Home > NEC > Communications System > NEC Neax 2400 Imx Fusion Network System Manual

NEC Neax 2400 Imx Fusion Network System Manual

Here you can view all the pages of manual NEC Neax 2400 Imx Fusion Network System Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 141

CHAPTER 5 ND-70185 (E)
Page 126
Revision 3.0
DATA PROGRAMMING
Office Data Sheets
FUSION POINT CODE 
(FPC)
1-253FCCH USE OR
NOT USE (FCCH)
0/1
12345678
CONNECTION ROUTE
(C_RT)
1-1023
FCCH NUMBER/FUSION
POINT CODE NUMBER
(FCHN/FPCN) 1-255/1-253 

Page 142

ND-70185 (E) CHAPTER 5
Page 127
Revision 3.0
DATA PROGRAMMING
Office Data Sheets
8.13 Data Sheet for ACAN
FUSION POINT CODE 
(FPC)
1-253FUSION CIC NUMBER 
(FCIC)
1-4095CONNECTION EQUIPMENT 
NUMBER 
(C_LENS)REMARKS 

Page 143

CHAPTER 5 ND-70185 (E)
Page 128
Revision 3.0
DATA PROGRAMMING
Office Data Sheets
8.14 Data Sheet for AFRT
FCCH NUMBER 
(FCHN)
1-255CONNECTION ROUTE (C_RT) 1-1023
12345678 

Page 144

ND-70185 (E) CHAPTER 5
Page 129
Revision 3.0
DATA PROGRAMMING
Office Data Sheets
8.15 Data Sheet for AETH
DESTINATION 
FPC
(FPC)
1-253GATEWAY
USING FLAG
(USE_GATE)
0/1FCCH
NUMBER
(FCHN)
1-255CONNECTION 
ROUTE
(C_RT)
1-1023DESTINATION
IP ADDRESS
(DST_IP)NEXT IP
ADDRESS
(NEXT_IP) 

Page 145

CHAPTER 5 ND-70185 (E)
Page 130
Revision 3.0
DATA PROGRAMMING
Office Data Sheets
8.16 Data Sheet for AGIP
LINE EQUIPMENT
NUMBER OF FCCH
(FCHEN)FGH IP
ADDRESS
(FGH_IP)IP ADDRESS
FOR DEFAULT
GATEWAY
(DG_IP)FRAME
TYPE OF
ARP
(ARP)
1/2VO I C E  
CHANNEL
CONTROL
TYPE
(CONTTYP)
0/1QSIG-PRIME
LINK NUMBER
(LINK_NUM)
0-32CLIENT/
SERVER
CONNECTION
MAX. NUMBER
(CSLINK_NUM)
0-15 MG U G LV 

Page 146

ND-70185 (E) CHAPTER 5
Page 131
Revision 3.0
DATA PROGRAMMING
Office Data Sheets
8.17 Data Sheet for AFIP
FCH
NUMBER
(FCHN)LINE EQUIPMENT
NUMBER OF FGH
(FGHEN)LINE EQUIPMENT
NUMBER OF
QSIG-PRIME Bch
(LENS)ROUTER ACCESS NUMBER
(RT_ACC)
Max. 16 digits
MG U G LV MG U G LV 

Page 147

CHAPTER 5 ND-70185 (E)
Page 132
Revision 3.0
DATA PROGRAMMING
Office Data Sheets
8.18 Data Sheet for AFRFL
TN FPC (1-253)AC C
MAX. 24 digits 

Page 148

ND-70185 (E) CHAPTER 6
Page 133
Revision 3.0
CHAPTER 6 POST INSTALLATION TEST
This chapter covers how to perform installation tests focusing on the Fusion Call Control Signal (denoted in the
remainder of this manual as FCCS) connections, after hardware installation and data assignment. This chapter
describes the following tests:
 How to Check Fusion Link by LEDs on an FCH Card
 Repair Procedure When LED Indicates Abnormality
 FCCS Network Connection Test
 FCCS Alternate Routing Test
 Fusion and...

Page 149

CHAPTER 6 ND-70185 (E)
Page 134
Revision 3.0
POST INSTALLATION TEST
Repair Procedure When LED Indicates Abnormality
1.1 How to check LYR LED
1. Confirm the LYR LED lights green on the front edge of the FCH (PA-FCHA) circuit card. (See “LED
Indication (A)” in Figure 6-2.) When the LED lights green, the fusion link is established.
2. Make sure that any alarm LED is not ON (red/yellow). (See LED Indication (B) in Figure 6-2.)
When all alarm LEDs are OFF, the DTI (PA-24DTR) card is in normal operation.
If...

Page 150

ND-70185 (E) CHAPTER 6
Page 135
Revision 3.0
POST INSTALLATION TEST
Repair Procedure When LED Indicates Abnormality
 FCH (PA-FCHA) switch setting
Make sure that the following keys are set properly:
 Dch TS designation (0ch - 23ch: SW11, SW12, SW13)
 Data Link Signal Logic (positive/negative: SW14-1)
 Fusion Data Link Speed (48/56/64 kbps: SW14-2, 3)
 LAPD Signal Link (user/network: SW14-4)
 24DTI (PA-24DTR) switch setting
Make sure that the keys are properly set on the card. See the NEAX2400 IMX...
Start reading NEC Neax 2400 Imx Fusion Network System Manual

Related Manuals for NEC Neax 2400 Imx Fusion Network System Manual

All NEC manuals