Toshiba Strata Dk14, Dk40i, Dk424 Programming Manual

E911
Program *11-2 – CAMA Trunk Group Hunting Assignments
Strata DK Programming 5/998-7
E911
Program *11-2 – CAMA Trunk Group Hunting 
Assignments
Processor Type:All RCTUs (Release 4.0)
Program Type:System
Initialized Default:Blank
Program *11-2 Overview
This program enables E911 calls to hunt for an idle line in a CAMA trunk group in the order 
assigned in this program.
If all lines in a CAMA trunk group are in use, a new 911 call that attempts to connect to a busy 
trunk group can hunt to another trunk...

E911
Program *11-5 – CAMA Digits Sent on 911 Calls
8-8Strata DK Programming 5/99
Program *11-5 – CAMA Digits Sent on 911 Calls
Processor Type:All RCTUs (Release 4.0)
Program Type:System
Initialized Default:911
Program *11-5 Overview
This program specifies which digits (“911” or “11” or “1”) will be sent to the to CAMA trunk, 
when a user dials 911 or 9+911.
When a caller dials 911, the DK can send 911, 11, or 1 out the CAMA trunk before sending the 
CESID location digits set in Program *12. Normally it...

E911
Program *11-6 – E911 Interdigital Timer
Strata DK Programming 5/998-9
E911
Program *11-6 – E911 Interdigital Timer
Processor Type:All RCTUs (Release 4.0)
Program Type:System
Initialized Default:Data, 2 seconds
Program *11-6 Overview
This program assigns the amount of time allotted for the E911 interdigital timer. When the E911 
feature is enabled, the DK applies the E911 interdigital timer any time a user dials “9” as the first 
digit. This applies to any type of call originated from a [DN] when you...

E911
Program *11-8 – 911 Special [DN] Notification Assignments
8-10Strata DK Programming 5/99
Program *11-8 – 911 Special [DN] Notification 
Assignments
Processor Type:All RCTUs (Release 4.0)
Program Type:System
Initialized Default:Data, Blank
Program *11-8 Overview
This program designates which [PDN] or PhDN] should have ringing notification on 911 calls (all 
installed consoles are always notified). A unique (or the same) [DN] can be designated as the E911 
notification DN in each system ring mode:...

E911
Program *12 – CESID Station Information
Strata DK Programming 5/998-11
E911
Program *12 – CESID Station Information
Processor Type:All RCTUs (Release 4.0)
Program Type:System
Initialized Default:Data Blank
Program *12 Overview
This program assigns the Caller Emergency Service Identification (CESID) information that will 
be sent to the CAMA trunk using Multi-Frequency (MF) signals.
When a station dials 911, the E911 feature causes the DK to seize the CAMA trunk and send 911, 
11 or 1 (per Program...

E911
Program *12 – CESID Station Information
8-12Strata DK Programming 5/99
1. When the CAMA trunk is connected to the Public Switched Telephone Network:            
CESID digits may be: 0-NYY-XXXX
NoteThe hyphens are for clarity - do not try to program them in *12
0 = Information code expected from a PBX on E911 calls. This multi-frequency (MF) “0”  
digit is sent automatically by the DK digits are entered for the calling port in Program *12.
NYY = Office Code
XXXX = Station Directory Number
2. When the...

E911
Program *13 – Station To CAMA Trunk Group Assignment
Strata DK Programming 5/998-13
E911
Program *13 – Station To CAMA Trunk Group 
Assignment
Processor Type:All RCTUs (Release 4.0)
Program Type:System
Initialized Default:Data Blank
Program *13 Overview
This program assign stations to different CAMA trunks groups (if more than one CAMA trunk is 
installed). This can be used to divide services for multi-users (Tenants) or distribute traffic during 
an emergency. 
If only one CAMA trunk is installed...

E911
Program *13 – Station To CAMA Trunk Group Assignment
8-14Strata DK Programming 5/99 

Strata DK Programming 5/99GL-1
Glossary
Glossary
Term Definition
AAAuto Attendant (built-in or external). This feature acts as an automatic operator that 
directs incoming callers to stations by offering a menu of dialing prompts.
ACDAutomatic Call Distribution. Allows incoming calls to be distributed to a group of 
ACD agents. The ACD supervisors LCD telephone displays ACD Agent and 
Group information which allows the supervisor to monitor calls and assist agents.
ACD/MIS Automatic Call Distribution...

Glossary
CCVY ~ DK
GL-2Strata DK Programming 5/99
CCVYCall Center Viewer “Y” Connector—Enables two-way transmissions between the 
Strata DK and a host PC, or SMIS equipment, and one-way transmissions to other 
PCs. There are four ports on the Call Center Viewer Connector for one Strata DK, 
another master port, and two additional ports. 
CLASS Custom Local Area Signaling Services—Defines a number of features offered by 
local telephone companies.
CLID or CND Calling Line Identification or Calling Number...