Mitel Sx 200 Ml Pabx Lightware 16 Instructions Guide

Appendix A - Maintenance Terminal Error Messages 
Table A-l Maintenance Terminal Error Messages (continued) 
Message Meaning 
The hourvalue “XX” is out of range. Used in traffic measurement for invalid values in the SET START 
Start time not set. TIME command. 
The link “X” cannot be tested. The user has tried to test or enable diagnostics on a pcm link 
which is not used as a telephony link. Links 0, 1, 14 and 15 are 
not available for testing. 
The minor threshold may not be Assign a higher value to...

RS-232 Maintenance Terminal 
Table A-l Maintenance Terminal Error Messages (continued) 
, 
Message Meaning 
Warning. Invalid qualifierfound. %s The qualifier specified during set time will be ignored. 
will be ignored. 
Warning, Sub-circuit field ignored Sub-circuit parameter was entered, but was not required. For 
for this card. information only. 
Wrong bay type for specified An incompatible bay number is given for the device selected 
device. (i.e., Bay 0 is selected for receivers). 
Page 4 of 4 
A-4...

Appendix A - Maintenance Terminal Error Messages 
March 1997 
issue 1 Revision 0 A-5  

RS-232 Maintenance Terminal 
A-6 Issue 1 Revision 0 March 1997  

SX-200@ ML PABX 
General 
Maintenance 
Information 
rM, @I - Trademark of Mite1 Corporation. 
0 Copyright 1997, Mite1 Corporation. 
All rights reserved 
Printed in Canada. 
e MITEL@  

General Maintenance Information 
NOTICE 
The information contained in this document is believed to be accurate in all re- 
spects but is not warranted by Mite1 Corporation (MlTEL@). The information is 
subject to change without notice and should not be construed in any way as a 
commitment by Mite1 or any of its affiliates or subsidiaries. Mite1 and its affiliates 
and subsidiaries assume no responsibility for any errors or omissions in this doc- 
ument. Revisions of this document or new editions of it...

I. General...............................................................l- 1 
Introduction ........................................................... ..l- 1 
Fieasonforlssue ....................................................... ..l- 1 
Disclaimer ............................................................ ..l- 1 
2. MaintenanceTools....................................................2- 1 
The Maintenance Terminal ................................................ .2-l 
Maintenance Port...

General Maintenance Information 
Specifying Equipment ...................................... ............... 6-7 
Normal Extension Calls .................................... ............... 6-7 
7. Maintenance Controls and Indicators ................. 
General 
................................................ 
Main Control Card II ....................................... 
Bay Control Card ......................................... 
Peripheral Circuit Cards .................................... 
Attendant...

Table of Contents 
Table 6-2 
Table 6-3 
Table 7-l 
Table 7-2 
Table 7-3 
Table 7-4 
Table A-l 
Table B-l 
Table C-l 
March 1997 Test Line Status Indicator Codes .................................. 6-6 
Test Line Status Tones .......................................... 6-7 
Main Control Card II Codes ....................................... 7-3 
Bay Control Card Status LEDs .................................... 7-4 
Attendant Console Maintenance Led Indicators ....................... 7-6 
Attendant Console...

General Maintenance Information 
vi Issue 1 Revision 0 March 1997