Oce ColorWave 300 User Manual

When the cover or door is opened while the printer prints a job, the print is cut after you
close the cover. Then the whole print job is restarted.
Chapter 8
 - System messages and solutions 301Cover or door opened
Downloaded From ManualsPrinter.com Manuals 

Remove jammed media
Introduction
When a media jam occurs, the system produces a double audio signal. When a jammed
media
 error occurs 
on the system, immediately remove the jammed media to prevent
damage to 
the printer.
The
 
system handles the error recovery for the jammed media through a series of dialog
boxes.
 Use 
the following procedure to remove the jammed media.
Job 
recovery
The 
Océ ColorWave 300 is equipped with a job recovery function that safeguards users
against
 data loss 
in case of a...

Examples:
2.
Use a pair of scissors to cut loose the media.
3. Remove
 the jammed 
media from the output side of the printer.
4. Press
 the softkey for 'Next >' 
to confirm that you removed the jammed media.
5. Close the cover or door 
that the printer user panel indicates.
6. Insert
 the roll of media in 
the printer.
The
 
printer is ready for use.
Note:
When you remove the media from the front of the printer, there is a risk of ink pollution
in 
the media feed section. Chapter 8
 - System...

Temperature or humidity out of range
Temperature or humidity out of range
The system produces a short interrupted audio signal. When this error persists, contact 
your local Océ service organization.
Chapter 8
 - System messages and solutions304Temperature or humidity out of range
Downloaded From ManualsPrinter.com Manuals 

Carriage away from home position too long
Caution:
When the carriage stays away from its home position too long, the printheads become
dry.
 When the printheads are 
dry, you must replace the printheads. Carriage away from home position too long
Always replace the printheads or the maintenance cassette in 
one continuous action to
prevent the drying of the printhead nozzles. When you 
replace a printhead or the maintenance cassette, the carriage moves to the
centre. 
When the carriage is in the center...

The scanner
Clear an original jam on the scanner
Introduction
When an original jam occurs on the scanner, the message 'Scanner original jam' appears
on the user panel. You must remove the original from the scanner.
If
 an original 
jam occurs often:
■ Check if 
you use the correct type of original.
■ Check
 if 
you must use a carrier sheet.
■ Check
 if 
the original is damaged before you insert it.
How
 to remove a jammed original 1. Use

 both hands to push up the left and right scanner open...

Note:
Check that the left and right scanner open levers are locked into position.4. Make the original 
smooth and feed the original.
Chapter 8
 - System messages and solutions 307Clear an original jam on the scanner
Downloaded From ManualsPrinter.com Manuals 

Chapter 8 - System messages and solutions308Clear an original jam on the scanner
Downloaded From ManualsPrinter.com Manuals 

Chapter 9
License 
management
Downloaded From ManualsPrinter.com Manuals 

Introduction to managing licenses
Introduction
The Océ applications and options are protected against unauthorized use. You need to
activate the license to 
enable an application or option for use. The 'Support' - 'Licenses'
tab
 
in the printer enables you to manage the licenses very easily.
This 
section describes the following.
■ The
 
basic concept of the licenses.
■ How to 
manage the licenses.
Chapter 9
 - License management310Introduction to managing licenses
Downloaded From...