Toshiba Strata Dk14, Dk40i, Dk424 Programming Manual

ISDN
ISDN Related Programs
Strata DK Programming 5/997-3
ISDN
5. For BRI, run Program *44 to initialize the Service Profile Identifier (SPID) interface. The TE 
initializes the SPID and sends it to the network. Once the SPID is confirmed from the CO, it 
does not have to be sent to the switch again.
6. For BRI and PRI, run Program *42 to assign the PRI or BRI, or T1, circuits to be used for 
Primary and Secondary Clock Source. To enter the program, enter the card slot number 
followed by the circuit...

ISDN
ISDN Related Programs
7-4Strata DK Programming 5/99
Flowchart 7-2 ISDN Trunk Programs
Programs 81~89, 
*81~*87 Direct 
Ringing LinesPrograms*09, *17, 
*71~*73 
DID RingingPrograms 71 and 72
DNIS Ringing Standard Trunks BRI PRIProgram *16
Define ISDN Trunk Group
Type (non-ISDN,PRI, BRI).
Program 16
Assign Trunk Groups. Program 16
Assign Trunk Groups.
Programs *66-1~3
Assign channel and 
trunk group parameters.
Programs *66-2, -4
Assign call-by-call 
service parameters
Program *67
Assign call...

ISDN
Trunk Programs Overview
Strata DK Programming 5/997-5
ISDN
Trunk Programs Overview
See Flowchart 7-2 for an overview of the ISDN trunk programming procedure.
©If you are installing all standard trunk groups, skip Program *16 (the default is for all standard 
TGs).
©If you are installing BRI ISDN, use Program *16 to assign BRI type and Program 16 to assign 
BRI CO lines into trunk groups.
©If you are installing PRI, use Program *16 to assign PRI types. Do not use Program 16. Do not
 
change settings...

ISDN
Program 16 – Assign CO Line Groups
7-6Strata DK Programming 5/99
Program 16 – Assign CO Line Groups
This program assigns CO line groups (or Dial 9 groups). Refer to this program only for BRI lines. 
Do not
 make changes to trunk groups assigned in Program *16 as PRI type. These will be assigned 
automatically when PRI programming is entered. The system record sheet is on Page 3-48 of this 
manual. 

ISDN
Program *16 – ISDN Trunk Group Type Assignment
Strata DK Programming 5/997-7
ISDN
Program *16 – ISDN Trunk Group Type Assignment
Processor Type:DK40i, All RCTUs (Release 4.0 or higher)
Program Type:Trunk, PRI, BRI
Initialized Default:Type 1 (non-ISDN)
Program *16 Overview
This program must be entered prior to Program 16. Each trunk group in the system must be 
defined whether it is used for non-ISDN trunks, PRI trunks, or BRI trunks. Do not make changes 
in Program 16 for PRI trunk groups. This may...

ISDN
Program *42 – Clock Source
7-8Strata DK Programming 5/99
Program *42 – Clock Source
Processor Type:DK40i, All RCTUs (Release 4.0 or higher). For Release 3.1 and earlier programming, 
see below.
Program Type:System, T1, PRI, BRI
Initialized Default:Blank
Program *42 Series Overview
This program assigns the T1, PRI or BRI interface RPTU PCB as a Primary or Secondary timing 
source. The DK424 is synchronized to the Public Network. If the Primary synchronization is lost, 
it switches to the secondary...

ISDN
Program *42-1 – Primary Timing Reference Assignments (Release 3.1 and earlier)
Strata DK Programming 5/997-9
ISDN
Program *42-1 – Primary Timing Reference 
Assignments (Release 3.1 and earlier)
Initialized Default:Primary = 1, Secondary = 2
Program *42-1 Overview (Release 3.1 and earlier)
Assign the Primary Timing Reference with this program.
NoteRDTU No.1 is the RDTU PCB installed in the lowest slot number of all RDTU PCBs, 
RDTU No. 2 is the RDTU PCB installed in the next highest slot number of...

ISDN
Program *43-1~3 – D-Channel Control and NFAS Assignments
7-10Strata DK Programming 5/99
Program *43-1~3 – D-Channel Control and NFAS 
Assignments
Processor Type:All RCTUs (Release 4.0 or higher)
Program Type:System, PRI
Initialized Default:Blank (see Important! below)
Program *43-1~3 Overview
Programs *43-1~3 are related in that there is a correspondence between Program *43-1 and *43-2. 
Program *43-1 determines which channel acts as the master. Program *43-2 points back to the 
master channel by...

ISDN
Program *43-2 – Non-Facility Associated Signaling (NFAS) Assignment
Strata DK Programming 5/997-11
ISDN
Program *43-2 – Non-Facility Associated Signaling 
(NFAS) Assignment
Processor Type:All RCTUs (Release 4.0 or higher)
Program Type:System, PRI
Initialized Default:Blank (see Important! below)
Program *43-2 Overview
This program specifies the card slot of additional PRI links that are dependent upon the D-channel 
of the master D-channel PRI. This setting is for Non-Facility Associated Signaling...

ISDN
Program *43-3 – Network PRI Interface Assignment
7-12Strata DK Programming 5/99
Program *43-3 – Network PRI Interface Assignment
Processor Type:All RCTUs (Release 4.0 or higher)
Program Type:System, PRI
Initialized Default:Blank (see Important! below)
Program *43-3 Overview
Program *43-3 assigns each PRI interface and ID code for communicating with the ISDN provider 
to identify the B-channels to be used with NFAS. 
Use the Record Sheet for *43-1.




  6SNU
  +ROG  6SNU  +ROG...