Panasonic Network Camera Management SystemKx Hgw600 Operating Instructions

							Operating Instructions
[For assistance, please call: 1-800-272-7033] 11
Product
Introduction1.2 Included Accessories
The following items are provided with the KX-HGW600. Additional pieces can be
ordered by calling1-800-332-5368.
Notes
 If any items are missing or damaged, check with the place of purchase or contact
our customer call center.
 The order numbers listed above are subject to change without notice.
 Save the original carton and packing materials for future shipping and
transportation of the unit.
AC adaptor—1pc.
Order No. PQLV12Y
( Page 21 and Page 41)Screws—2pcs.
Order No. PQHE5004Z
Washers
—2 pcs.
Order No. XWG3E16
(Page 125)
Ethernet cable
—1pc.
(Category 5 straight cable)
Order No. PQJA10138Z
(Page 19 and Page 39)Cable clamper
—1pc.
Order No. PQHR10788ZA
(Page 21 and Page 41) 
						

							Operating Instructions
12
1.3 Part Names
1.3.1 Front View
1.3.2 Rear View
W
I
R
E
L
E
S
S K
X
-
H
G
W
6
0
0
L
A
N
1
L
A
N
2L
A
N
3
L
A
N
4W
A
NP
O
W
E
RSD memory card slot( Page 54)
WIRELESS indicator
( Page 13)
LAN1—4 indicators
( Page 13) WAN indicator
( Page 13) POWER indicator
( Page 13) Diversity antenna
L
A
N
3
L
A
N
2
L
A
N
1R
E
S
T
A
R
T
F
A
C
T
O
R
Y
D
E
F
A
U
L
T
R
E
S
E
TL
A
N
4-+W
A
N D
C
I
N
1
2
V
USESPECIFIED
Panasonic
ACADAPTORONLY
LAN 1—4 jacks ( Page 20 and Page 40)
WAN jack
( Page 19 and Page 39)
DC IN jack( Page 21 and Page 41)
RESTART button ( Page 124)
FACTORY DEFAULT RESET button
( Page 124) 
						

							Operating Instructions
[For assistance, please call: 1-800-272-7033] 13
Product
Introduction
1.3.3 Indicators
LED Light Color Description
POWERGreenThe KX-HGW600 is turned on.
RedThe KX-HGW600 is in a bad state. Push the
RESTART button ( Page 124) on the
KX-HGW600.
WA NGreenThe KX-HGW600 is successfully connected to
a modem or an Ethernet hub.
Green
(Blinking)The KX-HGW600 is sending or receiving data
through this jack.
LAN 1—4GreenThe KX-HGW600 is successfully connected to
an Ethernet hub, Network Camera or a PC.
Green
(Blinking)The KX-HGW600 is sending or receiving data
through this jack.
WIRELESSGreenThe KX-HGW600 is successfully connected to
a wireless Network Camera or a wireless PC.
Green
(Blinking)The KX-HGW600 is sending or receiving data
in a wireless network. 
						

							Operating Instructions
14 
						

							Operating Instructions
[For assistance, please call: 1-800-272-7033] 15
Setup
Section 2
Setup 
						

							Operating Instructions
16
2.1 Configuration Types
The KX-HGW600 is available on a small or large scale network. The main configuration
types are as follows. Make sure which configuration type is required and set up the
KX-HGW600.
Internet Configuration—[Type 1](Page17)
The KX-HGW600 can establish a LAN by connecting to the Internet.
LAN (Intranet) Configuration—[Type 2](Page38)
The KX-HGW600 can establish a LAN by connecting to the other LAN (Intranet).
Notes
 TheKX-HGW600isadevicewithtwosides:OnesideismadeupofyourLAN
(Local Area Network) of each device in your home or office. The other side is the
WAN (Wide Area Network) outside of your home or office.
 In this manual the CATV/xDSL/optical cable modem is called Modem.
Modem
CATV
xDSL
Optical cable
Internet
ISP
WAN LAN
LAN (Intranet)WAN LAN 
						

							Operating Instructions
[For assistance, please call: 1-800-272-7033] 17
Setup
2.2 Internet Configuration
2.2.1 Connecting to the Internet
Preparation
Before starting to install the KX-HGW600, make sure you have everything below.
 A Windows PC with a network card (Ethernet card or IEEE 802.11b wireless card)
installed
 Account information for Internet access (provided by your ISP)
 A CATV/xDSL/optical cable modem
Notes
 Some modems may store only the initial network information. They cannot
communicate with the other devices. Turn them off. After a while, turn them on
again.
 Some modems may need to be turned off for a few hours or even a whole day.
 SomeISPsprohibityoutoturnoffthemodems.PleaseaskyourISP.
To collect information on the Internet access
Depending on the ISP, you can connect the following four types of Internet configuration.
 DHCP Connection
 Static Connection
 PPPoE (Point to Point Protocol over Ethernet) Connection
 PPPoE Connection (IP unnumbered)
Check the information provided by the ISP and make sure which type of configuration is
required. For more information, please ask your ISP.
To make note of corresponding account information for your future reference
1. DHCP Connection(using a DHCP server)
The DHCP server of your ISP assigns the IP addresses to the KX-HGW600
automatically. When the ISP uses the DHCP server function, enterDevice
Name*,Gateway Address,DNS Server 1,DNS Server 2andDomain Name
in the following data fields.
* Some ISPs may call Device Name differently. Please ask your ISP about
Device Name.
Device NameGateway Address...
DNS Server 1 . . .
DNS Server 2 . . .
Domain Name✐✐ ✐ ✐✐ 
						

							Operating Instructions
18
2. Static Connection(using static IP address)
When the ISP requires you to use static IP address, enterIP Address, Subnet
Mask, Gateway Address, DNS Server 1andDNS Server 2in the following
data fields. If specified by the ISP, enterDomain Name.
3. PPPoE Connection(using a single global IP address)
It is a connection method used mostly by ADSL providers. When the ISP requires
you to use a single global IP address, enterUser NameandPasswordin the
following data fields. If specified by the ISP, enterService Name,Access
Concentrator Name,DNS Server 1,DNS Server 2andDomain Name.
4. PPPoE Connection (IP unnumbered)(using multiple global IP addresses)
When the ISP requires you to use the multiple global IP addresses, enter the
same data fields as the above PPPoE Connection. Then enter one of the global
IP addresses provided by the ISP in theIP address of KX-HGW600.
IP address of KX-HGW600
IP Address . . . Subnet Mask . . .
Gateway Address...
DNS Server 1 . . .
DNS Server 2 . . .
✐✐ ✐
Domain Name✐ ✐✐
User Name Password
Service Name
Access Concentrator Name
DNS Server 1 . . .✐✐ ✐
DNS Server 2 . . .✐
Domain Name✐ ✐✐
User Name Password
Service Name
Access Concentrator Name
DNS Server 1 . . .✐✐ ✐
DNS Server 2 . . .✐
Domain Name✐ ✐✐
IP Address . . . Subnet Mask . . .✐ ✐ 
						

							Operating Instructions
[For assistance, please call: 1-800-272-7033] 19
Setup
Connecting the KX-HGW600 to a modem
To access the Internet using a CATV/xDSL/optical cable modem, follow the steps below.
1.Connect the Ethernet cable (with 8-pin RJ-45 connector) to the Ethernet jack of
the modem.
2.Connect the other end of the Ethernet cable to the WAN jack of the
KX-HGW600.
Note
Some modems may have a polarity switch or need category 5 cross cable
instead of category 5 straight cable. Please refer to the modem’s manual for
more information.
Ethernet jack of the modem
Ethernet cable
(included accessory)
WAN jack 
						

							Operating Instructions
20
Connecting a PC to the KX-HGW600
Before connecting a PC to the KX-HGW600, make sureObtain an IP address
automaticallyis checked in the TCP/IP Properties window on the PC
( Page 129) and follow the steps below.
1.Turn off the PC.
2.Connect the Ethernet cable (customer provided) to one of the LAN 1—4 jacks of
the KX-HGW600.
3.Connect the other end of the Ethernet cable to the Ethernet jack of the PC.
Note
All Ethernet jacks have an automatic MDI/MDIX feature, which means either a
straight or cross cable can be used to connect to any jack.
The KX-HGW600 will automatically detect which cable has been inserted.
Ethernet cable
Ethernet jackLAN1—4 jacks