If the display shows the following message, the Drum should be changed.
CHANGE DRUM SOON
Warning
•  Do not incinerate the used drum unit. Toner dust might ignite when
exposed to an open flame.
•  Disposal should take place at an authorized dealer or an appropriate
collection site.
•  If you dispose of the used parts yourself, dispose of them according to
local regulations.
☛
☛☛ ☛ 1.Turn off the printer.
ZAEH220E 
Fig....

5-8
☛
☛☛ ☛ 2.If the Duplex unit is installed, open the Duplex unit by lifting the catch.
ZAEP330E 
Fig. 5-11
☛
☛☛ ☛ 3.Open the Right cover of the printer by lifting the catch.
ZAEP271E 
Fig. 5-12
☛
☛☛ ☛ 4.Open the Front cover.
ZAEM320E 
Fig. 5-13
 

CHAPTER 5 MAINTENANCE
5-9
☛
☛☛ ☛ 5.While pressing the green button, slide the Drum unit out until it stops.
ZAEM330E 
Fig. 5-14
☛
☛☛ ☛ 6.Raise the green carrying handle and slide the Drum unit out.
ZAEM340E 
Fig. 5-15
✒ Note
• Do not tilt or drop the removed Drum unit. Moving the unit abruptly can
scatter toner.
• While the Drum unit is removed, do not change the toner.
☛
☛☛ ☛ 7.Take the new drum unit from the box and remove the plastic bag, holding
the Drum unit by the carrying handle.
✒ Note
• Do not...

5-10
☛
☛☛ ☛ 8.Put the Drum unit removed in Step 6 into the plastic bag emptied in Step 7,
keeping the unit at the same angle as when it was installed.  Then, seal the
plastic bag.
☛
☛☛ ☛ 9.Remove the two red sheets from the Drum unit in the order shown in the
illustration. (  )
ZAEM350E 
1
2
Fig. 5-16
✒ Note
• Remove the drum unit keeping the unit parallel to the ground as shown
in the illustration, otherwise the toner in the unit might scatter.
• Do not touch the inside of the unit or the green parts...

CHAPTER 5 MAINTENANCE
5-11
☛
☛☛ ☛ 11.Push the Drum unit into the printer until it clicks into place.
ZAEM370E 
Fig. 5-18
☛
☛☛ ☛ 12.Remove the red sheet from the Drum unit and remove the two pieces of
tape.
ZAEM410E 
Fig. 5-19
☛
☛☛ ☛ 13.Close the right side cover of the printer.
ZAEM310E 
Fig. 5-20
✒ Note
If the Right side cover of the printer cannot be closed, it means that the
Drum unit has not been properly installed.  Slide the Drum unit out and push
it into the printer again until it clicks into...

5-12
☛
☛☛ ☛ 14.Close the Front cover.
ZAEM380E 
Fig. 5-21
☛
☛☛ ☛ 15.If the Duplex unit is installed, close the Duplex unit cover.
ZAEP270E 
Fig. 5-22
☛
☛☛ ☛ 16.Turn on the printer.