Nitsuko 124i/384i Software Manual

Description (Cont’d)
Flexible DID Service Compatibility
You can program the system to be compatible with three and four digit DID service.  With four digit service, the
telco sends four digits to the system for translation.  With three digit service, the telco sends three digits to the
system for translation.  Be sure to program your system for compatibility with the provided telco service.  For
example, if the telco sends four digits, make sure you set up the translation tables to accept the four...

Description (Cont’d)
Federal Communications Commission DID Requirements (Cont’d)
This equipment returns answer supervision on all DID calls forwarded back to the Public Switched Telephone
Network. Permissible exceptions are when:
•A call is unanswered
•A busy tone is received
•A reorder tone is received
When ordering DID service, provide the telco with the following information:
FCC Registration Number ........................................1ZDJPN-nnnnn-KF-E 
DID Facility Interface...

Programming
Start
(384i Only) If required, in 0116
check the Tone Detection Setup.
Are all your DID trunks
in the same telco block?In 0905, assign all DID
trunks to the same group.
Enter data in worksheet
page 1.In 0905, assign each unique
type of DID trunk to its own
trunk group. Enter data in
worksheet page 1.
Is trunk for Dial
Pulse or DTMF
DID service?In 0901 item 27, enter 1
for DTMF. Enter data in
worksheet page 1.In 0901 Item 27, enter 0
for Dial Pulse. Enter data
in worksheet page 1.
(384i Only)...

Programming (Cont’d)
Yes NoNo Yes
Continued
on next
page.
For each Translation Table
Entry on worksheet page 2,
use 1806 to enter data in the
Digits Received, Digits
Dialed and Name fields.
Allocate Translation Table
entries to Translation Table 1.
On worksheet page 2, use
Table No. Entry to record the
entry number, and Address
No. for the entrys
corresponding address.
Enter the data from
worksheet page 2 into
1805 and 1807.
Allocate Translation Table
entries to each Translation
Table.  On worksheet...

Programming (Cont’d)
Continued
from
previous
page.Do you want
DID Intercept?StopNo
Should the intercept
destination be a Ring
Group, the VAU
Automated Attendant
or Voice Mail?
Yes
Determine which
extension Ring Group you
want for DID Intercept.
Set up Ring Groups in
0909 and 0910.
Ring
Group
In 1809, assign an
extension Ring
Group to each
Translation Table.In 1809, assign 128
(384i) or 16 (124i)
to each Translation
Table.
Voice Mail
In 1809, assign 127
(384i) or 15 (124i) to
each Translation
Table.VAU...

Programming (Cont’d)
DID Routing Through the Automated Attendant (124i Base 2.13, EXCPRU 2.18, 384i 3.06.16 or Higher)
Start
Should a DID
number route to the
VAU Automated
Attendant?
StopNo
In 1806 for the DID
number dialed, enter
882 in the 
TRF entry.
Yes
After entering 882 above, enter the
number of the VAU message (01-16) the
caller should hear when the Automated
Attendant answers (e.g., 882 02 ).This message could be similar
to your main company
greeting. Callers can dial
Automated Attendant...

Programming (Cont’d)
➣
0116 - Tone Detection Setup
Use items 1-10 and 19-32 to set the DTMF criteria for DTMF DID calls.
➣0132 - DID Trunk Timers
Make sure the DID Trunk Timer settings are compatible with your local telco.
➣(384i Only) 0303 - DTMF and Dial Tone Detection Circuit Setup
If the system has DTMF DID trunks, be sure to reserve at least one DTU block for analog trunk DTMF
reception (type 2). There must be an available receiver for each DTMF DID trunk.
•Use the following as a guide when...

Programming (Cont’d)
➣
1807 - DID Translation Table Expected Number of Digits
For each DID Translation Table (1-8), enter the number of digits the table expects to receive from the
CO. For example, for a table used with 3-digit DID service, enter 3.
➣1808 - DID Trunk Group to Translation Table Assignment
Assign the DID trunk groups (1-128) to translation tables. If all the DID trunks use the same type of DID serv-
ice, you may have only one DID trunk group and one DID Translation Table (with many...

DID Options Worksheet 
Trunk Service Type
OptionTrunk
NumberTrunk
GroupSignaling
Ty p eStart
Ty p eDay Night Midnight Rest
Program No.0905 0901-27 2301 0901-14 0901-15 0901-16 0901-17
Entry Range1-128 1-128 DP=0
DTMF=1Immed.=0
Wink=1Normal=0
DISA=2
DID=3Normal=0
DISA=2
DID=3Normal=0
DISA=2
DID=3Normal=0
DISA=2
DID=3
Sample Entries12013 0 0 3
22013 0 0 3
32013 0 0 3
Yo u r  E n t r i e s
Features D-M
Direct Inward Dialing (DID)
92000SWG08   Issue 1-0FEATURES   239 

DID Options Worksheet
AREA TABLES
OptionTrunk
GroupDID Table
Number 1Expected
DigitsTa b l e
No. EntryAddress
No.Digits Rcvd Digits Dialed Name
Program No.1808 1805 1807 1805 1805 1806 1806 1806
Entry Range1-128 1-8 1-8 1-1500 0000-1499 8 dgts max. 24 dgts max. 8 char
max.
Sample Entries2 1111 3 1 0000 218 218 DID
2 1111 3 2 0001 220 220 DID
2 1111 3 3 0002 224 224 DID
Yo u r  E n t r i e s
1        Make one entry for each Night Service mode.
Features D-M
Direct Inward Dialing (DID)
240...