ATT System 25 Installation And Maintenance Manual

APPENDIX E: Administration Codes and Data
Table E-B.PORT/PDC Administration,Voice Terminals (Menu=1/2)
(Contd)
ACTIONDESCRIPTION
DATA
100Button to be assigned[button #]
101NEXT[41]
Note: this feature requires the use of a
DISPLAY voice terminal.
100Button to be assigned[button #]
101AGENT STATUS FOR CMS[42]
102Assign button subtype:[0-3]
0 = Monitor
1 = Available (Agent)
2 = After Call Work (Agent)
3 = Logged Out (Agent)
103PDC of station that has the associated[1-9999 or
Monitor button, or 0 if this is...

APPENDIX E: Administration Codes and Data
Table E-C.Voice Terminal Type Codes
If the Terminal Type is:
Code:
SINGLE-LINE VOICE TERMINALS:
Without message waiting indicator201
With message waiting indicator202
MERLIN CS (ATL) VOICE TERMINALS:
5-Button, Z7302H01302
10-Button Hands-Free Answer on Intercom, Z7309H01303
10-Button Built-in-Speakerphone, Z7313H01 A303
ATL Cordless Telephone303
10-Button, Z7303H01304
22-Button Built-in-Speakerphone with Display, Z7314H01 A312
34-Button, Z7305H01
307 or
306...

APPENDIX E: Administration Codes and Data
Table E-D.Feature Button Translation (Menu=1/2)
“Action=100” is required before action(s) 101-104 listed in this table are
administered.
ACTIONNOTESBUTTON TYPEACTIONACTION
101102103
1(1)SYS ACCESS-
ORG
2FACILITYFacility Access
Code
3(1, 11, & 15)PERS LINETrunk Number
Owner?
4EXCLUSION
5MSG WAIT
Signaled PDCSignaled
Button No.
6(1)
COVER MSG
7MANUALSignaled PDC
SIGNAL
8(15)
AUTO ICOMCalled PDCCalled Button
No.
9DATAAssoc. DDC
10(1)
COVER-GRPGroup NumberRinger...

APPENDIX E: Administration Codes and Data
Table E-D. Feature Button Translation (Menu=1/2) (Contd)
Action=100 is required before action(s) 101-104 listed in this table are
administered
‘ Refer to page 10-6 of the Administration Manual.
November 1995
E-15 

APPENDIX E: Administration Codes and Data
NOTES:
A ? mark indicates that a yes/no
If a (No) or (Yes) is present,
response.
1)
2)
3)
4)
5)
6)
7)
8)
9)
1 0)
11)
12)
13)
14)
15)
If Switched Loop Attendant
Switched LOOp Attendant
(1/0) response is required.
this indicates a strongly suggested
Console: NOT ADMINISTRABLE
Console cannot be specified as the
covered PDC (Action 102) for individual call coverage
This code is READ ONLY (can’t be changed)
Direct Trunk or Switched Loop Attendant Console ONLY
If...

APPENDIX E: Administration Codes and Data
Table E-E.Multiline Voice Terminal Button Defaults
7- SYS ACCESS
12- FLEX DSS17- FLEX DSS29- FLEX DSS
8- SYS ACCESS13- ACCT ENTRY
18- FLEX DSS30- FLEX DSS
9- REP DIAL
14- SEND ALL CALLS19- FLEX DSS
31- FLEX DSS
10- REP DIAL
15- FLEX DSS20- FLEX DSS
32- FLEX DSS
11- LAST # DIALED16- FLEX DSS
!21- FLEX DSS I 33- FLEX DSS
22- FLEX DSS34- FLEX DSS
23- FLEX DSS
35- FLEX DSS
24- FLEX DSS36- FLEX DSS
25- FLEX DSS
37- FLEX DSS
26- FLEX DSS
38- FLEX DSS
27- FLEX DSS39-...

APPENDIX E: Administration Codes and Data
Table E-F.Switched Loop Attendant Console Button Defaults (Type
310)
7- LOOP†
8- LOOP†
9- LOOP†
10- LOOP†
11- LOOP†12- ALARM†17- LOCAL†29- SCROLL†
13- POS BUSY18- FLEX DSS30- FORCED RELEASE†
14- FLEX DSS19- FLEX DSS
31- LAST # DIALED
15- SOURCE†
20- FLEX DSS32- FLEX DSS
16- DESTINATION†
21- FLEX DSS33- FLEX DSS
I22- FLEX DSS34- FLEX DSS
23- FLEX DSS35- FLEX DSS
24- FLEX DSS36- FLEX DSS
25- FLEX DSS37- FLEX DSS
26- CANCEL†  38- JOIN†
27- START†39- RELEASE†
28- ATT...

APPENDIX E: Administration Codes and Data
Table E-G.Switched Loop Attendant Console Button Defaults (Type 311 )
7- LOOP†12- ALARM†
17- lNSPECT†  29- SCROLL†
8- LOOP†13- POS BUSY18 - LOCAL†  30- FORCED RELEASE† 
  9- LOOP†14- FLEX DSS19- FLEX DSS   31- LAST # DIALED
10- LOOP†15- SOURCE†20- FLEX DSS   32- FLEX DSS
 11- LOOP†
16- DESTINATION†  21- FLEX 0SS  33- FLEX DSS
  22- FLEX DSS   34- FLEX DSS
 23- FLEX DSS   35- FLEX DSS
24- FLEX DSS36- FLEX DSS
25- FLEX DSS37- FLEX DSS
  26- FLEX DSS   38- ATT MW†...

APPENDIX E: Administration Codes and Data
Table E-H.
Direct Trunk Attendant Console Button Defaults (Cold-Start
Defaults)
7- SYS ACCESS
8- SYS ACCESS
9- REP DIAL
10- REP DIAL
11- LAST # DIALED12- FLEX DSS
  17- Trunk 0001   29- Trunk 0009  
13- ACCT ENTRY18- Trunk 0002
30- Trunk 0010
14- ATT MSG
19- Trunk 0003
31- Trunk 0011
15- NIGHT20- Trunk 0004
32- Trunk 0012
16- ALARM†21- Trunk 0005
33- Trunk 0013
22- Trunk 0006
34- Trunk 0014
23- Trunk 0007
35- Trunk 0015
24- Trunk 0008
36- 
Pool 100
  25-...

APPENDIXE: Administration
Table E-1.Direct Trunk Attendant Console Defaults
Installed Defaults)Codes and Data
(Administration-
7- SYS ACCESS12- FLEX DSS17-029-0
8- SYS ACCESS13- ACCT ENTRY18-030-0
9- REP DIAL14- ATT MSG19-0
31-0
10- REP DIAL15-020-032-0
11- LAST # DIALED
 16- ALARM† 21-0 33-0
  25- COVER GRP  37-0
†Cannot be changed.
E-21