Mitel SX-200 DIGITAL Pabx General Description Manual

General Description 
ATTENDANT FEATURE LIST (CONT’D) 
Generic Generic 
Feature 
I I 1000 1001 
Timed Recall 
Training Jack 
I Tone Sinnalinn 
Trunk Busy-out 
Trunk Group Busy -. ’ 
Trunk-to-Trur - Display 
hk Connect v 
! r/  ,/ I/ 
, 
1 Wake-up, Automatic with Printout 
I I t’ 
Page 7-4  

General Description 
EXTENSION FEATURE LIST 
Page 7-5  

General Description 
8. MAINTENANCE 
General 
8.01 This Part briefly describes the maintenance diagnostics for the 
SX-200’ DIGITAL PABX. These diagnostics test the operation of 
the system hardware. The Main Control system has the responsibility 
of controlling and scheduling the diagnostics. 
8.02 Upon power-up or reset conditions, the diagnostics software (if 
enabled) has temporary control of the entire system. Once the 
system has been verified and the PABX is operational, the diagnostics 
run as...

General Description 
8.08 The Sackground diagnostic routines also consist of the com- 
plete routines which are run during system operation. When 
enabled they are executed as low priority background routines during 
system operation. 
Page 8-2/2  

MITEL STANDARD PRACTICE SECTION MITL9108-093-105-NA 
Issue 2, September 1985 
SX-200” DIGITAL 
PRWATE AUTOMATIC BRANCH EXCHANGE (PABX) 
FEATURES DESCRIPTION 
Copyright of MITEL Corporation 1986 
TM - Trademark of MITEL Corporation 
@Registered Trademark of MITEL Corporation  

NOTICE 
The information contained in this document is believed to be accurate in all respects but is 
not warranted by Mite! Corporation (MITEL). The information is subject to change without 
notice and should not be construed in any way as a commitment by Mite1 or any of its 
affiliates or subsidiaries. Miter and its affiliates and subsidiaries assume no responsibility 
for any errors or omissions in this document. Revisions of this document or new editions of 
it may be issued to incorporate such...

Features Description 
CONTENTS 
PAGE 
1. INTRODUCTION . . . . . . . m . . . 0 . 0 . . 0 . B . . m . . . . . e . 0 . . . . . l-l 
2. TYPES OF FEATURES 
............................... 2-l 
General ......................................... 2-1 
3. ATTENDANT FEATURES 
............................. 3-l 
Attendant Abbreviated Dial Programming, Access ...... 3-2 
Attendant Alarm Readout 
......................... 3-3 
Attendant Bell-Off 
............................... 3-4 
Attendant Busy Override...

Features Description 
CONTENTS (CONT’D) PAGE 
Attendant Softkey Functions . . . . . . . . . . . . . . . . n . . B . . 3-47 
Attendant Source Key .-.- 0 .......D.........O.e.. 3-48 
Attendant-Timed Recall . m . . e e m . . . s . . B . . m . D . . . . m . D 3-49 
Attendant Tone Signaling 0 s e . . s . . . . . . g . . n m . . . . m . . 3-50 
Attendant Training Jacks s . = . s D . . . . . . m . . . . . . . B a s 0 3-51 
Attendant Trunk Busy-Out Enable . Q . . a s . D a . . . . . D s . 3-52 
Attendant Trunk...