NEC Neax 2400 Imx Wireless System Manual

CHAPTER 4 ND-70290 (E)
Pag e 1 04
Revision 3.0
OFFICE DATA ASSIGNMENT
3. ZT Deletion Procedure
1) MBCSN ( MAKE BUSY CS/ZT for Network Data Memory)
2) ACSDN (Assignment of CS/ZT Data for Network Data Memory)
Delete the ZT Data.
 START
 END 

ND-70290 (E) CHAPTER 4
Page 105
Revision 3.0
OFFICE DATA ASSIGNMENT
2.3 PS OFFICE DATA ASSIGNMENT
Below are explanations about assigning office data to place the PS in operation in the Built-in PCS system.
1. Initial Start-UP of the PS
2. Addition of the PS
1) AFMU
Note:When a PS is assigned by APSD command, logically it occupies a port from module group
(MG) 31 to 26, from larger number of MG to smaller. Using AFMU command, those MGs must
be assigned for Fusion Network.
Since One MG can contain up to...

CHAPTER 4 ND-70290 (E)
Pag e 1 06
Revision 3.0
OFFICE DATA ASSIGNMENT
3. Deletion of the PS data
1) ALGSN (Assignment of Telephone Number Data for Network Data Memory)
Delete the Telephone Number and LENS related.
2) APSD (Assignment of the PS Operation Data for DM)
Using this command, delete the PS data to be cleared such as tenant No., station No., SFC and 
RSC.
Note:If CBCN has never been done in Fusion Network after the last initialization, please do CBCN
before ALGSN.
 END
 START 

ND-70290 (E) CHAPTER 4
Page 107
Revision 3.0
OFFICE DATA ASSIGNMENT
3. ASSIGNMENT OF SERVICE FEATURE DATA
This section describes how to assign the data for the following service features.
 Automatic Announcement-PS Out of Zone/C.F.-PS Incoming Incomplete
 Automatic Announcement-Disconnected PS Out of Zone
 Name Display
 Name Display-CCIS
 Number Sharing
PCS Roaming
 TTC Q. 931a protocol Tie Line with PCS Roaming
 Two-Line Operation
 Voice Mail Indication (VMI)
 ZT Program Download
 Call...

CHAPTER 4 ND-70290 (E)
Pag e 1 08
Revision 3.0
AUTOMATIC ANNOUNCEMENT-PS OUT OF ZONE/C.F.-PS INCOMING INCOMPLETE
AUTOMATIC ANNOUNCEMENT-PS OUT OF ZONE/C.F.-PS INCOMING INCOMPLETE
1. GENERAL DESCRIPTION
When a call cannot terminate to a PS which is Out of Zone or whose power is OFF, the system automatically
answers the call and provides an announcement to notify the calling party that the called PS is Out  of Zone or
if the C.F.-PS Incoming Incomplete is set to a given destination, the aborted call can be...

ND-70290 (E) CHAPTER 4
Page 109
Revision 3.0
AUTOMATIC ANNOUNCEMENT-PS OUT OF ZONE/C.F.-PS INCOMING INCOMPLETE
10. The incoming incomplete call to PS can be transferred to other PSs, stations, Attendant Consoles, Central
Office and TIE lines when the C.F.-INCOMING INCOMPLETE is in service.
11. The timer value of incoming incomplete call is approximately 8 seconds, time duration until the system
recognizes that the PS is Out of Zone from an incoming call attempt to the PS.
Priority is given to the...

CHAPTER 4 ND-70290 (E)
Pag e 1 10
Revision 3.0
AUTOMATIC ANNOUNCEMENT-PS OUT OF ZONE/C.F.-PS INCOMING INCOMPLETE
4. PROGRAMMING
4-1 Automatic Announcement-PS Out of Zone
 Entry Procedure
1) ARTD (Route Class Data)
Assign the Route Class Data for announcement trunk.
RT : Route Number
OSGS (CDN: 1) = 2
ONSG (CDN: 2) = 2
TF (CDN: 5) = 1
TCL (CDN: 6) = 4
L/T (CDN: 7) = 1
ANS (CDN28) = 1
Assign “0” for other parameters.
2) ALRTN (Assignment of Logical RT for Network Data Memory)
LGRT : Logical Route Number...

ND-70290 (E) CHAPTER 4
Page 111
Revision 3.0
AUTOMATIC ANNOUNCEMENT-PS OUT OF ZONE/C.F.-PS INCOMING INCOMPLETE
5) ARRC (Alternative Route Restriction Pattern Data)
Allow the restriction between the external trunk and the announcement trunk.
ICRT : Incoming Route Number
OGRT : Outgoing Route Number (Announcement trunk)
ARI : D (Direct)
RES = 1 (Allowed)
6) AAED (Announcement Equipment Data)
Assign EQP=60 for the AUTOMATIC ANNOUNCEMENT-PS OUT OF ZONE
TN : Tenant Number
EQP = 60 (AUTOMATIC ANNOUNCEMENT-PS...

CHAPTER 4 ND-70290 (E)
Pag e 1 12
Revision 3.0
AUTOMATIC ANNOUNCEMENT-PS OUT OF ZONE/C.F.-PS INCOMING INCOMPLETE
4-2 C.F.-PS Incoming Incomplete
 Entry Procedures
1) ASYD (Assignment for System Data)
Assign whether to use a same access code for Call Forwarding-Busy Line, Call Forwarding-Don’t 
Answer and C.F.-PS Incoming Incomplete, or use separate access codes.
SYS1, INDEX5, bit 0
0=Same
1=Separate
2) ANPD (Numbering Plan Data)
Assign the necessary number of digits needed to determine the service which...

ND-70290 (E) CHAPTER 4
Page 113
Revision 3.0
AUTOMATIC ANNOUNCEMENT-DISCONNECTED PS OUT OF ZONE
AUTOMATIC ANNOUNCEMENT-DISCONNECTED PS OUT OF ZONE
1. GENERAL DESCRIPTION
When a PS user moves Out of Zone (out of the PCS service area) and the call is disconnected, the counterpart
hears the announcement stating the call was disconnected due to the the wireless user going Out of Zone.
2. OPERATING PROCEDURE
No manual operation
3. SERVICE CONDITIONS
1. This service is valid only in a two-party call.
This...