NEC Neax 2000 Ivs2 Maintenance Manual

CHAPTER 2  TROUBLESHOOTING
Fault Detection
NEAX2000 IVS2 Maintenance Manual    
ND-70926 (E), Issue 1.0   Page 63
Application
Processor CardsPN-SC03-A
 (CSH)RUN Green 120 IPM Flash Steady ON or OFF
DOPE0Green Steady ON OFF
DOPE1Green Steady ON OFF
DOPE2Green Steady ON OFF
DOPE3Green Steady ON OFF
DOPE4Green Steady ON OFF
DOPE5Green Steady ON OFF
DOPE6Green Steady ON OFF
DOPE7Green Steady ON OFF
Line /Trunk Cards PN-2COTD
(COT)
[For Australia/
Others]LF0 Red OFF Steady ON
LF1 Red OFF Steady ON
PN-4COTE...

 NEAX2000 IVS2 Maintenance ManualPage 64  ND-70926 (E), Issue 1.0
CHAPTER 2  TROUBLESHOOTING
Fault Detection
Line/Trunk Cards PN-8COTT
(COT)
[For Australia]LF0 Red OFF Steady ON
LF1 Red OFF Steady ON
LF2 Red OFF Steady ON
LF3 Red OFF Steady ON
LF4 Red OFF Steady ON
LF5 Red OFF Steady ON
LF6 Red OFF Steady ON
LF7 Red OFF Steady ON
PN-2CSIA
(CSI)
[For North
America/
Latin America]OPE Green Steady ON OFF
B12 Red ON/OFF 60 IPM Flash
B11 Red ON/OFF 60 IPM Flash
B10 Red ON/OFF 60 IPM Flash
B02 Red ON/OFF 60...

CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
NEAX2000 IVS2 Maintenance Manual    
ND-70926 (E), Issue 1.0   Page 65
FAULT DIAGNOSIS AND TROUBLESHOOTING
Display on MAT/CAT
When the MJ/MN alarm is on, you can diagnose the contents of the fault by the Fault Message
and the Station Line Status Display features, which are displayed on the MAT or the CAT, and
restore the fault.
FAULT MESSAGE
Item (1) shows the display format for the Fault Message feature, and item (2) shows the fault di-...

 NEAX2000 IVS2 Maintenance ManualPage 66  ND-70926 (E), Issue 1.0
CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
(2) Fault Diagnosis and Troubleshooting
Table 2-3 shows the fault information and the remedial action on each fault kind. Table 2-4
shows the fault restoration information on each fault restoration kind. Diagnose contents of
the fault and perform the remedial action listed in Table 2-3.
If the corresponding fault restoration kind number shown in Table 2-4 also displays, no...

CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
NEAX2000 IVS2 Maintenance Manual    
ND-70926 (E), Issue 1.0   Page 67
Table 2-3  Remedial Action on Each Fault Kind 
FAU LT  
KIND
NUMBERFAU LT  
CONTENTFAULT INFORMATION REMEDIAL ACTION
01 System initialized 3:  XX XX XX XX
       
4: XX
 XX XX XX
 
Kind of System Initialization 
related information
1: Program address 
information
2: Receive command 
information
F:  No system initialization 
related information
Initial Kind (See below.)
The...

 NEAX2000 IVS2 Maintenance ManualPage 68  ND-70926 (E), Issue 1.0
CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
04 MP-FP/AP commu-
nication failure3: XX XX XX XX
     
Communication Failure Kind
00: Overflow of data sending 
buffer to the FP/AP
01: Invalid data received from 
FP/AP
Number of communication 
failures 
FP/AP Number
00-03: FP No. 0-3
04-15: AP No. 4-15, 20-31Replace the corre-
sponding FP or AP 
card indicated in the 
FP/AP Number.
08 FP/AP card down 3:  XX
 XX XX XX
FP/AP...

CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
NEAX2000 IVS2 Maintenance Manual    
ND-70926 (E), Issue 1.0   Page 69
12 CS/ZT Fault 3. XX XX XXXX
       
Fault Kind (See below.)
AP No. of CS/ZT fault occur-
rence 04-15, 20-31
CS/ZT Interface No. of CS/ZT  
fault occurrence 000-255
Fault Kind 00: Fault notice from 
CS/ZTNo specific action is 
required.
Fault Kind 01: CS/ZT initial failure
Make the CS/ZT 
Make busy or 
Make idle condition 
by CME5 Y=3.
Tu r n  O N   OFF the 
CS/ZT power...

 NEAX2000 IVS2 Maintenance ManualPage 70  ND-70926 (E), Issue 1.0
CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
12 CS/ZT  Fault Fault  Kind  05: SYS-ID upload             
failureCheck the LEN No. 
of the CS/ZT with 
SYS-ID is correct 
by CMAE Y=00>02
Make the CS/ZT 
Make busy or 
Make idle condition 
by CME5 Y=3.
Tu r n  O N   OFF the 
CS/ZT power 
switch.
Fault Kind 06: SYS-ID download 
failureWhen input the 
SYS-ID from MAT, 
check if the number 
is correct.
Check the CS/ZT 
is CS/ZT...

CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
NEAX2000 IVS2 Maintenance Manual    
ND-70926 (E), Issue 1.0   Page 71
12 CS/ZT Fault Fault Kind 07: CS/ZT make busy  
failureMake the CS/ZT Make 
busy or Make idle con-
dition by CME5 Y=3.
Fault Kind 08: CS/ZT data load 
failureMake the CS/ZT 
Make busy or 
Make idle condition 
by CME5 Y=3.
Tu r n  O N   OFF the 
CS/ZT power 
switch.
Fault Kind 09: B channel make 
busy failureMake the CS/ZT 
Make busy or 
Make idle condition 
by CME5 Y=3....

 NEAX2000 IVS2 Maintenance ManualPage 72  ND-70926 (E), Issue 1.0
CHAPTER 2  TROUBLESHOOTING
Fault Diagnosis and Troubleshooting
12 CS/ZT Fault Fault Kind 0B: LCCH sending 
position failureMake the CS/ZT 
Make busy or 
Make idle condition 
by CME5 Y=3.
Tu r n  O N   OFF the 
CS/ZT power 
switch.
Fault Kind 0C: Carrier selection 
failure
[North America/
Latin America 
Only]No specific action is 
required.
Fault Kind 0D: CS/ZT expansion 
data read failureMake the CS/ZT 
Make busy or 
Make idle condition...