ATT System 25 Installation And Maintenance Manual

APPENDIX E: Administration Codes and Data
Table E-AE.Pod/Board Type—Specific Representation (Contd)
CATEGORY:DESCRIPTION:DATA:
Voice Station
(Contd)
ATTENDANT VOICE TERMINALS:
Direct Trunk Attendant Console
(34-Button Deluxe or
34-Button Deluxe
Built-in-Speakerphone)309
Switched Loop Attendant Console
(34-Button Built-in-Speakerphone
with 16-Character Display) 
-310
Switched Loop Attendant Console,
Deluxe (34-Button Deluxe
Built-in-Speakerphone with
16-Character Display)311
MET VOICE TERMINALS:
10-Button...

APPENDIX E: Administration Codes and Data
Table E-AE.Port/Board Type—Specific Representation (Contd)
CATEGORY:DESCRIPTION:DATA:
Trunk
(Contd)
Delay Dial-in/Auto-out
1007
Delay Dial-in/Delay Dial-out
1008
Special
Service Circuit ZTN85 (R1V1, R2V2)
1101
Service Circuit Pack ZTN131 (R3)1102
External Alerts
253
First Paging Zone
1301
Second Paging Zone1302
Third Paging Zone
1303
DGC Delay Announcement
255
Music-on-Hold
254
First Selector Console
1601
Second Selector Console1602
First Directed Night Service...

APPENDIX E:
Table
For Action=1,Administration Codes and Data
E-K Save/Restore and System Restarts (Menu=9)
you need to press the PLAY and RECORD buttons.
For Action=2 and Action=3, you need to press the PLAY button.
 ACTIONDESCRIPTIONDATA
1Save (Backup) translations[1 to run]
2Verify translations[1 to run]
3Restore translations[1 to run]
10
Force a system warm start.FOR[1 to run]
QUALIFIED SYSTEMS TECHNICIAN
ONLY
20
Force a system cold start.FOR [1 for Full
QUALIFIED SYSTEMS TECHNICIAN
Default, 2 for...

APPENDIX E: Administration Codes and Data
Table E-AG.RS232 Port Administration (Menu=10)
In response to RS232=,enter the RS232 connector (1-5*) to be
administered.
ACTIONDESCRIPTIONDATA
1Reassign RS232 connector capability[0 to disconnect
port or see
footnote † for
options and
defaults]
2For Ports 1-4 ONLY*: Change the[0-2;0]
RETURN delay
3For Ports 1-4 ONLY*: Change the[300, 1200,
baud rate4800, 9600
See footnote †
for defaults]
lPorts 1-4 are the RS232 connectors off the Call Processor. Port 5 is a...

APPENDIX E: Administration Codes and Data
Table E-AH.Automatic Route Selection Administration (Menu=1)
ACTIONDESCRIPTIONDATA
100Assign a pattern number[1-8]
101
Assign a start time for subpattern 1 A in[HHMM]
the form HOUR, MINUTES (HHMM)
102
Assign a stop time for subpattern 1A[HHMM]
110Assign Route 1 for subpattern 1A (a
[FAC or VFC]
facility access code [FAC] or virtual
facility code [VFC])
111Assign facility restriction level (FRL O-3)[FRL]
for subpattern 1A, route 1
120Assign Route 2 for subpattern...

APPENDIX E: Administration Codes and Data
Table E-AH. Automatic Route Selection Administration(Menu=11)
(Contd)
ACTIONDESCRIPTIONDATA
230Assign Route 3 for subpattern 1 B (a[FAC or VFC]
facility access code [FAC] or virtual
facility code [VFC])
231Assign facility restriction level (FRL 0-3)[FRL]
for subpattern 1 B, route 3
240Allow subpattern 1 B to overflow to[1/0]
DDD (1=YES,0=NO)
241Assign facility restriction level (0-3) for[FRL]
DDD overflow
300Area Code for which an ARS pattern is[Area Code]
being...

APPENDIX E: Administration Codes and Data
Table E-AH. AutomaticRoute Selection Administration (Menu=11)
(Contd)
ACTIONDESCRIPTlONDATA
601Assign a 7-digit emergency telephone[7-digit number]
number
602Assign a 7-digit emergency telephone[7-digit number]
number
603Assign a 7-digit emergency telephone
[7-digit number]
number
700Enter facility (route) code number
[FAC or VFC]
701Assign associated area code[Associated
area code]
702Specify how many digits to strip from[Number of digits]
the front when the...

APPENDIX E: Administration Codes and Data
Table E-AH.Automatic Route Selection Administration
(Menu=11)
(Contd)
ACTIONDESCRIPTlON
DATA
900
N11 CO exchange for which a pattern[N11 code]
is being assigned (where N=2-8)
901ARS pattern number to route these[1-8 or O if this
N11 callsN11 Code must
be followed by
4 other digits
(N11 -XXXX)]
E-59 

APPENDIX F:
Administration Error Messages
APPENDIX F shows Basic Administration error codes and descriptions. The
Advanced Administration system uses different terminology. For additional
details about an error message in Basic Administration, press the “?” key.
The following table lists and describes error messages that can be displayed at
the SAT while administering the system.
The table also includes possible
solutions for some of the error messages.
AND DESCRIPTIONERROR MESSAGE
POSSIBLE SOLUTION...

APPENDIX F: Administration Error Messages
ERROR MESSAGE
AND DESCRIPTIONPOSSIBLE SOLUTION
1006:incorrect entryCabinet-Slot-Port (CSSPP) PP must
port-on-board number out
be a number from 1 to 8 (varies on
of rangedifferent circuit packs)
1007:incorrect action number
Must administer ACTION = 1 before
can ‘t exceed 1 withproceeding.
unequipped facility
1008:incorrect entryThe entered port is greater than
port-on-board number out
maximum port number on the
of rangeassociated board.
1009:incorrect entryNumber...