ATT DEFINITY Communications System Generic 3V4 Instructions Manual

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
NOTE:
There is a special case of a switch-classified call
being offered to a split. In this case, the Calling
Party number contains the original digits (from a
switch-classified Third Party Make Call Request)
provided in the destination field.
The Trunk Group number and Trunk Group Member
number are only provided if the Calling Party number is
unavailable.
Called Party
number (DNIS)
For incoming calls over PRI...

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
an ISDN DISCONNECT message; or in an ASAI Route
Select, 3rd Party Make Call, or 3rd Party Auto-Dial.
Flexible BillingSpecifies that the billing rate can be changed for an incoming
900-type call.  Present if the feature is allowed for the call and
the Flexible Billing customer option is assigned to the switch.
Issue 4  September 1995  
3-21 

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Call Originated Event Report (G3V4)
The Call Originated Event Report is sent to notify the adjunct that the originating
extension is attempting to establish a call.  This indication is provided to ASAI
applications monitoring the call through domain control only.  The report provides
the dialed digits.  Link version 2 must be active.  Two instances will not generate
this report: TAC dialing over an ISDN trunk, and...

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Cause[optional] This parameter is not included.
Issue 4  September 1995  
3-23 

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Call Redirected Event Report
The Call Redirected Event Report is sent to notify the adjunct that event
reporting for a call will no longer be provided.  This event report is sent under the
circumstances detailed below.
For Monitored Calls
This event is sent when a monitored call enters a new domain that has Event
Notification active.  For example, if a call leaves one monitored domain and
enters another, a Call...

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Ð An analog phone call is sent to coverage due to ``no answer (the
analog sets call is redirected).
Issue 4  September 1995  
3-25 

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
This event report will not be sent if the Domain (Station) Control is never
alerted or if it retains a simulated bridged appearance until the call is
dropped/disconnected.  Examples of situations when this event is not sent
are:
Bridging
Call forwarding
Calls to a TEG (multifunction set with TEG button)
Cover-All
Coverage/Busy
Incoming PCOL calls (multifunction sets)
Pick-up for multifunction set principals
This...

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Call Transferred Event Report
The Call Transferred Event Report is sent under the following circumstances:
When an on-PBX station completes a transfer by pressing the ``transfer
button on the voice terminal
When the on-PBX analog set (phone) user on a monitored call goes on
hook with one active call and one call on conference/transfer hold
When the ``call park feature is used in conjunction with the ``transfer...

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Party_id List
(up to six
numbers)The party identifier is a number corresponding to a specific
entry number in the Extension List
Extension List
(up to six
entries)The list of all transferred extensions on the call resulting after
the transfer.  It may contain alerting extensions or group
extensions as well as default trunk values (#####) (if the call
contains off-PBX parties).
The extension consists of local...

Event Reporting and U-Abort Capabilitiesbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbbb
Connected Event Report
The Connected Event Report is sent as follows:
When a switch-classified call is delivered to an on-PBX party (after having
been answered at the destination) and the on-PBX party answers the call
(picked up handset or connected after zip tone)
When a call is delivered to an on-PBX party and the on-PBX party has
answered the call (picked up handset or cut-through after zip tone)
When a call is...