Sharp Mx 4100n Owners Manual

4-76
FACSIMILE
Contents
3
Select Dual Page Scan.
(1) Touch the [Special Modes] key.
☞SPECIAL MODES (page 4-69)
(2) Touch the [Dual Page Scan] key so that it is 
highlighted.
(3) Touch the [OK] key.
4
Press the [BLACK & WHITE START] key.
Scanning begins.
When scanning finishes, place the next original and press the [BLACK & WHITE START] key. Repeat until all pages have 
been scanned and then touch the [Read-End] key.
A beep will sound to indicate that scanning is finished.
To cancel scanning...
Press the...

4-77
FACSIMILE
Contents
SENDING A FAX AT A SPECIFIED TIME 
(Timer)
When this function is used, transmission takes place automatically at a specified time.
The timer transmission function makes it easy to perform reserved transmissions, broadcast transmissions and other 
transmissions at night or other times when phone rates are low.
A timer setting can also be specified for polling reception to receive a fax when you are not present.
 When a timer transmission is set, keep the main power switch on....

4-78
FACSIMILE
Contents
4
Set the time with the   keys.
(1) Specify the day.
If you do not wish to specify a day, select [---]. In this 
case, transmission will begin when the time specified in 
(2) arrives.
(2) Specify the time (hour, minute)
Select the time in 24-hour format.
You can also directly touch a numeric display key to 
change the setting with the numeric keys.
(3) Touch the [OK] key.
When this screen is opened, the setting will show the current time. If the time is not correct, press the...

4-79
FACSIMILE
Contents
SENDING TWO PAGES AS A SINGLE PAGE 
(2in1)
Two original pages can be reduced and sent as a single page. This function is convenient when you have a large 
number of original pages and wish to reduce the number of pages sent.
1
Place the original.
When placing the originals, orient them as shown below.
2
Enter the destination fax number.
☞
ENTERING DESTINATIONS (page 4-16)
12
12
12
1
2
Portrait-oriented originals
Landscape-oriented originalsTransmission
Transmission
12
12
11
11...

4-80
FACSIMILE
Contents
3
Select 2in1.
(1) Touch the [Special Modes] key.
☞SPECIAL MODES (page 4-69)
(2) Touch the [2in1] key so that it is 
highlighted.
(3) Touch the [OK] key.
4
Touch the [Original] key.
5
Specify the orientation in which the 
original is placed.
(1) Touch the appropriate [Image Orientation] 
key.
If this setting is not correct, a suitable image may not be 
transmitted.
(2) Touch the [OK] key.
6
Press the [BLACK & WHITE START] key.
Scanning begins.
 If you inserted the original pages...

4-81
FACSIMILE
Contents
 Transmission is not possible at a size smaller than the original size.
 This function cannot be used in direct transmission mode or when the speaker is used to dial.
 The 2in1 function cannot be used when the original is other than 8-1/2 x 11 (A4) or 5-1/2 x 8-1/2 (B5 or A5) size.
 When the scan size of the original is specified by numerical values, this function cannot be used.
To cancel 2in1...
Touch the [2in1] key in the screen of step 3 so that it is not highlighted. 

4-82
FACSIMILE
Contents
SENDING BOTH SIDES OF A CARD AS A 
SINGLE PAGE (Card Shot)
This function lets you send the front and reverse sides of a card as a single page, without the need to send each side 
separately.
When using card shot, the original must be scanned on the document glass.
1
Place the original face down on the 
document glass.
2
Enter the destination fax number.
☞
ENTERING DESTINATIONS (page 4-16)
3
Select the special modes.
(1) Touch the [Special Modes] key.
(2) Touch the [Card Shot]...

4-83
FACSIMILE
Contents
4
Specify the original size.
(1) Enter the original size.
 Touch the [X] key and enter the horizontal dimension 
(X) of the original with the   keys.
 Touch the [Y] key and enter the vertical dimension (Y) 
of the original with the   keys.
(A) To return the original size to the default size, touch 
the [Size Reset] key.
(B) To automatically enlarge or reduce the image size to 
the send size, touch the [Fit to Send Size] key. Do not 
touch this key if you wish to scan the original...

4-84
FACSIMILE
Contents
7
Touch the [Read-End] key.
If you will continue by scanning the front of the card, you can touch the [Configure] key to change the exposure, 
resolution, scan size, and send size.
 The ratio cannot be specified and Rotation Sending Setting cannot be selected.
 This function cannot be used in direct transmission mode or when the speaker is used to dial.
To cancel Card Shot...
Touch the [Cancel] key in the screen of step 4.
Place next original.       
Press [Start].
When finished,...

4-85
FACSIMILE
Contents
SENDING A LARGE NUMBER OF PAGES
(Job Build)
This function lets you separate an original consisting of numerous pages into sets, scan each set using the automatic 
document feeder, and transmit the pages in a single transmission. Use this function when there are more original pages 
than can be placed at once in the auto document feeder.
When scanning originals that are separated into sets, scan the set that has the first page first. The settings that you 
select for the first set...