NEC Neax 2400 Imx Installation Manual

NDA-24234 CHAPTER 3
Page 271
Revision 3.0
INSTALLATION PROCEDURE
22. UPDATING CONFIGURATION DATA
When configuration data assignment is complete, update configuration data according to the procedure below.
When the RELEASE key is pressed, update is cancelled.
While one of the Configuration Menu is displayed on the LCD, press the ANSWER key.
Configuration data is updated and the DESK CONSOLE is automatically restarted.
Figure 016-23  Updating Configuration Data
NAP-200-016
Sheet 41/41
Installation of the...

CHAPTER 3 NDA-24234
Pag e 27 2
Revision 3.0
INSTALLATION PROCEDURE
This NAP explains the installation of the Maintenance Administration Terminal (MAT) and the System Message
Printer focusing on their cable connections.
1. INSTALLATION OF MAT AND CABLE CONNECTIONS
NAP-200-017
Sheet 1/9
Installation of Maintenance 
Administration Terminal (MAT) and Cable 
Connections
START
Preparation of the MAT Set up the Personal Computer, CRT Display, Printer, 
and so on.
Cable Connection Connect the cables between the...

NDA-24234 CHAPTER 3
Page 273
Revision 3.0
INSTALLATION PROCEDURE
Figure 017-1  Cabling of MAT when Using Ethernet
NAP-200-017
Sheet 2/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
LPR
BASEULANI(PZ-PC19)
10BASET (straight)
HUBMAT
0001 02 03 04 05 06 07 08 09 00
01 02 03 0411 12 13 14 15 16 17 18 19 10 21 22 2320
PH-IO24 (IOC) PH-PC40 (EMA)
10BASET (straight) 

CHAPTER 3 NDA-24234
Pag e 27 4
Revision 3.0
INSTALLATION PROCEDURE
Figure 017-2  Cable Connection Diagram for the MAT
NAP-200-017
Sheet 3/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
Slot No.s 03  02MISC4B MISC4A

To connect the PBX and the MAT, the following three 
kinds of cables are required. The “RS-232C Cable should 
be provided by the customer.

The location of the MISC connector to which the “68PH S 2PORTS CA-A” cable 
is connected varies depending on...

NDA-24234 CHAPTER 3
Page 275
Revision 3.0
INSTALLATION PROCEDURE
2. INSTALLATION OF MAT AND CABLE CONNECTION BY USING MODEM
Note:
When the distance between the PBX and the MAT (Maintenance Administration Terminal) exceeds 15
meters (50 feet), connect them with Modems as shown in Figure 017-3.
NAP-200-017
Sheet 4/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
START
Preparation of the MAT Set up the Personal Computer, CRT Display, Printer, 
and so on.
Preparation of...

CHAPTER 3 NDA-24234
Pag e 27 6
Revision 3.0
INSTALLATION PROCEDURE
Figure 017-3  Cabling of MAT Using Modems
NAP-200-017
Sheet 5/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
: Champ Connector (Male)
: Champ Connector (Female)
: 25-Pin Cannon Connector (Male)
: 25-Pin Cannon Connector (Female)
: 68-Pin Connector (Female) — Legend —MATPBX
Installation Cable
(less than 10 m / 33 feet)
RS-232C Cable
(customer provided)
RS-232C CA-(3)
MODEMANALOG LINE
(2W/4W)
MODEMTo...

NDA-24234 CHAPTER 3
Page 277
Revision 3.0
INSTALLATION PROCEDURE
3. INSTALLATION OF SYSTEM MESSAGE PRINTER AND CABLE CONNECTIONS
Figure 017-4  Connection of System Message Printer
NAP-200-017
Sheet 6/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
START
Installing printer Install printer according to its instructions.
Cable connection Connect the cable between the PBX and the dedicated 
System Message Printer which is equipped with a 
parallel port referring to...

CHAPTER 3 NDA-24234
Pag e 27 8
Revision 3.0
INSTALLATION PROCEDURE
Figure 017-5  Detail of RS-232C CA-(0)
NAP-200-017
Sheet 7/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
1500mm (4 feet 1 inch)
TYP
DTE
Champ Connector
(Female)25-Pin Cannon Connector
(Male)
Connect to PRT Connect to
68PH S 2PORTS CA-A
TYPE-1-SD
TYPE-2-RD
TYPE-3-RS
TYPE-4-CS
TYPE-5-DR
TYPE-6-SG
TYPE-7-CD
TYPE-8-ER
TYPE-9-PB
TYPE-10-SP0
TYPE-12-SP2
TYPE-11-SP1DTE-3-RD
TYPE-2-SD
TYPE-8-CD
TYPE...

NDA-24234 CHAPTER 3
Page 279
Revision 3.0
INSTALLATION PROCEDURE
Figure 017-6  Detail of RS-232C CA-(1)
NAP-200-017
Sheet 8/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
1500mm (4 feet 1 inch)
TYP
Champ Connector
(Female)
25-Pin Cannon Connector
(Female)
Connect to
RS-232C Cable Connect to
68PH S 2PORTS CA-A
TYPE-1-SD
TYPE-2-RD
TYPE-3-RS
TYPE-4-CS
TYPE-5-DR
TYPE-6-SG
TYPE-7-CD
TYPE-8-ER
TYPE-9-PB
TYPE-10-SP0
TYPE-12-SP2
TYPE-11-SP1DTE-3-RD
TYPE-2-SD
TYPE-8-CD...

CHAPTER 3 NDA-24234
Pag e 28 0
Revision 3.0
INSTALLATION PROCEDURE
Figure 017-7  Detail of RS-232C CA-(3)
NAP-200-017
Sheet 9/9
Installation of the Maintenance 
Administration Terminal (MAT) and Cable 
Connections
1500mm (4 feet 1 inch)
TYP
Champ Connector
(Female)
25-Pin Cannon Connector
(Male)
Connect to MODEM Connect to
68PH S 2PORTS CA-A
TYP-1-SD
TYP-2-RD
TYP-3-RS
TYP-4-CS
TYP-5-DR
TYP-6-SG
TYP-7-CD
TYP-8-ER
TYP-10-SP0
TYP-11-SP2
TYP-12-SP1DCE-2-SD
DCE-3-RD
DCE-4-RS
DCE-5-CS
DCE-6-DR
DCE-7-SG...