Home
>
Toshiba
>
Communications System
>
Toshiba Perception Electronic Business Communications System Installation And Maintenance Manual
Toshiba Perception Electronic Business Communications System Installation And Maintenance Manual
Have a look at the manual Toshiba Perception Electronic Business Communications System Installation And Maintenance Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 566 Toshiba manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
TB 100-8504 March 25, 1985 Page 1 of 1 Both the LCD EKT and attendant console require a high volume of control data from the central control. If LCD EKTs and an attendant console are connected to the first half of a DEKU PCB, one or the other might malfunction during high traffic conditions. Therefore, LCD EKTs should not be installed at the following ports: I ) If the attendant console is assigned to port number LOOI, do not assign an LCD EKT to port numbers LO02, LOO3 or LOO4. 2) If the attendant console is assigned to port number Ll21, do not assign an LCD EKT to port numbers Ll22, Ll23 or Ll24. Toshiba America, Inc. Telecommunicatmn Systems Division 2441 Michelle Drive, Tustin, CA 92680 (714) 730.5000 111 Business Park Drwe, Armonk, N.Y. 10504 (914) 273-l 750 TSD 85-03-020
TB 100-8503 March 1, 1985 Page 3 of 3 b) The strapping terminal consists of six pins labeled A C D E F andapairof insulated shorting bars. The bars can connect two pairs of adjacent pins. Select the desired option according to the following table. (Note: The table is printed on each DLSU PCB for reference.) Battery to Ground Dial Pulse: A-B & E-F Loop Dial Pulse: B-C & D-E 3) Loop Current Detection Level: a ) For proper detection of incoming digits, adjustments are required based upon the CO line loop resistance. Selections are made using the strapping terminals, see Figure 2. TB 104-Circuit #1 TB 304-Circuit #3 TB 204-Circuit #2 TB 404-Circuit #4 b) The strapping terminal consists of four pins labeled a b c and an insulated shorting bar. The bar can connect any pair of adjacent pins. Select the desired option according to the following table. MOTE: 0 - 8OOQ c-d (least sensitive) 800 - 1.5KQ b-c (mid sensitive) 1.5KQ and above a-b (most sensitive) The CO line loop resistance values are arbitrary and are used as an initial strapping guide. If the incoming digits are not being detected properly, move the strapping terminal to a different sensitivity position and test for proper operation. c) Install the DLSU PCB(s)-one for each group of four circuits-in the slots designated TOO - TO7 in the DCEC.
To: Erom: Date: Subject: Open jack set box* Remove mute switch wires from switch0 solder them togetherP tape and store* MEMORANDUM ---m--w--- Tech Tips John Brady March 6, 1985 Headset Hook Switch Control Solder two lengths of wire to the switch about i foot long- Route these wires along the coil cord to the phone. Lift mod jack and lay the wires at bottom of slot. Replace mod jack- Route the wires aiong the left side of EKT. bottom of hook switch. Solder to top and JB:sh