Panasonic UF 6300 User Manual

41
memo
Programming 
Your Machine
UF6300_FAX_UK_PJQMC1263ZB.book  41 ページ  ２００８年１２月１０日　水曜日　午後１時２６分
Downloaded From ManualsPrinter.com Manuals 

42
Basic Operations
Loading Documents
In general, your machine will send any document printed on A4 size paper.
Note:The maximum document width that can be sent through the machine is 257mm. 
However, the effective scanning width is 208mm.
You must never try to send documents that are:
To transmit these kinds of documents, make a photocopy first and then transmit the copy instead.
Documents You Can Send
Documents You Cannot Send
Wet Covered with wet ink or paste
Too thin (Ex: onionskin, airmail 
paper,...

Loading Documents
43
Basic Operations
1. Be sure the document(s) is free of staples, paper clips and is not torn, greasy or covered by foreign objects.
2. Place the document(s) FACE DOWN on the Automatic Document Feeder (ADF) until the leading edge 
inserted in the machine stops.
You can also stack up to 30 PAGES on the ADF at one time. If you are sending more than 30 pages of the 
document(s) (up to 50 pages), make sure that the bottom sheet of the document(s) enters first.
3. Adjust the Document Guides...

44
Basic Transmission Settings
You can temporarily change the transmission settings either before or after you place the document on the 
ADF. 
These settings are as follows:
•Contrast
• Resolution
•Stamp
• Communication Journal
After your document(s) have been sent, your machine will automatically return to the preset settings.
Your machine is preset to Normal contrast.  If you wish to send a document with lighter contrast, change the 
setting to Lighter.  If you wish to send a document with darker...

Basic Transmission Settings
45
Basic Operations
The Verification Stamp helps you to confirm successful transmissions by stamping the bottom of each 
successfully transmitted page with a small   mark.
Press  to:
NOTE1. When you store a document in memory, the Verification Stamp will stamp on the document if it 
is successfully stored in memory. In this case the Verification Stamp is not a confirmation that 
the document was successfully transmitted. If you wish to disable the use of the Verification...

Basic Transmission Settings
46
A Communication Journal lets you verify if the transmission was successful.  You can select the condition to 
print out the Communication Journal as follows.
NOTE1. To change the preset Comm. Journal condition, change the setting of Fax Parameter No. 12.  
(See page 36)
Communication Journal (COMM. JOURNAL) 
When you set COMM. JOURNAL = OFF: A Communication Journal will not be printed out.
When you set COMM. JOURNAL = ON: A Communication Journal is printed out automatically...

47
Basic Operations
Sending Documents
You can choose either Memory or Direct Transmission.
Use Memory Transmission if:
• You want to send the document to multiple stations.
• You have to retrieve the document immediately.
• You want to take advantage of Dual Operation design.
Use Direct Transmission if:
• The memory is full.
• You want to send the document immediately.
Use Voice Mode Transmit if:
• You want to send the document after talking with the other party.
• You want to send the document after...

Sending Documents
48
General Description
2. If memory overflow occurs while storing documents, the remaining documents on the ADF will 
be ejected.  The machine prompts you whether to transmit the successfully stored documents 
or to cancel the transmission.  Press   to cancel or press   to transmit.
MEMORY OVERFLOW
 INFO. CODE=870
See the Specifications on page 152 for the image memory capacity.
If no action is taken within 10 seconds, the machine will start transmitting the stored 
documents.
15 PAGES...

Sending Documents
49
Basic Operations
Manual Number Dialling
To dial the telephone number manually, follow the steps below.
NOTE1. If you need a special access number to get an outside line, dial it first then press 
 to enter a pause (represented by a -) before dialling the full number.
Ex: 9 PAUSE 5551234
2. If you are using Pulse dialling and you wish to change to Tone dialling in the middle of dialling, 
press   (represented by a /). The dialling method will be changed from Pulse to Tone after...

Sending Documents
50
Memory Transmission
Dialling Re-enter Function
This function has the function of preventing transmission of a document to a wrong address.
When use direct dialling, the re-enter screen will be displayed. Input the destination Tel No. again and if both 
are match start dialing.
This function operates if setting 137 RE-ENTER D. DIAL of Fax Parameter set to VALID. 
(See page 40) 
NOTE1. When telephoning from an external telephone, the re-enter screen is not displayed.
2. If setting 136...