OKI MC860cdtn User Manual

							
Operation > 111
Using a Job Program:
To use a pre-programmed short cut:
1.Press the  Job Program  button on the control panel to prompt the  Job Programs 
screen.
2. Select the job number you wish to use.
3. At the prompt, select  Yes to execute the program or  No to exit.
Deleting a Job Program:
To delete a Job Program function:
1. Press the  Setup button on the control panel to prompt the  Setup screen.
2. Press the  Job Programs Setting  button.
3. Press the  Delete button.
4. Select the job number you wish to delete.
5. At the prompt, select  Yes to confirm deletion or  No to exit.
Changing the Key Speed:
To help you monitor the operation of each step , you can alter the speed at which each step 
is performed. To alter the key speed:
1. Press the  Setup button on the control panel to prompt the  Setup screen.
2. Press the  Job Programs Setting  button.
3. Press the  Key Speed  button.
4. Select the required key speed and press  Enter.
5. Press the  Close button (twice) to exit the menu.
Editing the Job Program Title:
To edit a Job Program title:
1.Press the  Setup button on the control panel to prompt the  Setup screen.
2. Press the  Job Programs Setting  button.
3. Press the  Edit Title  button.
4. Select the job number you wish to edit.
5. Use the on-screen keyboard to  enter/edit the job title.
6. At the prompt, select  Yes to confirm deletion or  No to exit.
Downloaded From ManualsPrinter.com Manuals 
						

							
Operation > 112
Reports and Listings
Press the Reports button on the control panel to display the list of reporting options 
available:
Configuration
1. Press the  Configuration  button.
2. At the prompt, press  Yes to print the report or press  No to cancel the operation and 
return to the Reports screen.
Information
1. Press the  Information  button to display the information report and listing options.
2. Select required report or list:
- File List
-Demo Page
- Error Log
-Scan to Log
-MFP Usage Report
- Network Info.
3. MFP Usage Report only: use the on-screen  arrows or the keypad to specify the 
number of copies required.
4. At the prompt, press  Yes to print the report/list or press  No to cancel the operation 
and return to the list of information reports.
Fax
1. Press the  FAX button to display the fax report and listing options.
2. Select required report or list:
-Speed Dial List
-Group List
Downloaded From ManualsPrinter.com Manuals 
						

							
Operation > 113
- Journal Report:(i) Fax Transmit
(ii) Fax Receive
(iii) Fax Tx/Rx
(iv) Journal Daily Report
-F-code Box List
-Block Junk Fax
- Store Doc List
3. At the prompt, press  Yes to print the report/list or press  No to cancel the operation 
and return to the list of fax reports.
Scan 
1. Press the  SCAN button.
2. Press the  E-mail Address  button.
3. At the prompt, press  Yes to print the list of e-mail addresses or press  No to cancel 
the operation.
Print
1. Press the  PRINT button to display the print report and listing options.
2. Select required report or list:
-PCL Font List
-PSE Font List
- PPR Font List
-FX Font List
- Color Pattern
- Color Profile
3. At the prompt, press  Yes to print the report/list or press  No to cancel the operation 
and return to the list of print reports.
Downloaded From ManualsPrinter.com Manuals 
						

							
Maintenance > 114
Maintenance
Consumable Life Expectancy
As a guide, the life expectancy of these items is:
•Toner Starter cartridge:
The machine is shipped with sufficient cyan, magenta, yellow & black toner for 2,000 
images (ISO/IEC19798), of which 750 images are used to charge the image drum 
(1,250 A4 pages remaining at 5% coverage).
Replacement cartridge:
Replacement cartridges (C, M, Y & K)  have a capacity of approximately 10,000 
images (ISO/IEC19798).
• Image drum:  As the lifetime of the cartridge is proportional to the number of drum 
rotations, simplex printing on LetterLEF pape r with area coverage rate at 5% yields:
• 20,000 pages (approx.) for 3 pages per job
• 16,000 pages (approx.) for 2 page per job
• 11,000 pages (approx.) for 1 page per job
• Transfer belt:  Approximately 80,000 Letter pages.
• Fuser:  Approximately 100,000 Letter pages.
Consumable Order Details
Only use genuine Oki Original consumables to  ensure the best quality and performance 
from your hardware. Non Oki Original prod ucts may adversely affect your printers 
performance and invalidate your warranty.
NOTE
When the on-screen display indicates that  the toner is low, or if print appears 
faded, first open the printer cover and  try tapping the cartridge a few times to 
evenly distribute the toner powder. This  will enable you to obtain the best 
“yield” from your toner cartridge.
ITEMORDER NO.
Toner, black 44059216
Toner, cyan 44059215
Toner, magenta 44059214
Toner, yellow 44059213
Image drum, black 44064016
Image drum, cyan 44064015
Image drum, magenta 44064014
Image drum, yellow 44064013
Fuser, 120V
Fuser, 230V  43529404
43529409
Transport belt 43449704
Downloaded From ManualsPrinter.com Manuals 
						

							
Maintenance > 115
Replacing Consumable Items
Toner Cartridge Replacement
The toner used in this machine is a very fine dry powder. It is contained in four cartridges: 
one each for cyan, magenta, yellow and black.
Have a sheet of paper handy so that you have  somewhere to place the used cartridge while 
you install the new one.
Dispose of the old cartridge responsibly, inside the pack that the new one came in.  Follow 
any regulations, recommendations, etc., which  may be in force concerning waste recycling.
If you do spill any toner powder, lightly brush it  off. If this is not enough, use a cool, damp 
cloth to remove any residue.
Do not use hot water, and never use solvents of any kind. They will make stains permanent.
1. Pull the lever (a) firmly to release the lo ck and then gently raise the scanner (b).
CAUTION!
To avoid toner wastage and possib le toner sensor errors, do not 
change the toner cartridge(s) un til “TONER EMPTY” is displayed.
WARNING!
If you inhale any toner or get it in  your eyes, drink a little water or 
bathe your eyes liberally in cold  water. Seek medical attention 
immediately.
b
a
Downloaded From ManualsPrinter.com Manuals 
						

							
Maintenance > 116
2.Press the cover release (a) and open the top cover (b) fully.
3. Note the positions of the four cartridges. It  is essential that they go back in the same 
order.
5. Pull the colored toner release lever (1) on th e cartridge to be replaced fully towards 
the front of the MFP.
WARNING!
If the MFP has been powe red on, the fuser may be hot. This area is 
clearly labelled. Do not touch.
1. Cyan cartridge 3. Yellow cartridge
2. Magenta cartridge 4. Black cartridge
b
a
1 
2 
3 
4 
1
Downloaded From ManualsPrinter.com Manuals 
						

							
Maintenance > 117
6.Lift the right-hand end of the cartridge an d then draw the cartridge to the right to 
release the left-hand end as shown, and wi thdraw the toner cartridge out of the MFP.
7. Put the cartridge down gently onto a piec e of paper to prevent toner from marking 
your furniture.
8. Remove the new cartridge from its box but leave its wrapping material in place for 
the moment.
9. Gently shake the new cartridge from end to end several times to loosen and 
distribute the toner evenly inside the cartridge.
10. Remove the wrapping material and peel off the adhesive tape from the underside of 
the cartridge.
11. Holding the cartridge by its top centre with  the colored lever to the right, lower it 
into the printer over the image drum unit  from which the old cartridge was removed.
CAUTION!
The green image drum surface is very delicate and light sensitive. 
Do not touch it and do not expose  it to normal room light for more 
than 5 minutes. If the toner cartri dges need to be out of the MFP 
for longer than this,  please lower the top co ver. Never expose the 
drum to direct sunlight or  very bright room lighting.
2 
1 
Downloaded From ManualsPrinter.com Manuals 
						

							
Maintenance > 118
12.Insert the left end of the cartridge into th e top of the image drum unit first, pushing 
it against the spring on the  drum unit, then lower the right end of the cartridge down 
onto the image drum unit.
13. Pressing gently down on the cartridge to en sure that it is firmly seated, push the 
colored lever (1) towards the rear of the MFP.  This will lock the cartridge into place 
and release toner into the image drum unit.
14. Close the top cover and press down firm ly so that the cover latches closed.
15. Gently lower the scanner.
2 1 
1
Downloaded From ManualsPrinter.com Manuals 
						

							
Maintenance > 119
Image Drum Replacement
The MFP contains four image drums: cyan, magenta, yellow and black.
1. Pull the lever (a) firmly to release the lo ck and then gently raise the scanner (b).
2. Press the cover release (a) and open the top cover (b) fully.
CAUTION!
Static sensitive devices, handle with care.
WARNING!
If the MFP has been powered on, the  fuser will be hot. This area is 
clearly labelled. Do not touch.
b
a
b
a
Downloaded From ManualsPrinter.com Manuals 
						

							
Maintenance > 120
3.Note the positions of the four cartridges. It  is essential that they go back in the same 
order.
5. Holding it by its top centre, lift the image drum, complete with its toner cartridge, up 
and out of the MFP.
6. Put the cartridge down gently onto a piec e of paper to prevent toner from marking 
your furniture and to avoid damaging the green drum surface.
7. With the colored toner release lever (1) to  the right, pull the lever towards you. This 
will release the bond between the toner  cartridge and the image drum cartridge.
8. Lift the right-hand end of the cartridge an d then draw the cartridge to the right to 
release the left-hand end as shown, and  withdraw the toner cartridge out of the 
1. Cyan cartridge 3. Yellow cartridge
2. Magenta cartridge 4. Black cartridge
CAUTION!
The green image drum surface at the base of the cartridge is very 
delicate and light sensitiv e. Do not touch it and do not expose it to 
normal room light for more than 5  minutes. If the drum unit needs 
to be out of the MFP for longer th an this, please wrap the cartridge 
inside a black plastic bag to keep  it away from light. Never expose 
the drum to direct sunlight  or very bright room lighting.
1 
2 
3 
4 
1
Downloaded From ManualsPrinter.com Manuals