Sanyo Projector Plc Xu10n User Manual

41
APPENDIX
OPERATING WIRELESS MOUSE
Installation
The Wireless Remote Control Unit is not only able to operate the projector but also usable as a wireless mouse
for a PC.  POINT buttons and two CLICK buttons are used for wireless mouse operation.
Wireless mouse is usable when PC mouse pointer is displayed on the screen.  When the menu or indicator of
the projector is displayed on the screen instead of the PC mouse pointer, the wireless mouse cannot be used.
Connect the mouse port of your computer to the...

42
APPENDIX
MAINTENANCE
TEMPERATURE WARNING INDICATOR
The TEMPERATURE WARNING Indicator flashes red when the internal temperature of the projector exceeds
the normal temperature.  The Indicator stops to flash when the temperature of the projector become normal.
When the TEMPERATURE WARNING Indicator continues to flash, make sure the matters below.
The Ventilation slots of the projector are blocked.  In such an event, reposition the appliance so that the ventilation
slots are not obstructed.
Turn the...

43
APPENDIX
LAMP REPLACEMENT Indicator
When the Lamp of this projector draws to an end, the LAMP REPLACEMENT indicator lights yellow.  When the
image become dark or the color of the image become unnatural, replacement of the Lamp is required.
Turn off the projector and disconnect the AC plug.  Allow the
projector to cool for at least 45 minutes.
Remove 2 screws with a screwdriver and pull out the lamp
assembly by grasping the handle.
1
3
Lamp Replacement Monitor Timer
Replace the lamp assembly.4
Replace...

44
APPENDIX
TROUBLESHOOTING
Before calling your dealer or service station for assistance, check the matters below once again.
1. Make sure you have connected the projector to your equipment a s described in section CONNECTING
THE PROJECTOR  on pages 10 ~ 15.
2. Check cable connection.  Verify that all computer, video and power cord are properly connected.
3. Verify that all power is switched on.
4. If the projector still does not produce the image, re-start the computer.
5. If the image sill does not...

45
APPENDIX
WARNING :
High voltages are used to operate this projector.  Do not attempt to open the cabinet.
Sanyo Service is easily obtained.  If after following all operating instructions, you find that service is
necessary, contact the SFS Corporation in Los Angeles, or the store where you purchased the unit.  Give the
model number and explain the difficulty.  We will advise you how to obtain service.
Remote Control
Units dose not
work.lCheck the batteries.
lMake sure anything is blocking between the...

46
0.9 TFT Active Matrix type, 3 panels
TECHNICAL SPECIFICATIONS
Multi-media Projector
9.48 lbs (4.3 kg)
8.46 x 4.88 x 12.85 (215mm x 124mm x 326.5mm)
1,024 x 768 dots
2,359,296 (1,024 x 768 x 3 panels)
PAL, SECAM, NTSC, NTSC4.43 and PAL-M
H-sync. 15 ~ 100 KHz, V-sync. 50 ~ 100 Hz
Adjustable from 30” to 300”
800 TV lines
1 speaker, 1.57 x 1.18 (40mm x 30mm) 
AC 100 ~ 120 V, 50 / 60 Hz
2.2 A (Max. Ampere) 
41 ˚F ~ 95 ˚F (5 ˚C ~ 35 ˚C)
14 ˚F ~ 140 ˚F (-10 ˚C ~ 60 ˚C)
Owner’s Manual
AC Power Cord
Remote...

This symbol on the nameplate means the product is Listed by Underwriters Laboratories Inc.  It
is designed and manufactured to meet rigid U.L. safety standards against risk of fire, casualty
and electrical hazards. 

1YEAR
In order to obtain warranty service, the product must be delivered to and picked up from and Authorized Sanyo Factory
Service Center at the users expense, unless specifically stated otherwise in this warranty.  the names and addresses of
authorized Sanyo Service Centers may be obtained by calling the toll-free number listed below.
Subject to the OBLIGATIONS above and EXCLUSIONS below, SANYO  FISHER COMPANY (SFC) warrants this
SANYO product against defects in materials and workmanship for the...