NEC Neax 2400 Imx Wireless System Manual

CHAPTER 3 ND-70290 (E)
Pag e 6 4
Revision 3.0
PA-4CSID (CSINT)
Figure 3-8  Connecting Route Diagram
MDF
PIM
NT1 A
B
CSINTA
B 

ND-70290 (E) CHAPTER 3
Page 65
Revision 3.0
PA-4CSIE (CSINT)
PA-4CSIE (CSINT)  : ZT (Zone Transceiver) Interface
1. General Functions
This circuit card is designed to provide the ISDN S interface to the Zone Transceiver (ZT).
Specifications and functions of this circuit card are shown below.
 A maximum of four ZTs can be accommodated in one 4CSIE circuit card.
 Interface with ZTs is based on the ISDN standard interface, though the multi-point connection of the
ZTs is not available.
 I.430, Q.921...

CHAPTER 3 ND-70290 (E)
Pag e 6 6
Revision 3.0
PA-4CSIE (CSINT)
3. Lamp, Key, Connector and Their Location
The following diagram shows the location of Lamp, Key and Connectors.
Figure 3-10  Lamp, Key and Connectors : PA-4CSIE
OPE
MB
SW10
NOPE
MODE
L3
L2
L1
L0 BL34
BL33
BL32
LYR3
PWR3
BL24
BL23
BL22
LYR2
PWR2
BL14
BL13
BL12
LYR1
PWR1
SYNCBL04
BL03
BL02
LYR0
PWR0
SW12 SW11
MBR 

ND-70290 (E) CHAPTER 3
Page 67
Revision 3.0
PA-4CSIE (CSINT)
4. Lamp Indication
Shown below are the contents of lamp indication on this circuit card.
n=0~3
Note 1:B2 through B4 channels represent channel names of 32k ADPCM.
LAMP NAME COLOR MEANING
OPE Green Remains lit when this card is operating normally.
NOPE Red Remains lit when this card is in make-busy state.
BLn4 Green  Remains lit when B4 channel of the line #n is communicating  
Note
Flashing Flashes while the corresponding circuit is in...

CHAPTER 3 ND-70290 (E)
Pag e 6 8
Revision 3.0
PA-4CSIE (CSINT)
5. Switch Settings
Standard settings of switches on this circuit card are shown in the table below.
SWITCH NAMESWITCH 
NUMBERSWITCH 
SETTINGSTANDARD 
SETTINGMEANING
MB
 (Toggle Switch)
UpCircuit card make-busy set
Down
Circuit card make-busy cancel
MBR
 (Piano-Key Switch)
0ON Line 0 make-busy request
OFF×Line 0 make-busy request cancel
1ON Line 1 make-busy request
OFF×Line 1 make-busy request cancel
2ON Line 2 make-busy request
OFF×Line 2...

ND-70290 (E) CHAPTER 3
Page 69
Revision 3.0
PA-4CSIE (CSINT)
SWITCH NAMESWITCH 
NUMBERSWITCH 
SETTINGSTANDARD 
SETTINGMEANING
SW11 
1PAD on TSW side
2
3ON×Not used
4ON×Not used
5PB Sender Mode (Law/Level) Selection  
Note:µ/A-law can be selected on the TSW side PAD. 
µ-law Standard = High : -7.0 dBm 
Low : -9.0 dBm
A-law Standard =High : -8.0 dBm 
Low : -10.0 dBm 6
7ON×Fixed
8ON×Fixed
(DIP Switch)
ON
12
3456
78SWITCH 1 SWITCH 2 PAD
OFF OFF Not used
ON OFF A-Law
OFF ON µ (PS)-A (TSW) Conversion
ON ON...

CHAPTER 3 ND-70290 (E)
Pag e 7 0
Revision 3.0
PA-4CSIE (CSINT)
Note:
The following diagram shows the PAD control method.
SWITCH NAMESWITCH 
NUMBERSWITCH 
SETTINGSTANDARD 
SETTINGMEANING
SW12
(DIP Switch)
1~8
ON
12
345678
Connection with C.O.  Note 
Connection with a station.  Note 
SWITCH 1 SWITCH 2 SWITCH 3 PAD VALUE
OFF OFF OFF Not used
ON OFF OFF Not used
OFF ON OFF PAD 1=3 dB
ON ON OFF PAD 1=0 dB
OFF OFF ON PAD 1=–3 dB
ON OFF ON PAD 1=–5 dB
(Standard setting)
OFF ON ON PAD 1=–7 dB
ON ON ON PAD 1=–10...

ND-70290 (E) CHAPTER 3
Page 71
Revision 3.0
PA-4CSIE (CSINT)
PA-4CSIE (CSINT) : ZT (Zone Transceiver) Interface
MODULE
NAMESLOTSWITCH 
NAMESWITCH SHAPE REMARKS
PIM MB ON : Make-busy set of circuit 
card 
OFF : Make-busy cancel of 
circuit card
MBR
MODE
SW10
SW11
SW12
ON (MB)
OFF
No. 3
No. 2
No. 1
No. 0OFF
ON
ON
1234
ON
12
3456 78
ON
12
3
456 78 

CHAPTER 3 ND-70290 (E)
Pag e 7 2
Revision 3.0
PA-4CSIE (CSINT)
6. External interface
Below are accommodation of the LT connector leads of this circuit card and connecting route diagram.
a. LT Connector Lead Accommodation when this circuit card is mounted in PIM.
Figure 3-11  LT Connector Leads Accommodation of PIM : PA-4CSIE
26272829303132333435363738394041
1234567891011121314151642434445464748
1718192021222349502425
Accommodated in *1
LT0, 2, 4, 6, 8, 10 Connector
LT Connector Accommodation...

ND-70290 (E) CHAPTER 3
Page 73
Revision 3.0
PA-4CSIE (CSINT)
Figure 3-12  Connecting Route Diagram
PBX
CSINT
TA
TB
RA
RBRA
RB
TA
TB
ZT IN
OUT MDF