Mitel Sx 200 Ml Pabx Lightware 16 Instructions Guide

Appendix B 
Updating the Operating 
System Software 
General 
B.1 To update the operating system software, refer to Table B-i, Operating System Soft- 
ware Update Procedure From The Terminal, and the /M&I//~~o~ /~Vor~?~aHon Practice. 
S Table B-1 Operating System Software Update Procedure From The Terminal 
ltep Action 
1. Back up the existing database to the PC before proceeding. 
2. Ensure that the power to the system is OFF. 
3. Ensure that the System ID module is installed. Refer to the /ns&i//ef~o~~...

General Maintenance Information 
B-2 Issue 1 
Revision 0 March 1997  

Appendix C 
Username Command 
Privileges 
Table C-l lists the command privileges of all of the valid username levels: 
Table C-1 Username Command Privileges 
COMMAND Installer 
DATABASE RESTORE X 
DATABASE BACKUP X 
Maintl Maint2 Supervisor 
Attendant 
LOGS-BACKUP 
SET TIME 
SET DATE X 
X 
X X X X 
X X X X X 
SET PASSWORD X X X X X 
SET SPEED X X 
SHOW DATE X X X X X 
SHOW TIME X X X X X 
SHOW DEVICE X X X X X 
SHOW IDENTITY X X X X X 
MONITOR SMDR X X X X 
MONITOR DIAG X X X X 
MONITOR LOGS 
I lx I x I...

General Maintenance information 
Table C-l Username Command Privileges (continued) 
SHOW ALARMS X 
X 
SHOW CONFIG X X X 
SHOW STATUS X X X 
SHOW CHANNEL-MAP X X X 
Page 2 of 2 
c-2 Issue 1 Revision 0 March 1997  

Appendix C - Username Command Privileges 
March 1997 Issue 1 Revision 0 c-3  

General Maintenance Information 
C-4 
Issue 1 Revisior 
March 1997  

SX-200@ ML PABX 
Field- 
Replaceable 
Units 
TM, @ - Trademark of Mite1 Corporation 
0 Copyright 1997, Mite1 Corporation. 
All rights reserved 
Printed in Canada. 
@ 
MlTEL@  

Field-Replaceable Units 
NOTICE 
The information contained in this document is believed to be accurate in all re- 
spects but is not warranted by Mite1 Corporation (MlTEL@). The information is 
subject to change without notice and should not be construed in any way as a 
commitment by Mite1 or any of its affiliates or subsidiaries. Mite1 and its affiliates 
and subsidiaries assume no responsibility for any errors or omissions in this doc- 
ument. Revisions of this document or new editions of it may be...

Field-Replaceable Units 
IMPORTANT SAFETY INSTRUCTIONS 
These instructions are intended to be used as a general guide to provide 
basic installation information which is necessary for the proper and safe 
functioning of this equipment. 
WARNING: 
FAILURE TO FOLLOW ALL INSTRUCTIONS MAY RESULT IN 
IMPROPER EQUIPMENT OPERATION AND/OR THE RISK OF 
ELECTRIC SHOCK. 
General 
l Read and understand all instructions. Keep these instructions with the 
equipment. 
l Do not attempt to install or service this...

Field-Replaceable Units 
l Never install telephone jacks in wet locations unless the jack is 
specifically designed for wet locations. 
l Never touch uninsulated telephone wires or terminals unless the 
telephone line has been disconnected at the network interface. 
l Use caution when installing or modifying telephone lines. 
Use of Notices and Symbols 
The following information provides an explanation of the notices and 
symbols which appear on the product and in the practices for this product. 
Danger...