Trillium Panther Ii Feature Module Iv System Manual

Panther IT 820/1032/2064-200 
25pair cable  

Trillium Standard Practice 
Incoming C.OJPBX Lines 
Female 
25-Pair CaMe 
25-pair cable 
50-Pin-to-Modular 
Adapter 3 MOD 
v SM 5J2 5&Pin-to-Modular - 
To KSU Jack 
‘Power Fail’ 4-conductor 
Modular-to- 
Modular caMes 
(not supplied) 
To KSU Plug 
Labeled 
co1 1120 
Female 
I I 
I 
Standard 
Telephone 
to Match 
Phone 
Service 
i.e.: Tone 
3 or Rotary 
t OM Phone 
per Line 
NOTE: 
SP 
ca 
su 
wi 
PF If a fine is not being 
connected to a PFT, bridge Ihe 
apprcpriale jade on ‘Adapter 3’ 
directly to the...

Panther II 820/l 032/2064-200 
Station Message Detail Recording Unit Installation 
6.15 
The Station Message Detail Recording (SMDR) unit interfaces a standard 80- 
character serial ASCII printer or serial port on a terminal to the KSU. The printer or 
computer terminal is connected to the SMDR unit using an RS-232 connector. The 
baud rate for the Panther II system is set during system programming, and can be set to 
150,300,600, 1200,2400,4800, or 9600 baud. The preprogrammed baud rate is 
1200 baud....

Panther II 820/1032/2064-200 
Step 2. Plug the KSU power cord into the grounded 110 Vat electrical outlet. 
The status lamp on the KSU flashes. 
Step 3. Set the BATTERY switch (Switch 4) to the ON position. 
(Leave the BATTERY switch in the ON position for memory retention.) 
Step 4. 
Step 5. 
Step 6. 
Step 7. Set the PROGRAM 2 switch to the ON position. 
Press the RESET button. 
Set the PROGRAM 2 switch to the OFF position. 
Press the RESET button. The system is now set with the factory 
preprogrammed...

Trillium Standard Practise 
Note: If the data pair is reversed, the Panther set telephone will not function properly. 
For Peripherals and Optional Equipment: 
Use the procedures outlined in Panther II 820/1032l2064-320, Maintenance and 
Troubleshooting 
to perform a system check on peripherals and options such as Station ’ 
Message Detail Recording. 
Installation and Commissioning 
Page 38  

Panther II 820/1032/2064-200 
Important Notice 
Warning 
The Panther II Electronic Key Telephone System generates and uses radio frequency energy and if not 
installed and used in strict accordance with the manufacturer’s instructions, may cause interference to 
radio communications. It has been tested and found to comply with the limits for a Class A 
computing device in accordance with the specifications in Subpart J of Part 15 of FCC Rules which are 
designed to provide reasonable protection against...

TriIIium Standard Practice 
Service Requirements 
In the event of equipment malfunction, all repab will be implemented by Mite1 Corporation. 
It is the responsibility of users requiring service to report this need to Mite1 
Corporation or to 
one of their authorized agents. 
ADDRESS FOR U.S. SERVICE 
Mite1 Corporation 
1675 MacArthur Blvd., 
Costa Mesa, California 92626 
Tel.: (714) 557-3300 
NOTE TO CANADIAN CUSTOMERS: 
The Load Number (LN) assigned to each terminal device denotes the percentage of the...