OKI C130n User Manual

81 - C130n User’s Guide
Important!
Do not touch the contact 
indicated in the illustration.
 
 
 
 
 
 
 
 
 
 
 
10Press in the toner cartridge until 
it locks into place.
11Close the front cover.
NoteThe printer must 
complete a calibration 
cycle (less than 2 
minutes) after the toner 
cartridge has been 
replaced. If you open the 
top or front cover before 
the message IDLE 
appears, the printer stops 
and repeats the 
calibration cycle.
Downloaded From ManualsPrinter.com Manuals 

82 - C130n User’s Guide
Replacing All Toner Cartridges at the Same Time
CAUTION
Be careful not to spill toner while replacing a toner cartridge. If 
toner spills, immediately wipe it off with a soft, dry cloth.
By using the REMOVE ALL mode, all toner cartridges can be replaced at the 
same time.
1Perform the operation described below to switch the printer to the 
REMOVE ALL mode.
Press KeyUntil Display Reads
MANU 
MAIN MANU
MAIN MENU 
PRINT MENU
 × 2MAIN MENU 
QUALITY MENU
QUALITY MENU 
REPLACE TONER...

83 - C130n User’s Guide
NoteIt is not possible to exit REMOVE ALL mode before the operation is 
finished (even if the Cancel key is pressed).
 
If the printer has incorrectly been switched to REMOVE ALL mode, 
open, then close the front cover four times to exit REMOVE ALL 
mode.
2Perform the operations described in steps 2 through 10 of “Replacing a 
Toner Cartridge”  starting on page 6-77 to replace the magenta toner 
cartridge.
3Follow the same procedure to replace the cartridges for the cyan, black,...

84 - C130n User’s Guide
Imaging Cartridges 
Replacing the Imaging Cartridge
Important!
When replacing an imaging cartridge, use only a genuine Oki 
imaging cartridge for your specific printer type. 
1Open the top cover.
NoteIf there is paper in the 
output tray, remove it, 
and then fold up the 
output tray before 
opening the top cover.
2Grab the handle and lift it up 
slightly to the back, and then 
slowly pull the imaging cartridge 
out vertically.
 
 
 
 
 
 
 
 
Downloaded From ManualsPrinter.com...

85 - C130n User’s Guide
CAUTION
Dispose of the used imaging cartridge according to your local 
regulations. Do not burn the imaging cartridge.
3Prepare the new imaging cartridge.
Important!
Do not touch the PC drum and the transfer belt on the imaging 
cartridge.
 
 
 
 
 
 
 
 
 
 
 
 
4Slowly insert the new imaging 
cartridge vertically, and then 
push it slightly down toward you 
to finish installing the imaging 
cartridge.
Downloaded From ManualsPrinter.com Manuals 

86 - C130n User’s Guide
5Carefully close the top cover.
NoteThe printer must 
complete a calibration 
cycle (less than 2 
minutes) after the 
imaging cartridge has 
been replaced. If you 
open the top cover before 
the message 
IDLE 
appears, the printer stops 
and repeats the 
calibration cycle.
 
Downloaded From ManualsPrinter.com Manuals 

87 - C130n User’s Guide
The Fuser Unit
Replacing the Fuser Unit
Important!
For optimum print quality and performance, use only a genuine 
Oki fuser unit for your specific printer type.
1Turn off the printer and 
disconnect the power cord.
 
 
 
 
 
 
 
 
 
 
 
 
 
WARNING!
There are extremely hot parts within the printer. Before replacing 
the fuser unit, wait about 20 minutes after turning off the printer, 
and then check that the fusing section has reached room 
temperature, otherwise, you may get...

88 - C130n User’s Guide
2Open the top cover.
NoteIf there is paper in the 
output tray, remove it, 
and then fold up the 
output tray before 
opening the top cover.
3Push the blue handles back as 
far as possible.
4Grab the blue handles and lift 
the fuser unit to remove it.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Downloaded From ManualsPrinter.com Manuals 

89 - C130n User’s Guide
Important!
Do not touch the matching 
connectors of the fuser unit 
and the machine.
 
 
 
 
 
 
 
 
 
 
5Prepare a new fuser unit.
Downloaded From ManualsPrinter.com Manuals 

90 - C130n User’s Guide
aPull the fuser separator 
levers forward as far as pos
-
sible.
bRemove the fuser separator 
material, and then return the 
fuser separator levers to their 
original positions.
 
 
 
 
 
 
 
 
 
Downloaded From ManualsPrinter.com Manuals